Lipase production in two-step fed-batch culture of organic solvent-tolerant Pseudomonas aeruginosa LST-03

Efficient lipase production by two-step fed-batch culture of an organic solvent-tolerant bacterium, Pseudomonas aeruginosa LST-03, was investigated. When FB synthetic medium was used in flask culture, no lipase activity was detected, whereas lipase was produced at 2.3 I.U./ml in C2 complex medium. However, lipase production was induced in FB medium when a fatty acid was added to the culture broth in the stationary phase. Among fatty acids tested, long chain saturated fatty acids, such as C18 (stearic acid) and C20 (arachidic acid), were found to function as effective inducers for the production of lipase, giving an activity level almost the same as that obtained in C2 medium in flask culture. Two-step lipase production, comprised of a growth phase in fed-batch mode and a production phase in which lipase was induced by the addition of 5% (v/v) stearic acid, was carried out in a jar-fermentor. In the growth phase, the maximum cell concentration at 16 h was only 20 in terms of the optical density at 660 nm (OD660), and a low level of lipase production (8 I.U./ml) was obtained after 167 h. This was considered to be due to the exhaustion of several medium components brought about by the use of an unsuitable medium or feeding solution. After analyzing the contents of the compounds in the culture broth by inductively coupled plasma spectrometry for metal ions and HPLC for anions, a modified FB medium was designed. When this modified FB medium was used in two-step fed-batch culture, the maximum cell concentration reached an OD660 of 55 (30.2 g-dry cells/l) at 16.5 h, and lipase was produced at 96 I.U./ml after 35 h, which is approximately 40 times higher than the production level obtained in flask culture using C2 medium.     

Radical-induced degradation mechanism of perfluorinated polymer electrolyte membrane

The degradation mechanism induced by radicals was investigated for Nafion^®-117 by solution analysis. Nafion^® was exposed independently to three kinds of radicals, OH, H and O₂⁻ which were produced separately by γ-irradiation. Based on the eluted elements, the scission site in the membrane was analyzed. The results showed that the scission site was classified into two and these locations were closely relating to oxidative and reductive reactions. The decreasing rate of proton conductivity was more significant under the influence of reductive radicals. The progression of the unzipping reaction of main chain was suggested to be initiated by the production of tertiary carbon radical by reductive radicals such as H and O₂⁻ with the aid of OH. The structural degradation such as collapse of cluster and the cluster decomposition as well as the performance degradation was found to be initiated by such reductive radicals.     

Prediction of peptide binding to major histocompatibility complex class II molecules through use of boosted fuzzy classifier with SWEEP operator method

To treat autoimmune diseases, it is important to identify which peptides bind to major histocompatibility complex (MHC) class II molecules (HLA-DRs). Predicting the peptides that bind to MHC class II molecules can effectively reduce the number of experiments required for identifying helper T cell epitopes. In our previous study, we applied fuzzy neural networks (FNNs) to solve this problem. However, an FNN requires a long calculation time and a large number of peptides; this means performing several experiments. In this study, we applied a boosted fuzzy classifier with the SWEEP operator method (BFCS) to solve this problem. For comparison, two other conventional modeling methods, namely, support vector machine and FNN combined with the SWEEP operator method (FNN-SWEEP) instead of using solely an FNN, were employed. Compared with FNN, FNN-SWEEP is extremely fast and has an almost identical prediction accuracy. The model constructed by BFCS showed an accuracy approximately 5%-10% higher than that constructed by FNN-SWEEP. In addition, BFCS was 30,000-120,000 times faster than FNN-SWEEP. This result suggests that BFCS has the potential to function as a new method of predicting peptides that bind to various protein receptors.     

A model of stage of change to recommend colonoscopy among urban primary care physicians.

Theory is little used in the prediction of physician cancer screening stage of change. Structural equation modeling was used to evaluate the theoretical predictors of stage of change to recommend colonoscopy among 235 urban physicians. Constructs from the theory of planned behavior, social-cognitive theory, and the transtheoretical model were systematically tested. As predicted, contextual factors, such as the physicians' ages, their race-ethnicities, patient race-ethnicity, and office-related barriers to preventive care were associated with stage of change through self-efficacy, normative beliefs, and negative behavioral beliefs. The findings demonstrate the relevance of these models to studying the behavior of physicians and support the development of interventions that are tailored to normative beliefs and specific physician cognitions for colonoscopy recommendation. (PsycINFO Database Record (c) 2010 APA, all rights reserved)     

WTRLGD—A computer program for the transient analysis of waterlogged fuel rods under the RIA condition

A computer code WTRLGD has been developed to describe the transient internal pressure of a waterlogged fuel rod during power burst and also to predict the possibility of the rod failure in the mode of cladding rupture. The code predicts transient thermal behavior of the fuel rod on the basis of an assumption of axisymmetry, and thermal-hydraulic transients of the internal water on the basis of a homogeneous volume-junction model modified so as to involve the cladding deformation. Calculated transients of the rod pressure are in fairly good agreement with those measured in the NSRR experiments, simulating the fuel rod behavior under an RIA condition. The comparison between calculation and experiment verifies that the code is an effective tool for the prediction of the failure of a waterlogged fuel rod.     

International intercomparison of laser power at 633 nm

An international intercomparison of laser power at 633 nm has recently been completed. This comparison was initiated at a meeting of the High Frequency Working Group of CCE/CIPM in October, 1972.     

Updating geomorphic features of watersheds and their boundaries in hazardous areas using satellite synthetic aperture radar

Volcanic disasters can cause severe loss of human life and damage to property. The main damage is caused during an eruption and from subsequent erosion of deposited materials. Heavy rainfall in volcanic areas erodes volcanic deposits, mainly pyroclastic flows and ash fall deposits, which flow as lahar to the foothill of the mountain and cause drastic damage to economically important areas. This post-eruption disaster becomes complex due to the occurrence of stream captures and watershed breakouts that lead to devastating lahars. Continuous monitoring of such geomorphic and hydrologic changes is necessary to cope with changing hazard conditions. Therefore it is important to update the watershed boundaries in order to study current hazard conditions and develop mitigation plans for future disasters. Changes of geomorphic and watershed boundary have occurred in the Mayon Volcano in the Philippines mainly as a result of a major volcanic eruption of 1993, due to which mitigation structures were constructed and modified in the low lying areas. In this study interferometry was used to develop DEM from SAR data to delineate watershed boundaries. New lava flows, pyroclastic flows and lahar deposits in the watersheds were mapped using elevation changes, coherence and intensity derived from the SAR images. Updating geomorphic features of the watersheds and their boundaries using SAR provides a new weather independent alternative technique for monitoring the effect of volcanic activity.     

Esquentian of the mean by three stage procedure

Let X₁, X₂... be i.i.d. observations with mean μ and variance σ², and suppose that given a sample of size n one wishes to estimate μ by X_n, subject to the loss function L_n= A²(X_n-μ)²+n. When σ² is unknown, the optimal sample size n₀ for minimizing the risk R_n = E{L_n} cannotbe found. To resolve this problem, Robbins (1959) proposed a sequential procedure whenX_i is normally distributed, and then the asymptotic properties have been extensively studied. In this paper, we apply Hall's three stage procedure to the problem without specifying the distribution of X_i and derive the second order asymptotic expansions of the expected sample size and the risk.     

Pyrrolizidine Alkaloids Mediate Host-Plant Recognition by Ovipositing Females of an Old World Danaid Butterfly, Idea leuconoe

A giant danaid butterfly, Idea leuconoe, specializes on apocynaceous plants such as Parsonsia laevigata, which has been reported to contain pyrrolizidine alkaloids. Females of I. leuconoe deposited eggs in response to methanolic extract of P. laevigata, and subsequent bioassay-guided fractionation of the extract revealed that phytochemicals crucial for host recognition by ovipositing females are Parsonsia-specific macrocyclic pyrrolizidine alkaloids including parsonsianine, parsonsianidine, and 17-methylparsonsianidine. Parsonine, another P. laevigata pyrrolizidine component with a keto-dihydropyrrolizine moiety that is closely related in structure to male pheromones of the butterfly, and several nonhost pyrrolizidine alkaloids were entirely inactive. We interpret these data as strong evidence for an ancestral association through herbivory between danaid butterflies and pyrrolizidine alkaloids.     

Aerosol Particle Collection Efficiency of Holey Carbon Film-Coated TEM Grids

A simple sampling method to collect aerosol particles for transmission electron microscope (TEM) analysis was developed by R’mili and others in 2013. The method involves passing air through a holey carbon film-coated copper mesh TEM grid (holey carbon grid) and sampling particles by filtration. In this study, we proposed a modified calculation method to represent the collection efficiencies of holey carbon grids, taking into consideration the porosity of the copper mesh. We then evaluated the particle collection efficiencies of holey carbon grids both theoretically and experimentally. We tested the collection efficiency of two types of holey carbon grids, with nominal pore sizes of 1.2 and 0.6 μm, using particles of monodispersed polystyrene latex (PSL) and potassium chloride. The overall collection efficiency of each grid (E_grid) was determined by the downstream/upstream concentration ratio measured by condensation particle counters (CPCs). In addition, for PSL particles, the collection efficiency of the holey carbon film (E_film) was determined by the ratio of the number of particles on the film (counted on a scanning electron microscope) to the number of inflow particles (counted by a CPC). We compared model calculations against the experimental results obtained in this study and those reported by R’mili and others in 2013. These data showed that the calculated E_grid values were in reasonably good agreement with the experimental E_grid values. However, although the model calculation indicated that E_film ≈ E_grid, there was an inconsistency between the experimental E_film and E_grid, which requires further investigation in order to determine its cause.

Copyright 2014 American Association for Aerosol Research