Investigation of charge transport mechanism in semiconducting La<Subscript>0.5</Subscript>Ca<Subscript>0.5</Subscript>Mn<Subscript>0.5</Subscript>Fe<Subscript>0.5</Subscript>O<Subscript>3</Subscript> manganite prepared by sol–gel method

Here in, we report the charge transport mechanism in semiconducting La_0.5Ca_0.5Mn_0.5Fe_0.5O₃ (LCMFO) polycrystalline material synthesized via sol–gel auto combustion route. X-ray diffraction (XRD) analysis confirmed the orthorhombic phase of the prepared material. Temperature dependent resistivity and impedance spectroscopy measurements have been carried out to probe the dielectric and electrical conduction mechanism which revealed a change of Mott variable range to the small polaronic hopping conduction mechanism around 303 K. The complex impedance and modulus spectra undoubtedly showed the contribution of both grain and grain boundary effect on the conduction properties of LCMFO. An equivalent circuit [(R_gbQ_gb) (R_gQ_g)] model has been used to address the electrical parameters associated with the different phases (grains and grain boundaries) having different relaxation times. The values of resistances of two phases obtained after fitting the equivalent circuit in the nyquist plot have been analyzed which confirmed the change of conduction mechanism around 303 K. The resultant change in conduction mechanism is also supported by the conductivity plots.     

Soret and Dufour effects between two rectangular plane walls with heat source/sink

This study addresses the thermo‐diffusion and the diffusion‐thermo phenomena in a semi‐infinite absorbent channel whose walls are contracting/expanding, with heat source/sink effects. The governing partial differential equations with suitable boundary conditions are transformed to a system of dimensionless ordinary differential equations. An analytic solution of the problem has been found using a technique called homotopy analysis method (HAM). HAM gives consistently valid answers to the problem over an extensive variety of parameters and also provides better accuracy. To validate the analytical results, a comparison has been presented with a numerical solution calculated by using the parallel shooting method. The effects of dimensionless parameters, that is, deformation parameter, Reynolds number, Soret and Dufour numbers, and heat source/sink parameter on the expressions of velocity, temperature, and concentration profiles are analyzed graphically to understand the physics of the deformable channel. It has been noted that the velocity across the channel is higher for the expanding channel, as compared to that for the contracting channel. Also the Soret and Dufour number increases the temperature of the fluid, and decreases the concentration. The temperature profile has an increasing behavior in the case of heat source, and a decreasing behavior in the case of heat sink.     

Ubiquitin in cerebrospinal fluid: a rapid competitive enzyme-linked immunoflow assay

The aims of this study were to develop a rapid immunoassay to determine the levels of ubiquitin in cerebrospinal fluid and to establish the ubiquitin levels in the spinal fluid of normal aged individuals. A competitive enzyme-linked immunoflow assay was developed. In this assay, ubiquitin is bound to nitrocellulose membrane, after which the primary antibody-test sample mixture and the enzyme-labeled secondary antibody under vacuum are applied sequentially. The final reaction product is collected in a microtiter plate by suction. This competitive assay requires only approximately 4 h and is potentially useful for determining in biological fluids the levels of any antigen or its antibodies that might be present. Employing this immunoassay, cerebrospinal fluid ubiquitin levels were found to be 147.5 +/- 5.2 ng ml-1 in non-neurological aged cases.     

Thermal depolarization and electromechanical hardening in Zn2+-doped Na1/2Bi1/2TiO3-BaTiO3

Na_1/2Bi_1/2TiO₃-based materials have been earmarked for one of the first large-volume applications of lead-free piezoceramics in high-power ultrasonics. Zn²⁺-doping is demonstrated as a viable route to enhance the thermal depolarization temperature and electromechanically harden (1-y)Na_1/2Bi_1/2TiO₃-yBaTiO₃ (NBT100yBT) with a maximum achievable operating temperature of 150 °C and mechanical quality factor of 627 for 1 mole % Zn²⁺-doped NBT6BT. Although quenching from sintering temperatures has been recently touted to enhance T_F-R, with quenching the doped compositions featuring an additional increase in T_F-R by 17 °C, it exhibits negligible effect on the electromechanical properties. The effect is rationalized considering the missing influence on conductivity and therefore, negligible changes in the defect chemistry upon quenching. High-resolution diffraction indicates that Zn²⁺-doped samples favor the tetragonal phase with enhanced lattice distortion, further corroborated by ²³Na Nuclear Magnetic Resonance investigations.     

Effect of irrigation on the lipid composition of taramira seed

The effect of irrigation on the lipid composition in maturing taramira (Eruca sativa, Mill) seed was studied. Decreasing the number of irrigations had an adverse effect on oil setting. Restricted irrigations affected adversely the biosynthesis of erucic acid in the oil at initial stages, though at later stages of seed development, irrigation had no such effect.     

Feeding barley grain steeped in lactic acid modulates rumen fermentation patterns and increases milk fat content in dairy cows

The objectives of the present in vivo and in situ trials were to evaluate whether feeding barley grain steeped in lactic acid (LA) would affect rumen fermentation patterns, in situ dry matter (DM) degradation kinetics, and milk production and composition in lactating dairy cows. The in vivo trial involved 8 rumen-fistulated Holstein cows fed once daily a total mixed ration containing rolled barley grain (27% in DM) steeped for 48 h in an equal quantity of tap water (CTR) or in 0.5% LA (TRT) in a 2 × 2 crossover design. The in situ trials consisted of incubation of untreated rolled barley grain in cows fed CTR or TRT diets and of incubation of 3 different substrates including CTR or barley grain steeped in 0.5% or 1.0% LA (TRT1 and TRT2, respectively) up to 72 h in the rumen. Results of the in vivo trial indicated that cows fed the TRT diet had greater rumen pH during most intensive fermentation phases at 10 and 12 h post-feeding. The latter effect was associated with a shorter duration in which rumen pH was below 5.8 for cows fed the TRT diet (2.4 h) compared with CTR diet (3.9 h). Furthermore, cows fed the TRT diet had lower concentrations of volatile fatty acids at 2 and 4 h post-feeding. In addition, concentrations of preprandial volatile fatty acids were lower in the rumen fluid of cows fed the TRT diet. Results also showed that molar proportion of acetate was lower, whereas propionate tended to increase by feeding cows the TRT diet. Cows fed the TRT diet demonstrated greater rumen in situ lag time of substrate DM degradation and a tendency to lower the fractional degradation rate. Other in situ results indicated a quadratic effect of LA on the effective rumen degradability of substrates whereby the latter variable was decreased from CTR to TRT1 but increased for TRT2 substrate. Although the diet did not affect actual milk yield, fat-corrected milk, percentages of milk protein, and lactose and concentration of milk urea nitrogen, cows fed the TRT diet increased milk fat content and tended to increase fat:protein ratio in the milk. In conclusion, results demonstrated that treatment of barley grain with LA lowered the risk of subacute rumen acidosis and maintained high milk fat content in late-lactating Holstein cows fed diets based on barley grain.     

Synthesis and properties of cross‐linked polymers from epoxidized rubber seed oil and triethylenetetramine

A series of epoxidized oils were prepared from rubber seed, soybean, jatropha, palm, and coconut oils. The epoxy content varied from 0.03 to 7.4 wt %, in accordance with the degree of unsaturation of the oils (lowest for coconut, highest for rubber seed oil). Bulk polymerization/curing of the epoxidized oils with triethylenetetramine (in the absence of a catalyst) was carried out in a batch setup (1 : 1 molar ratio of epoxide to primary amine groups, 100°C, 100 rpm, 30 min) followed by casting of the mixture in a steel mold (180°C, 200 bar, 21 h) and this resulted in cross‐linked resins. The effect of relevant pressing conditions such as time, temperature, pressure, and molar ratio of the epoxide and primary amine groups was investigated and modeled using multivariable nonlinear regression. Good agreement between experimental data and model were obtained. The rubber seed oil‐derived polymer has a T_g of 11.1°C, a tensile strength of 1.72 MPa, and strain at break of 182%. These values are slightly higher than for commercial epoxidized soybean oil (T_g of 6.9°C, tensile strength of 1.11 MPa, and strain at break of 145.7%). However, the comparison highlights the potential for these novel resins to be used at industrial/commercial level. © 2015 Wiley Periodicals, Inc. J. Appl. Polym. Sci. 2015 , 132, 42591.     

Modelling and Analysis of Electro‐chemical,Thermal, and Reactant Flow Dynamics for a PEM Fuel Cell System

In this paper an approach for the dynamic modelling of polymer electrolyte membrane fuel cells is presented. A mathematical formulation based on empirical equations is discussed and several features, exhibiting dynamic phenomena, are investigated. A generalized steady state fuel cell model is extended for the development of a method for dynamic electrochemical analysis. Energy balance and reactant flow dynamics are also explained through physical and empirical relationships. A well‐researched system (Ballard MK5‐E stack based PGS‐105B system) is considered in order to understand the operation of a practical fuel cell unit. Matlab‐SIMULINK^TM has been used in simulating the models. The proposed method appears to be relatively simple and consequently requires less computation time. Simulation results are compared with available experimental findings and a good match has been observed.