Energy Dissipation and Apparent Viscosity of Semi-solid Metal during Rheological Processes Part Ⅱ： Apparent Viscosity

This study investigated the rheological properties of semi-solid metal. An analytical model of apparent viscosity was built up based on analysis of energy dissipation during rheological processes such as slurry preparing, delivering and model filling. The rheological properties of SSM （semi-solid metal） slurry was described by an analytical model in terms of microstructural parameters, which consist of effective solid fraction, particle size and shape, and flow parameters such as mean velocity, fluctuant velocity and relative velocity between liquid and solid phase. The model was verified in the experiment of A356 alloys with a coaxial double-bucket rheometer. And the maximum relative error between the theoretical value and measured one is less than 20%. The results of experiment and theoretical calculation also indicate that the microstructural parameters and flow parameters are two major factors that affect the apparent viscosity of semi-solid alloys, and fluctuant velocity and relative velocity between liquid and solid phase are the key factors to distinguish between steady and transient rheological properties.     

Study of the electrical cycling stressed large area Schottky diodes using I–V and noise measurements

Large area commercial Al/n-Si Schottky diodes were subjected to an electrical cycling stress in order to cause degradation of diodes with local contact irregularities. Using the I–V characteristics and noise measurements in the frequency range of 10 Hz to 10 kHz at room temperature and using the corresponding equivalent circuit representation of degraded diodes, it has been shown that the latent leakage paths contribute to the degradation of the Schottky diodes under the test conditions. The results could be used to confirm that the ideality factor cannot be alone used as prediction tool of diode behavior under electrical cycling stress. The conclusion of this paper is that the results show that this kind of the stress test can be used as a screening test for diodes with latent leakage current paths.     

在实时控制系统中通过FlexRay同步多种器件

让我们设想这样一个控制系统:其中多个器件用于对模拟数量进行抽样,一个强大的中心器件用于处理测量值并计算控制操作,还有另外一些器件用于生成控制信号.它的一个实例就是4轮汽车主动减震系统,其传感器和驱动器件置于车轮附近,控制器位于中央位置.所有器件使用同一个通信系统.要实现这些目的,可使用FlexRay等时分多址(TDMA)通信协议(参考文献1).     

Benchmarking distribution centres using Principal Component Analysis and Data Envelopment Analysis: A case study of Serbia

The efficiency of distribution systems is largely affected by the performances of distribution centres. The main objective of this paper is to develop and propose a DEA model for distribution centres efficiency measuring that can help managers in decision making and improving the efficiency. Due to numerous indicators that describe DCs operating, the main problem is indicators selection. In order to improve discriminatory power of classical DEA models PCA–DEA approach is used. This paper analysis the efficiency of distribution centres of one trading company in Serbia. Proposed models integrate operational, quality, energy, utilisation and equipment warehouse and transport indicators. Several hypotheses are tested in this paper. The results showed that small distribution centres are more efficient than large.     

Advanced LMI based analysis and design for Acrobot walking

This article aims to further improve previously developed design for Acrobot walking based on partial exact feedback linearisation of order 3. Namely, such an exact system transformation leads to an almost linear system where error dynamics along trajectory to be tracked is a 4-dimensional linear time-varying system having three time-varying entries only, the remaining entries being either zero or one. In such a way, exponentially stable tracking can be obtained by quadratically stabilising a linear system with polytopic uncertainty. The current improvement is based on applying linear matrix inequalities (LMI) methods to solve this problem numerically. This careful analysis significantly improves previously known approaches. Numerical simulations of Acrobot walking based on the above-mentioned LMI design are demonstrated as well.     

Gas sensing properties of nanocrystalline diamond films

Toxic gas sensing device with metal electrodes built into nanocrystalline diamond (NCD) is investigated. The NCD morphology is controlled via seeding and/or deposition time. The surface properties and morphology of NCD are studied using scanning electron microscopy (SEM) and atomic force microscopy (AFM). AFM measurements reveal increase in NCD surface area by up to 13%. Gas sensing properties of H-terminated NCD device show high sensitivity towards oxidizing species where the surface conductivity is increased by an order of magnitude for humid air and by three orders of magnitude for COCl₂. The surface conductivity exhibits a small decrease to reducing spices (CO₂, NH₃).     

π-ELECTRON CONTENTS OF RINGS IN THE DOUBLE-HEXAGONAL-CHAIN HOMOLOGOUS SERIES (PYRENE,ANTHANTHRENE AND OTHER ACENOACENES)

Abstract

Recently three methods for calculating the π-electron content of rings of benzenoid hydrocarbons were put forward: one based on the consideration of Kekuléstructural formulas, and the other two based on an analogous treatment of the Clar aromatic sextet formulas. These three methods are applied to the homologous series consisting of two condensed acene chains (whose first members are pyrene, anthanthrene, peri-naphthacenonaphthacene, …), leading to basically identical results. In contrast to acenes (in which the partition of π-electrons into rings is uniform), in the double-hexagonal-chain species the partition of π-electrons is highly non-uniform. The electron content monotonically decreases, in opposite directions, along the two acene chains, being maximal in the least annelated rings. Some other generally valid regularities in the π-electron properties of the double–hexagonal–chain benzenoids are also pointed out.     

The effect of pressure on GRIN lenses

The changes of the optical power of Gradient Index (GRIN) lenses occurring in hydrostatic pressures of the range of 0-2 GPa are investigated. The measurements of the position of the waist of the semiconductor laser beam revealed the increase of the optical power of the lenses with increasing pressure. The use of the special plano-concave lenses insensitive to the changes of the refractive index of the pressure medium allowed to attribute the changes to the increasing index gradient in GRIN material. The effect has been explained within the frame of Mueller’s theory of photoelasticity. The findings have been then confirmed in experiments with the plano-planar and plano-convex lenses of the same materials.     

Variation in fatty acid composition of ewes' milk during continuous transition from dry winter to natural pasture diet

The profile variations of approximately 70 fatty acids (FAs) in milk of ewes consuming total mixed rations (TMR) and grazing natural pasture were determined. Milk of ewes grazing pasture in May and September in the Slovak Republic contained 3-times more conjugated linoleic acid (CLA) (P < 0.001) and trans-vaccenic acid (TVA) (P < 0.001), and 2-times more α-linolenic acid (ALA) (P < 0.001) than that of ewes fed TMR. A doubling of the CLA and TVA contents of milk of ewes fed with TMR was achieved by changing to meadow hay containing a higher ALA content. Less availability of vegetation and lower ALA pasture content in summer (P < 0.001) caused a 2-fold decrease (P < 0.001) of CLA and TVA contents when compared with data obtained in May. With grass re-growth and an increase in pasture ALA content in September, the CLA and TVA contents rose to values similar to those obtained in May (P > 0.05). No significant differences in the FA composition in milk of ewes grazing on summer pasture at higher altitude were observed.