Diagnosis of systemic causes of uveitis; a matter of ophthalmologist and internist

OBJECTIVE: To assess how often the aetiology is established in patients with uveitis, what systemic disease are found and what is the contribution of the internist to the diagnostic process. DESIGN: Retrospective study. SETTING: University Hospital Leiden, the Netherlands. METHOD: From January 1987 to April 1992, 342 patients presented with uveitis. All patients underwent a standard ophthalmological examination. Referral to an internist and individualised laboratory screening followed in patients with recurrent, chronic, bilateral or panuveitis. Recorded were: ophthalmological data, results of laboratory screening, results of analysis by the internist, final diagnosis and presence of systemic disease. RESULTS: 149 (44%) patients were examined by the internist, 18 (5.2%) were seen by another specialist. In 169 (49%) patients a specific diagnosis was made. 74 (22%) had a systemic disease, 74 a primary ocular disease. In 28 (8%) a systemic disease was presumed (5% were HLA-B27 positive, 3% had abnormal laboratory results); 5 (1%) patients had endophthalmitis as a complication of a septic process. CONCLUSION: In approximately 1/3 of the patients with uveitis a systemic disease was found. Examination by the internist tailored to the individual patient is essential in the evaluation of uveitis patients.     

Behavior of a vibrating wire near the liquid3He-vacuum interface and in a saturated3He-4He mixture

In this paper we describe the effect of the vicinity of a liquid³He-vacuum interface on the behavior of a vibrating wire viscometer. It was found that in the fluid near the liquid interface the quality factor is lower than in the bulk liquid. We further report on the observation of a doubling of the resonance peak of the wire in a saturated³He-⁴He mixture. The frequencies and amplitudes of the two peaks strongly depend on the distance between the phase boundary and the vibrating wire; the temperature and the velocity of the phase boundary have no significant influence on the peak frequencies. The observed peak doubling is attributed to the coupling of the vibrating wire with a standing second-sound wave in the dilute phase where the volume of the dilute phase can be regarded as a resonating cavity for second sound.     

A novel cyclic process using CaSO<Subscript>4</Subscript>/CaS pellets for converting sulfur dioxide to elemental sulfur without generating secondary pollutants: Part I. Feasibility and kinetics of the reduction of sulfur dioxide with calcium-sulfide pellets

Certain new sulfide-smelting processes and coal-gasification processes generate high-strength sulfur dioxide streams, for which a new process for converting sulfur dioxide to elemental sulfur needs to be developed because no process exists that is generally and economically applicable to the treatment of such streams. A thermodynamic and experimental investigation to develop a new process for converting sulfur dioxide to elemental sulfur by a cyclic process involving calcium sulfide and calcium sulfate without generating secondary pollutants was carried out. In this process, the starting raw material, calcium sulfate, is reduced by a suitable reducing agent, such as hydrogen, to produce calcium sulfide, which is used to reduce sulfur dioxide to elemental sulfur vapor and calcium sulfate. The latter is, in turn, reduced to regenerate calcium sulfide. In this Part I, detailed experimental results are presented on the kinetics of the reaction between sulfur dioxide and calcium-sulfide pellets, which produces elemental sulfur and calcium sulfate. The experiments were carried out at temperatures between 1023 and 1088 K and sulfur-dioxide partial pressures between 9 and 60 kPa by the use of a thermogravimetric analysis (TGA) technique. The rate of this reaction was demonstrated by the conversion of 40 pct calcium-sulfide pellets obtained from the hydrogen reduction of fresh calcium sulfate in 10 minutes at 1073 K under a sulfur-dioxide partial pressure of 43 kPa. The reactivity decreased somewhat during the first three cycles but remained largely unchanged thereafter up to the tenth cycle. This characteristic of the pellets is important because the solids must be reusable for repeated cycles to avoid generating secondary pollutants. A pore-blocking model was found to fit the reaction rate. The reaction is first order with respect to sulfur-dioxide partial pressure and has an activation energy of 101 to 134 kJ/mol (24 to 32 kcal/mol) for calcium-sulfide pellets reacted and regenerated several different times. Sulfur dioxide-containing streams from certain sources, such as the regenerator off-gas from an integrated-gasification, combined-cycle, desulfurization unit and new sulfide-smelting plants, contain much higher partial pressures of SO₂. In these cases, the rate of the first reaction is expected to be proportionally higher than in the test conditions reported in this article. The reduction kinetics of calcium-sulfate pellets with hydrogen gas is reported in the accompanying Part II.     

TPS分散型控制系统在骤冷风空调装置中的应用

主要介绍了Honeywell公司TPS系统在直纺涤纶长丝用骤冷风空调装置中的应用。重点说明了该系统的硬件配置和一些复杂控制回路的实施和组态。     

Microbiological denitrification of red beet juice

The purpose of study was the determination of optimal conditions for red beet juice denitrification by Paracoccus denitrificans bacteria as well as the evaluation of the usefulness of microbiologically treated juice for the production of a natural colouring preparation for foods. Total reduction of nitrates was found during bacterial culturing at 25 and 30 °C, at an initial pH of 7.0-8.0 and juice osmotic pressure of 900-1100 mOsm/kg. Microbiological denitrification procedure affected colour, taste and aroma of the juice. However, the use of juice as food colouring and component was made feasible by acidification and partial evaporation of water together with volatile substances.     

Suspension force and mechanism of debris flows

The paper discusses the postulated suspension force, by which it is possible to explain some enigmatic phenomena observed in different types of mass movements. This force is generated in thick suspensions as a result of friction between sinking solid particles and static water. The suspension force is related to the seepage force but they have opposite directions. Both forces form flow networks. Having explained the suspension force, the paper describes how this influences the movement of material, particularly in debris flows. Enigmatic features and the mechanism of debris flows and lahars are explained by virtue of the suspension force. Electronic Publication     

Scheduling railway traffic at a construction site

We consider the problem of rescheduling trains in the case where one track of a railway section consisting of two tracks in opposing directions is closed due to construction activities. After presenting an appropriate model for this situation we derive a polynomial algorithm for the subproblem of finding an optimal schedule with minimal latenesss if the subsequences of trains for both directions outside the construction site are fixed. Based on this algorithm we propose a local search procedure for the general problem of finding good schedules and report test results for some real world instances. Received: December 8, 1999 / Accepted: May 2, 2001