Effects of crystallographic misorientation on power loss in

The effects of the inclination angle β of the [001] axis out of the sheet plane on the thickness dependence of the power losses in     

Extensions of polyacrylic acid ammonium salts in the adsorption layer to fluidize alumina slurries

An average shell volume occupied in the adsorption layer on alumina by a polyacrylic acid ammonium salts molecule (PAA) defined as the average area occupied by an adsorbed PAA on alumina multiplied by the average thickness of the water layer at the limit of thickening, has been calculated from the adsorbed amount of PAA and from the flow points of alumina in the presence of PAA of different molecular weights. A steric effect of the PAA dispersant on the dispersion of alumina resulted in a flow with no yield stress. This was due to the change of the extension of PAA in the adsorption shell from a sphere to an ellipsoid with a long axis which exceeded the effective distance that the van der Waals attraction force reaches at a molecular weight for the PAA of between 10 000–20 000.     

New protection method for HVDC lines including cables

For the third project of the Hokkaido-Honshu HVDC Link in Japan, called the HVDC Link III project (rated at 250 kVDC-1200 A-300 MW), we developed an HVDC transmission line protection method based on a new working principle that allows high-speed and highly sensitive detection of faults, enhancing reliability in the supply of electric power. In general, increasing the sensitivity of relays will lead to an increased likelihood of undesired operation whereas lowering the sensitivity will impair the responsiveness of the relays. Our proposed method meets these apparently incompatible requirements very well. Basically classified as a differential scheme, the HVDC transmission line protection method compensates for a charging and discharging current that flows through the line-to-ground capacitance at times of voltage variations caused by a line fault or by the operation of DC power systems. The developed protection method is also characterized in that it uses current changes induced by voltage variations to restrain the operation of a relay. This configuration has made the proposed method far superior in responsiveness and sensitivity to the conventional protection method. A simulation using an EMTP (Electro-Magnetic Transients Program) was conducted on this method. Developed relay equipment embodying the new protection method was subjected to various verification tests, where this equipment was connected to a power system simulator, before being delivered to the HVDC Link III facility     

Expression of V642 APP mutant causes cellular apoptosis as Alzheimer trait-linked phenotype

APP is a transmembrane precursor of beta-amyloid. In dominantly inherited familial Alzheimer's disease (FAD), point mutations V6421, V642F and V642G have been discovered in APP695. Here we show that expression of these mutants (FAD-APPs) causes a clone of COS cells to undergo apoptosis associated with DNA fragmentation. Apoptosis by the three FAD-APPs was the highest among all possible V642 mutants; normal APP695 had no effect on apoptosis, suggesting that apoptosis by APP mutants in this system is phenotypically linked to the FAD trait. FAD-APP-induced apoptosis was sensitive to bcl-2 and most probably mediated by heteromeric G proteins. This study presents a model system allowing analysis of the mechanism for FAD-APP-induced cytotoxicity.     

Hot-carrier effects in scaled MOS devices

A universal guideline and state-of-the-art hot-carrier effects in scaled MOSFETs are reviewed and discussed from the viewpoints of 1) DC and AC hot-carrier effects, 2) hot-carrier detrapping phenomena, 3) mechanical stress effects on hot-carrier phenomena, and 4) hot-carrier resistant device structures.In the deep-submicron region, the hot-carrier applicable voltage is less than 3 V, so AC hot-carrier effects from the dynamic operation of actual circuits should be taken into account. Despite much experimentation and analysis, there is still no universally accepted theory that explain the AC degradation mechanism. This is because the noise caused by the wiring inductance in ULSI circuits and in measurement systems screens the intrinsic AC hot-carrier effects.Here, AC hot-carrier degradation enhanced by gate pulse-induced-noise is analyzed experimentally and theoretically. After eliminating the noise problem, it is found that AC hot-carrier degradation in LDD (Lightly doped drain) and GOLD (gate-drain overlapped device) structures can be estimated based on DC degradation in terms of the effective stress time which takes the duty ratio into account. In addition, it is found that the noise is negligible when the wiring inductance is smaller that 80 nH (250 mω), which is important for future circuit design.Furthermore, hot-carrier detrapping effects, especially in p-channel MOS devices, and hot-carrier phenomena under mechanical stress are investigated experimentally to better understand the underlying hot-carrier physics. Finally, future hot-carrier resistant device structures are discussed.     

Integrated optical devices of InGaAsP/InP heterojunction phototransistor and inner stripe light-emitting diode

New integrated optical devices combining an InGaAsP/InP HPT and an inner-stripe LED are proposed and their fabrication processes are described. The device functions of light amplification, optical bistability, and optical switching are demonstrated in the 1-μm wavelength region.     

Hydroliquefaction of low-sulfur coals using iron carbonyl complexes—Sulfur as catalysts

Hydroliquefaction of low-sulfur Australian coals (Wandoan and Yallourn) was studied using iron carbonyl complexes as catalyst. The addition of Fe(CO)₅ (2.8 wt% Fe of coal) increased coal conversion from 48.6 to 85.2% for Wandoan coal, and from 36.7 to 69.7% for Yallourn coal in 1-methylnaphthalene at 425°C under an initial hydrogen pressure of 50 kg cm^?2. When molecular sulfur was added to iron carbonyls (Fe(CO)₅, Fe₂(CO)₉ and Fe₃(CO)₁₂), higher coal converions ( > 92%) and higher oil yields (>46%) were obtained, along with an increase in the amount of hydrogen transferred to coal from the gas phase (0.2 to 2.8%, d.a.f. coal basis). In the liquefaction studies using a hydrogen donor solvent, tetralin, Fe(CO)₅S catalyst increased the amount of hydrogen absorbed from the gaseous phase and decreased the amount of naphthalene dehydrogenated from tetralin. The direct hydrogen transfer reaction from molecular hydrogen to coal fragment radicals seems to be a major reaction pathway. Organic sulfur compounds, dimethyldisulfide and benzothiophene, and inorganic FeS₂ and NiS were found to be good sulfur sources to Fe(CO)₅. From X-ray diffraction analyses of liquefaction residues, it is concluded that Fe(CO)₅ was converted into pyrrhotite (Fe_1?xS) when sulfur was present, but into Fe₃O₄ in the absence of sulfur.