Preparation of Aluminum Nitride Powder from Aluminum Polynuclear Complexes

AIN powder was synthesized from aluminum polynuclear complexes. Basic aluminum chloride and basic aluminum lactate were used as the aluminum polynuclear complexes. These starting materials and glucose were dissolved in water and mixed homogeneously. AIN powder was obtained by calcining after drying and precalcining at 800°C under nitrogen gas flow. Then excess carbon was removed by firing in air. Nitridation in the system was investigated and compared with that in the alumina–carbon black system. It was found that in our reaction system nitridation began and proceeded at lower calcination temperatures above 1200°C than in the alumina–carbon black system. Using aluminum polynuclear complexes, AIN was synthesized through the nitridation of γ-alumina and produced in a very fine and sharp particle size distribution.     

Studies on the biaxial stretching of polypropylene film. XI. Type II orientation during [2-2FI]-type stretching and its change by subsequent thermal contraction

In order to study the deformation mechanism of type II stretching, the change in orientation during the restretching and subsequent thermal contraction was investigated by x-ray diffraction method. When a uniaxially oriented film is restretched, the lamellae which are stacked in the stretching direction by the stretching rotate as a whole toward the restretching axis. They rotate backward nearly reversibly during the thermal contraction, unless the restretching exceeds a balancing state, where the orientation in the film plane are equal in all directions. However, when the restretching degree is so high and the film orientation exceeds the balancing state, the lamellar rotation is accompanied by a complex phenomenon. It is considered from the wide-angle and small-angle x-ray diffraction patterns that the lamellar surface becomes indented because of slippage between microfibrils composing the lamellae, and the microfibrils themselves bend at the boundary between the amorphous and crystalline regions within which the tilting of c-axis also occurs. Upon contracting of the film; these changes recover, but even in the last stage of contraction the orientation approaches the symmetrical biaxial orientation but not the uniaxial orientation from which the biaxial orientation is started. These orientation and disorientation behaviors are not affected basically by a slight change in the restretching temperature and the degree of stretching.     

Robust loss functions for boosting

Boosting is known as a gradient descent algorithm over loss functions. It is often pointed out that the typical boosting algorithm, Adaboost, is highly affected by outliers. In this letter, loss functions for robust boosting are studied. Based on the concept of robust statistics, we propose a transformation of loss functions that makes boosting algorithms robust against extreme outliers. Next, the truncation of loss functions is applied to contamination models that describe the occurrence of mislabels near decision boundaries. Numerical experiments illustrate that the proposed loss functions derived from the contamination models are useful for handling highly noisy data in comparison with other loss functions.     

Multiple kernel learning with gaussianity measures

Kernel methods are known to be effective for nonlinear multivariate analysis. One of the main issues in the practical use of kernel methods is the selection of kernel. There have been a lot of studies on kernel selection and kernel learning. Multiple kernel learning (MKL) is one of the promising kernel optimization approaches. Kernel methods are applied to various classifiers including Fisher discriminant analysis (FDA). FDA gives the Bayes optimal classification axis if the data distribution of each class in the feature space is a gaussian with a shared covariance structure. Based on this fact, an MKL framework based on the notion of gaussianity is proposed. As a concrete implementation, an empirical characteristic function is adopted to measure gaussianity in the feature space associated with a convex combination of kernel functions, and two MKL algorithms are derived. From experimental results on some data sets, we show that the proposed kernel learning followed by FDA offers strong classification power.     

PNET “ONDM 2019” special issue

Photonic Network Communications -     

A CMOS 1/spl times/-16/spl times/ speed DVD write channel IC

Optical recording demands a meticulous write strategy to control the laser beam power and regulate the phase change layer temperature tightly. The width, height, and delay of a string of short pulses applied to the laser diode need to be adjusted in fine steps, and the writing speed varies widely per applications. A multi-phase phase-locked loop (PLL) tracks a wide range of clock frequencies, and provides a low-jitter time base for write pulses. With two enabling circuit concepts, PLL loop filter voltage folding/unfolding and switch-in of parallel MOS resistors in delay cells, it is possible to operate a PLL to cover a frequency range spanning over three octaves with one VCO. A 10-stage differential VCO is phase-locked to the input channel clock ranging from 26 to 420 MHz (1/spl times/-16/spl times/ DVD speed), and its 20-phase outputs are used to generate write pulses. The pulsewidth and delay are programmed with 120 /spl plusmn/ 40 ps time resolution. The prototype chip fabricated in 0.35 /spl mu/m CMOS occupies 3.5/spl times/3.3 mm/sup 2/, and consumes 294 mW at 3.3 V.     

Effect of off-orientation of seed crystal on silicon carbide (SiC) single-crystal growth on the (11 $$\bar 2$$ 0) surface0) surface

The effect of off-orientation growth has been investigated in terms of stacking fault formation during physical vapor transport (PVT) growth of silicon carbide (SiC) single crystals on the (11 0) seed crystal surface. Occurrence of stacking fault formation is largely dependent on the direction of off-orientation, and basal plane stacking fault density is significantly reduced by growing the crystals on a (11 0) seed crystal off-oriented toward 〈0001〉. The density of the basal plane stacking faults rapidly decreases from 100–150 cm⁻¹ to ∼10 cm⁻¹ as the degree of off-orientation is increased from 0 to 10 deg. The results are interpreted in the framework of microscopic facet formation during PVT growth, and the introduction of off-orientation of seed crystal is assumed to prevent (01 0) and (10 0) microfacet formation on the (11 0) growing surface through modification of the surface growth kinetics and to suppress the stacking fault formation. An erratum to this article is available at .     

An antenna impedance measuring system for the medium-wave with interference signal suppression function

An impedance analyzer or the Schering bridge is usually used for measurement of the medium-wave antenna impedance. However it has been said to be impossible to measure the exact antenna impedance under a high-intensity electric field environment generated by such as a neighboring radio station, especially with the same operating frequency because an undesired large signal is induced at the antenna input port. We propose a new measurement method and an instrument using a double synchronized detection, which has a function to suppress undesired signals efficiently. Here a double synchronous detecting technique is introduced to suppress the undesired signal with the same frequency as a measurement frequency. This system makes it possible to easily measure the antenna impedance with higher accuracy even under such an environment and also is useful for periodical maintenance of the transmitting antenna without interruption of broadcasting services in the daytime.     

Receptor function of small semiconductor crystals with clean and electron-traps dispersed surfaces

Theoretical exploration has been conducted to formulate the receptor function and response of a semiconductor gas sensor using thin plate-like crystals. The receptor function can be formulated over a wide range of depletion from conventional one (regional depletion) to new type one (volume depletion) by focusing attention on how the surface density of adsorbed oxygen ions (O⁻) is related with chemical moiety outside the crystals and physical moiety inside. The responses to gases thus derived are inversely proportional to the thickness of the plates used in the range of volume depletion. Electron-traps, if dispersed on the crystals, are shown to exert drastic effects in promoting sensitivity to gases.     

Am1 MO Study of Benzene Nitro Derivatives

Molecular properties of benzene nitro derivatives were investigated by using semi-empirical MO calculations. As the results, the molecular structures and the rotational barrier of the nitro group calculated by AM1 showed a good agreement with the experimental values. The heats of formation in gaseous and condensed phases were obtained by considering isodesmic reactions. By this procedure, the heat of formation of hexanitrobenzene in solid phase was calculated to be +22.7 kcal/mol. The detonation parameters were also calculated by using four equations of state. The predicted detonation velocities showed a good agreement with the experimental values.