Adaptive modulation and combining for bandwidth and power efficient communication over fading channels

Traditional fading mitigation techniques are designed relative to the worst‐case channel conditions, resulting in a poor utilization of the spectrum and the available power a good percentage of the time. In contrast, we introduce and investigate in this paper new adaptive modulation and diversity combining techniques that jointly select the most appropriate constellation size and the most suitable diversity branches in response to the channel variation and given a desired bit error rate (BER) requirement. Numerical results show that these newly proposed adaptive modulation and combining schemes can reduce considerably the average receiver channel estimation complexity as well as the power drain from the battery while offering high spectral efficiency and satisfying the desired outage probability and BER requirements. Copyright © 2006 John Wiley & Sons, Ltd.     

LED发光式LAN电缆测试器

电缆与连接器故障在LAN(局域网)中相对较常见。图1的电路可以测试直通或交叉式10BaseT、100BaseT或千兆位UTP(非屏蔽双绞线)和STP(屏蔽双绞线)电缆。电路会对每个链接线对作一次连续测试。当电缆两端RJ-45连接器的相应线对正确连     

J integral solution for semi-elliptical surface crack in high density poly-ethylene pipe under bending

The goal of this work is to analyse the severity of semi-elliptical crack defects and to study the degree of damage in the poly-ethylene pipe in bending during the crack propagation. The semi-elliptical cracks are considered in this work located in different position in the wall of the pipe. The three finite element method based on the computation of the J integral was used to analyse the fracture behaviour of these structures. The effect of the position, shape and size of the crack on the J integral values was highlighted. The effects of strain rate and the temperature on the J integral values were also examined. The obtained results show that the strain rates have a strong influence on the J integral values especially for circumferential crack at higher bending moment. However, the energy for circumferential crack is more important compared to axial crack. The effect of the depth of the crack becomes important when the ratio (a/t) reaches a critical value of 0.6 (a/t = 0.6), especially when the ratio a/c is weak (semi-elliptical crack, a/c = 0.2) where the J integral values becomes independently of the crack depth, this conclusion is opposite to the above for the poly-ethylene pipe subjected to internal pressure. We recall finally, that the temperature effect on circumferential cracks behaviour is more important compared to the axial cracks at critical crack size (a/c = 0.2 and a/t = 0.6). It is also shown that in the wall of pipe, the internal cracks are more dangerous than the external cracks.     

Postharvest physiology and technology of loquat (Eriobotrya japonica Lindl.) fruit

Loquat (Eriobotrya japonica Lindl.) is a subtropical evergreen tree whose fruit is consumed both fresh and processed. Loquat fruit is a good source of minerals and carotenoids, while the kernel is rich in protein and carbohydrates. It has been considered a non‐climacteric fruit, but there is evidence that some cultivars have a ripening pattern similar to that of climacteric fruits. The fruit has a short postharvest life at ambient temperatures and is susceptible to physical and mechanical damage, loss of moisture and nutrients, and decay. Low‐temperature storage extends the shelf life of loquat fruit, but some cultivars are severely affected by chilling injury and flesh browning during cold storage. Purple spot, browning and leatheriness are major postharvest disorders. The shelf life of loquat can be extended by modified or controlled atmosphere storage as well as by postharvest treatment with 1‐methyl cyclopropene or methyl jasmonate. © 2014 Society of Chemical Industry     

Comparative study of various methods for extraction of multi- quantum wells Schottky diode parameters

In this work, forward current voltage characteristics for multi-quantum wells Al_0.33Ga_0.67As Schottky diode were measured at temperature ranges from 100 to 300 K. The main parameters of this Schottky diode, such as the ideality factor, barrier height, series resistance and saturation current, have been extracted using both analytical and heuristics methods. Differential evolution (DE), particle swarm optimization (PSO) and artificial bee colony (ABC) have been chosen as candidate heuristics algorithms, while Cheung technic was selected as analytical extraction method. The obtained results show clearly the high performance of DE algorithms in terms of parameters accuracy, convergence speed and robustness.     

Diffusion analysis and modeling of kinetic behavior for treatment of brine water using electrodialysis process

In this study, the removal of monovalent and divalent cations, Na⁺, K⁺, Mg²⁺, and Ca²⁺, in a diluted solution from Chott-El Jerid Lake, Tunisia, was investigated with the electrodialysis technique. The process was tested using two cation-exchange membranes: sulfonated polyether sulfone cross-linked with 10% hexamethylenediamine (HEXCl) and sulfonated polyether sulfone grafted with octylamine (S-PESOS). The commercially available membrane Nafion® was used for comparison. The results showed that Nafion® and S-PESOS membranes had similar removal behaviors, and the investigated cations were ranked in the following descending order in terms of their demineralization rates: Na⁺ > Ca²⁺ > Mg²⁺ > K⁺. Divalent cations were more effectively removed by HEXCl than by monovalent cations. The plots based on the Weber–Morris model showed a strong linearity. This reveals that intra-particle diffusion was not the removal rate-determining step, and the removal process was controlled by two or more concurrent mechanisms. The Boyd plots did not pass through their origin, and the sole controlling step was determined by film-diffusion resistance, especially after a long period of electrodialysis. Additionally, a semi-empirical model was established to simulate the temporal variation of the treatment process, and the physical significance and values of model parameters were compared for the three membranes. The findings of this study indicate that HEXCl and S-PESOS membranes can be efficiently utilized for water softening, especially when effluents are highly loaded with calcium and magnesium ions.     

Thermal buckling analysis of laminated composite beams using hyperbolic refined shear deformation theory

In this article, thermal buckling of laminated composite beams, based on hyperbolic refined shear deformation theory, presented for the first time, is formulated using the principle of minimum total potential energy. Navier’s analytical solution is derived to analytically solve the differential equations and the thermal critical buckling is presented in closed-form solution. The effects of temperature distribution, length to thickness ratio, modulus ratio, and thermal expansion coefficient ratio on thermal buckling of isotropic, orthotropic and laminated composite beams are investigated. The accuracy of the numerical model is verified by comparison with the available results in the literature.     

Mechanical Properties Analysis of 4340 Steel Specimen Heat Treated in Oven and Quenching in Three Different Fluids

This paper proposes a statistical approach to analyze the mechanical properties of a standard test specimen, of cylindrical geometry and in steel 4340, with a diameter of 6 mm, heat-treated and quenched in three different fluids. Samples were evaluated in standard tensile test to access their characteristic quantities: hardness, modulus of elasticity, yield strength, tensile strength and ultimate deformation. The proposed approach is gradually being built (a) by a presentation of the experimental device, (b) a presentation of the experimental plan and the results of the mechanical tests, (c) anova analysis of variance and a representation of the output responses using the RSM response surface method, and (d) an analysis of the results and discussion. The feasibility and effectiveness of the proposed approach leads to a precise and reliable model capable of predicting the variation of mechanical properties, depending on the tempering temperature, the tempering time and the cooling capacity of the quenching medium.     

A Novel Graph-Based Approach for the Management of Health Data on Cloud-Based WSANs

Nowadays, healthcare applications become among the most important services that help to improve the public safety through, for example, the prevention of the propagation of some epidemic diseases from patient to another or better from a location to another. Wireless Body Area Networks (WBANs) are considered among the major sources that enable the collection of such kind of data that shares in most cases the properties of big data and that needs to be stored and managed in an efficient manner. Regarding this need, Wireless Storage Area Networks (WSANs) have been considered among the alternatives to store generated health data. Even if these infrastructures enable the storage of huge volumes of data, there are some issues related to the efficient storage and processing of health data that still not resolved and that are of interest for the research communities. In this context, this paper proposes a cloud-based WSAN approach that enables the storage and the management of health data in an efficient manner by representing the collected data and their dependencies using Temporal Conceptual Graphs (TCGs). The validity of the generated graphs is verified by the proposed graph checker that enables the localization of semantic errors in such structure to prevent some threats to be realized for stored health data and to ensure the privacy of patients. The efficiency of the proposed approach is illustrated for different defined scenarios of diseases and their associated health data represented through generated TCGs.