Detection of back-side pit on a ferrous plate by magnetic flux leakage method with analyzing magnetic field vector

We have developed a magnetic flux leakage (MFL) system using magnetic resistive (MR) sensors for detecting two dimensional magnetic field components, and an induction coil that generates low magnetic field strengths and extremely low frequencies. The signal at each scanned measurement point (i) was divided by the signal strength M_mes,i and phase α_i by a lock-in amplifier. Using the strength M_mes,i and phase α_i, we calculated the imaginary part of the signal using the common phase β. By optimization of the common phase β to the imaginary part, the analyzed scanning data curve was shown to be effective in estimating the size (depth and diameter) of back-side pits on a ferrous plate. Comparing the two dimensional magnetic field components of leakage, the imaginary part of the y-component parallel to the induced magnetic field was found to be suitable for detecting the back-side pits.     

A 0.18-μm 256-Mb DDR-SDRAM with low-cost post-mold tuning methodfor DLL replica

A 200-MHz double-data-rate synchronous-DRAM (DDR-SDRAM) was developed. The chip contains a delay-locked loop (DLL) which performs over a wide range of operating conditions. Post-mold-tuning allows precise replica programming. A 200-MHz intra-chip data bus is suitable for DDR operation     

High-speed DCFL circuits with very shallow junction GaAs JFETs

High-speed DCFL (direct-coupled FET logic) circuits implemented with advanced GaAs enhancement-mode J-FETs are discussed. A divide-by-four static frequency divider operates at up to 6 GHz with a power consumption of 20 mW/flip-flop. A high channel concentration of more than 1×10¹⁸ cm^-3 together with a very shallow junction depth of less than 30 nm for the p⁺-gate results in a transconductance as high as 340 mS/mm at a gate length of 0.8 μm. Open-tube diffusion of Zn using diethylzinc and arsine makes it possible to control a very shallow p⁺-layer less than 10 nm thick. The propagation delay time, as measured with a ring oscillator, was 22 ps/gate with a power consumption of 0.42 mW/gate     

Structural Analysis of the Complex between Penta-EF-Hand ALG-2 Protein and Sec31A Peptide Reveals a Novel Target Recognition Mechanism of ALG-2

ALG-2, a 22-kDa penta-EF-hand protein, is involved in cell death, signal transduction, membrane trafficking, etc., by interacting with various proteins in mammalian cells in a Ca²⁺-dependent manner. Most known ALG-2-interacting proteins contain proline-rich regions in which either PPYPXnYP (type 1 motif) or PXPGF (type 2 motif) is commonly found. Previous X-ray crystal structural analysis of the complex between ALG-2 and an ALIX peptide revealed that the peptide binds to the two hydrophobic pockets. In the present study, we resolved the crystal structure of the complex between ALG-2 and a peptide of Sec31A (outer shell component of coat complex II, COPII; containing the type 2 motif) and found that the peptide binds to the third hydrophobic pocket (Pocket 3). While amino acid substitution of Phe⁸⁵, a Pocket 3 residue, with Ala abrogated the interaction with Sec31A, it did not affect the interaction with ALIX. On the other hand, amino acid substitution of Tyr¹⁸⁰, a Pocket 1 residue, with Ala caused loss of binding to ALIX, but maintained binding to Sec31A. We conclude that ALG-2 recognizes two types of motifs at different hydrophobic surfaces. Furthermore, based on the results of serial mutational analysis of the ALG-2-binding sites in Sec31A, the type 2 motif was newly defined.     

High dispersion ability of fluorene‐based polyester as a polymer matrix for carbon nanotubes

The high compatibility of fluorene‐based polyester (FBP‐HX) as a polymer matrix for multiwalled carbon nanotubes (MWCNTs) is discussed. A low surface resistivity due to the fine dispersion of MWCNTs in FBP‐HX and polycarbonate (PC) is reported. With a solution‐casting method, a percolation threshold with the addition of between 0.5 and 1.0 wt % MWCNTs was observed in the MWCNT/PC and MWCNT/FBP‐HX composites. Because of the coverage of FBP‐HX on the MWCNTs, a higher surface resistivity and a higher percolation ratio of the MWCNT/FBP‐HX composites were achieved compared with the values for the MWCNT/PC composites. In the MWCNT/FBP‐HX composites, MWCNTs covered with FBP‐HX were observed by scanning electronic microscopy. Because of the coverage of FBP‐HX on the MWCNTs, FBP‐HX interfered with the electrical pathway between the MWCNTs. The MWCNTs in FBP‐HX were covered with a 5‐nm layer of FBP‐HX, but the MWCNTs in the MWCNT/PC composites were in their naked state. MWCNT/PC sheets demonstrated the specific Raman absorption of the MWCNTs only with the addition of MWCNTs of 1 wt % or above because of the coverage of the surface of the composite sheet by naked MWCNTs. In contrast, MWCNT/FBP‐HX retained the behavior of the matrix resin until a 3 wt % addition of MWCNTs was reached because of the coverage of MWCNTs by the FBP‐HX resin, induced by its high wettability. © 2010 Wiley Periodicals, Inc. J Appl Polym Sci, 2010     

Development of a strain for efficient degradation of polychlorinated biphenyls by patchwork assembly of degradation pathways

Rhodococcus jostii RHA1 accumulates chlorobenzoates (CBA) during the degradation of polychlorinated biphenyls (PCBs). CBA degradation is considered one of the rate-limiting steps in the complete degradation of PCBs. To reduce the accumulation of CBAs, the upper pathway enzyme genes for PCB degradation of RHA1 were introduced into a CBA-degrading bacterium, Burkholderia sp. NK8. The resulting recombinant strain exhibited no biphenyl 2,3-dioxygenase (BphA) activity encoded by bphAaAbAcAd genes, which encode the large and small subunits of the terminal oxygenase component and the ferredoxin and reductase subunits responsible for electron transfer from NADH to the large subunit. The remaining enzyme genes involved in the transformation of biphenyl to benzoate, bphB2C1D1, which encode dehydrogenase, ring-cleavage dioxygenase and hydrolase, conferred activities to NK8. To obtain the BphA activity of RHA1 in NK8, sets of BphA genes were constructed by combining the bphAaAbAcAd genes of RHA1 and bphA3A4 of Pseudomonas pseudoalcaligenes KF707, encoding the ferredoxin and reductase subunits. Hybrid derivatives of BphA containing the KF707 bphA3 conferred BphA activity to NK8, and a derivative containing the RHA1 bphAaAb and KF707 bphA3A4 genes exhibited the highest BphA activity. A plasmid containing the RHA1 bphAaAb and KF707 bphA3A4 genes plus the RHA1 bphB2C1D1 genes was constructed and introduced into NK8. The resulting recombinant strain efficiently degraded 2-, 3- and 4-chlorobiphenyls with an apparent reduction in CBA accumulation in comparison to the recombinant mutant strain, which had an insertion in the cbeA gene to inactivate CBA dioxygenase.     

Estimation of concentrations of antifungal agents allowed as food additives in foods and their daily intake based on official inspection results in Japan in fiscal year 1998

The mean concentrations and daily intake of four antifungal agents were estimated based on the results of an analysis of 7,005 samples of food obtained in official inspections by Japanese local governments in fiscal year 1998. The mean concentration of diphenyl was 0.0004% of the allowable limit, and those of imazalil, o-phenylphenol, and thiabendazole were 14.0%, 3.5%, and 5.7%, respectively. The daily intakes of these antifungal agents per person, estimated from their concentrations and the daily consumption of the foods, were 0.000326, 1.89, 11.5, and 23.3 micrograms, respectively, and assuming a body weight of 50 kg, the amounts of these antifungal agents consumed were 0.000013%, 0.15%, 0.12%, and 0.47% of the acceptable daily intake, respectively. These values are similar to the values obtained on the basis of the results of the official inspection in fiscal years 1994 and 1996, except that the amount of diphenyl is much lower (1/100).     

Contribution of high p34cdc2 kinase activity to premature chromosome condensation of injected somatic cell nuclei in rat oocytes

The present study was undertaken to clarify the relationship between the p34cdc2 kinase activity of in vitro-aged or enucleated rat oocytes and the premature chromosome condensation (PCC) of microinjected cumulus cell nuclei. Wistar rat oocytes were placed in vitro up to 120 min after the animal was killed. The p34cdc2 kinase activity of the oocytes decreased in a time-dependent manner. The incidence of PCC was higher when nuclear injection into intact oocytes was completed in 15-45 min rather than 46-120 min. When rat oocytes were enucleated for subsequent nuclear injection, the p34cdc2 kinase activity transiently increased soon after enucleation but drastically decreased after 30 min. Removal of the cytoplasm instead of the meta-phase-plate did not affect the p34cdc2 kinase activity even after 60 min. PCC occurred in intact and cytoplasm-removed oocytes but not in enucleated oocytes. In contrast, oocytes from BDF1 mice exhibited a p34cdc2 kinase level twice that of rat oocytes and supported PCC despite enucleation. The p34cdc2 kinase level of intact rat oocytes was reduced to the equivalent level of aged (120 min) or enucleated (+60 min) oocytes by a 45 min treatment with roscovitine, an inhibitor of p34cdc2 kinase. None of the roscovitine-treated oocytes supported PCC while half of the control oocytes did. When rat oocytes were treated with MG132, a proteasome inhibitor, delayed inactivation of the p34cdc2 kinase was observed in the MG132-treated oocytes. A significantly higher proportion of the MG132-treated oocytes supported PCC when compared with the control oocytes. Moreover, a higher proportion of MG132-treated and enucleated oocytes carried two pseudo-pronuclei after cumulus cell injection and developed to the two-cell stage when compared with the enucleated oocytes at the telophase-II stage. These results suggest that the decreased level of p34cdc2 kinase activity in aged or enucleated rat oocytes is responsible for their inability to support PCC of microinjected donor cell nuclei and that inhibition of p34cdc2 kinase inactivation by chemicals such as MG132 is in part effective for rat oocytes to promote PCC and further development.     

Processing of Ultrafine-Grained Materials through the Application of Severe Plastic Deformation

Processing through the application of severe plastic deformation (SPD) has become an absorbing tool because it provides the potential for refining the grain size of polycrystalline bulk metals to the submicrometer or even the nanometer level. Several SPD methods are now available, but the more promising procedures seem to be equal-channel angular pressing (ECAP) and high-pressure torsion (HPT). This report examines these procedures with an emphasis on the principles of grain refinement and the mechanical properties developed at high temperatures in materials after processing by ECAP and the hardness homogeneity and microstructural evolution in materials processed by HPT. Moreover, recent observations on the ECAP and HPT processing also are discussed.