ISS experiments for the clarification of boiling and two-phase flow in microgravity and for the development of high-performance space cold plates

Inflow boiling, gravity effects on the distribution of both phases are observed in a heated tube and heat transfer coefficients due to two-phase forced convection is deteriorated in microgravity. In narrow channels between heated and unheated plates, the increase in subcooling enlarges a size of flattened bubble and reduces the frequency of detachment under microgravity conditions resulting the emphasis of heat transfer deterioration. To clarify reasons for the unknown behaviors of interfacial distribution and corresponding characteristics in heat transfer not easily be clarified through the experiments on ground, the opportunity on the experiments utilizing long-term microgravity duration realized in ISS is required. The experiments on microgravity boiling and two-phase flow are proposed by the collaboration of researchers in five countries. A common test loop is designed to conduct multiple experiments by the interchangeable structures of test sections; a transparent heated tube for the visualized flow boiling, a stainless tube for the measurement of CHF data, a copper surface for the heat transfer data of nucleate boiling with superimposed liquid flows in a duct, a glass heated plate with multiple array of small temperature sensors and transparent heaters for the clarification of mechanisms in nucleate boiling heat transfer, and one or two models of cold plates for practical applications. A direction of researches in the present discipline is proposed based on the existing experimental results and on the idea developed by the present authors.     

Czochralski growth of Yb doped oxyapatite for high power laser application

Ca₈(La,Yb)₂(PO₄)₆O₂ (Yb:CLPA) single crystals with the apatite-type structure could be grown from the melt using the Czochralski method. Grown crystal was 18 mm in diameter and 110 mm in length. It is transparent with slightly blue color. Neither visible inclusion nor crack was observed. Thermal conductivity of Yb:CLPA was calculated from the values of thermal diffusivity, heat capacity measurement and density. Luminescent characterization was carried out from the results of emission, absorption and Raman spectrum.     

A two-degree-of-freedom motor-powered gait orthosis for spinal cord injury patients

A number of orthoses have been developed to restore stance and walking in paraplegic subjects. Compliance, however, has been limited, mainly owing to walking effort. Use of the forces produced by actuators is an effective way to solve the problem of the considerable effort required for orthotic gait, namely high muscular effort and high energy expenditure. The purpose of the present study was to investigate the effects of assistance by external actuators on the orthotic gait of spinal cord injury (SCI) patients. Two kinds of linear actuator were developed by using direct current (d.c.) motors for assisting the knee and hip joint of a gait orthosis. They were mounted on the knee and hip joint of a commercial advanced reciprocating gait orthosis (ARGO), and a new two-degree-of-freedom externally powered gait orthosis was thus developed. The orthosis was assessed through inter-subject experiments on five male adult complete SCI patients. Owing to the short training period available for the assisted gait, simultaneous operation of both joint actuators was not conducted: either the knee actuation or the hip actuation was executed only. Thus, the knee actuator and the hip actuator were assessed with a T12 subject and with subjects for T5, T8, T11, and T12 respectively. The motions of the gaits, assisted by the linear actuators, were measured by a Vicon 370 system, and the general gait parameters and compensatory motions were evaluated. Results demonstrated that (a) all subjects could walk without falling, assisted either by the knee or the hip actuator; (b) both the knee and hip joint actuator increased the gait speed and the step length; (c) the knee flexion produced by the orthosis improved the dynamic cosmesis of walking; and (d) lateral compensatory motions as well as vertical ones tended to decrease when the hip joint was assisted, which could contribute to a reduction in walking effort.     

Positive chronotropic actions of parathyroid hormone and parathyroid hormone-related peptide are associated with increases in the current, I(f), and the slope of the pacemaker potential

BACKGROUND: The classic calciotropic hormone parathyroid hormone (PTH) and its paracrine factor parathyroid hormone-related protein (PTHrP) both increase heart rate. METHODS AND RESULTS: We used standard electrophysiological techniques to study the effects of PTH and PTHrP on isolated rabbit sinus node, isolated canine Purkinje fibers, and disaggregated rabbit sinus node myocytes. Sinus node maximum diastolic potential, activation voltage, and amplitude were unchanged by PTH or PTHrP (P>.05). However, the slope of phase 4 and the automatic rate were increased at PTH and PTHrP > or = 10 nmol/L (P<.05). Comparable results were seen in canine Purkinje fibers. We then used the perforated-patch technique to study the I(f) pacemaker current in sinus node. PTH 12.5 nmol/L and PTHrP 12.5 to 18 nmol/L increased I(f) at -65 mV by 68+/-41% (n=5) and 69+/-50% (n=5), respectively. Actions of both agents were reversible. The increase in I(f) appeared to result from a change in maximal conductance and not a shift in the voltage dependence of activation. CONCLUSIONS: These observations provide, for the first time, direct electrophysiological support for the chronotropic actions of PTH and PTHrP. They suggest that classic hormones and paracrine factors can have multiple functions and that in the case of PTH and PTHrP, a newly recognized action is to alter automaticity directly.     

Effect of annealing conditions on the uniformity of undoped Semi-Insulating InP

Recently, it was found that undoped semi-insulating InP can be obtained by highpressure annealing of high purity materials. The reproducibility and the uniformity was, however, not satisfactory. In the present work, we found that not only Fe concentrations but also Cr and Ni concentrations in annealed wafers were slightly increased during annealing. Since it seems that the origin of the contamination was due to the vapor source of red phosphorus, conductive InP with a trace amount of Fe was annealed under low phosphorus vapor pressure in order to reduce the contamination. By preventing the contamination of Cr and Ni, preparation of semi-insulating InP became highly reproducible. The minimum Fe concentration for realizing semi-insulating InP was found to be 1 x 10¹⁵cm⁻³. It was also found that the better resistivity uniformity can be obtained at higher annealing temperatures.     

Disturbance rejection with information constraints: Performance limitations of a scalar system for bounded and Gaussian disturbances

This paper derives performance limitations for disturbance rejection of scalar systems under information constraints subject to either bounded or Gaussian disturbances. Two kinds of disturbance are treated in a unified manner, using appropriate entropies and distortions. It is shown that the achievable performance cannot be improved even if the maximum information constraint is relaxed to an average information constraint. Another observation is that, while the information constraints are weaker than bit-rate or signal-to-noise ratio constraints on the communication channel, the same performance levels are achieved by the best encoder and decoder for disturbance rejection with the information constraints.     

Chain stiffness and chain conformation of poly(α-methylene-γ-butyrolactone) in dilute solutions

The chain stiffness and local chain conformation of atactic poly(α-methylene-γ-butyrolactone) (PMBL), which is a side chain cyclic structural analog of poly(methyl methacrylate) (PMMA), with a weight-average molecular weight (M_w) ranging from 2.8 × 10³ to 2.6 × 10⁶ in N,N-dimethylformamide (DMF) and γ-butyrolactone (GBL) were characterized by size exclusion chromatography with a multi-angle light-scattering detector (SEC-MALS) and synchrotron radiation small-angle X-ray scattering (SAXS). Based on the Kratky-Porod worm-like chain model, the scattering functions and the M_w dependence of z-average root-mean-square radius of gyration <S²>_z^1/2 yielded the Kuhn segment lengths λ⁻¹, the diameter of the PMBL chains d, and the excluded-volume strengths in DMF and GBL. The local conformation of atactic PMBL in DMF and GBL were slightly larger than those of atactic PMMA, due to the presence of the conformationally rigid lactone ring structure.     

Developmental ability of cloned embryos from neural stem cells

The success rate is generally higher when cloning mice from embryonic stem (ES) cell nuclei than from somatic cell nuclei, suggesting that the embryonic nature or the undifferentiated state of the donor cell increases cloning efficiency. We assessed the developmental ability of cloned embryos derived from cultured neural stem cell (NSC) nuclei and compared the success rate with that of embryos cloned from other donor cells such as differentiated NSCs, cumulus cells, Sertoli cells and ES cells in the mouse. The transfer of two-cell cloned embryos derived from cultured NSC nuclei into surrogate mothers produced five live cloned mice. However, the success rate (0.5%) was higher in embryos cloned from cultured NSC nuclei than from differentiated NSCs (0%), but lower than that obtained by cloning mice from other cell nuclei (2.2-3.5%). Although the in vitro developmental potential to the two-cell stage of the cloned embryos derived from NSC nuclei (73%) was similar to that of the cloned embryos derived from other somatic cell nuclei (e.g., 85% in Sertoli cells and 75% in cumulus cells), the developmental rate to the morula-blastocyst stage was only 7%. This rate is remarkably lower than that produced from other somatic cells (e.g., 50% in Sertoli cells and 54% in cumulus cells). These results indicate that the undifferentiated state of neural cells does not enhance the cloning efficiency in mice and that the arrest point for in vitro development of cloned embryos depends on the donor cell type.     

Unsteady behavior of leading-edge vortex and diffuser stall in a centrifugal compressor with vaned diffuser

The characteristics of a rotating stall of an impeller and diffuser and the evolution of a vortex generated at the diffuser leading-edge (i.e., the leading-edge vortex (LEV)) in a centrifugal compressor were investigated by experiments and numerical analysis. The results of the experiments revealed that both the impeller and diffuser rotating stalls occurred at 55 and 25 Hz during off-design flow operation. For both, stall cells existed only on the shroud side of the flow passages, which is very close to the source location of the LEV. According to the CFD results, the LEV is made up of multiple vortices. The LEV is a combination of a separated vortex near the leading- edge and a longitudinal vortex generated by the extended tip-leakage flow from the impeller. Therefore, the LEV is generated by the accumulation of vorticity caused by the velocity gradient of the impeller discharge flow. In partial-flow operation, the spanwise extent and the position of the LEV origin are temporarily transmuted. The LEV develops with a drop in the velocity in the diffuser passage and forms a significant blockage within the diffuser passage. Therefore, the LEV may be regarded as being one of the causes of a diffuser stall in a centrifugal compressor.     

Acceleration of the redox kinetics of VO2+/VO2 + and V3+/V2+ couples on carbon paper

The redox kinetics of VO²⁺/VO₂ ⁺ and V³⁺/V²⁺ couples on a carbon paper (CP, HCP030 N, Shanghai Hesen, Ltd., China) electrode were investigated in terms of their standard rate constant (k ₀) and reaction mechanism. The values determined for k ₀ for VO²⁺ ?? VO₂ ⁺ and V³⁺ ?? V²⁺ using the CP electrode are 1.0 × 10^?3 and 1.1 × 10^?3 cm s^?1, respectively. The value of k ₀ increases by one or two order(s) of magnitude compared with values obtained using electrodes composed of pyrolytic graphite and glassy carbon. The acceleration of the redox kinetics of vanadium ions is a result of the large surface area of the CP electrode. An inner-sphere mechanism for the reaction on the surface of the electrode is proposed. The kinetic features of vanadium redox reactions on the CP electrode reveal that CP is suitable for use as the electrodes in vanadium redox-flow batteries.