Ureteroscopic management of lower ureteral stones: two years'' experience

1. This study was to determine the effects of heat load early in life on thermoregulatory responses and whole blood viscosity of broilers during a subsequent exposure to high environmental temperature later in life. 2. The birds, which had been subjected to exposure to 38 degrees C for 24 h at 5-d-old, served as prior exposure group (group A). Both group A and control group B were exposed to 33 degrees C for 3 h when near marketable weight. 3. On exposure to 33 degrees C, although there were no significant differences in the increases in heat production (HP) between the two groups, abdominal temperature (Ta), temperature of external ear tract (Tee), shank skin temperature (Tss), standing-lying frequency and lying time were lower in group A than in group B. Heart rate (HR) and comb surface temperature (Tcs) did not differ but increased in both groups during exposure to 33 degrees C. Respiration rate (RR) was greater in group A. 4. Blood viscosity decreased markedly in both groups after exposure to 33 degrees C; the decrease was greater in group A. 5. These results suggest that early exposure may promote broilers' ability to cope with the subsequent heat load by altering thermoregulatory physiological responses and behavioural patterns, resulting in an alleviation of heat stress.     

Down syndrome associated with systemic lupus erythematosus: a mere coincidence or a significant association?

An 8-year-old male, who had Down syndrome associated with systemic lupus erythematosus (SLE), is described. He also had a partial complement 4 deficiency. This case is a reminder that the physician should be aware of the possibility of an immune defect in a male presenting with SLE at a young age. The question of whether the association of Down syndrome with SLE is coincidental or whether there is a predilection for autoimmune disorders in Down syndrome is discussed.     

On the Capacity and Energy Efficiency of Training-Based Transmissions Over Fading Channels

In this paper, the capacity and energy efficiency of training-based communication schemes employed for transmission over a priori unknown Rayleigh block-fading channels are studied. Initially, the case in which the product of the estimate error and transmitted signal is assumed to be Gaussian noise is considered. In this case, it is shown that bit energy requirements grow without bound as the signal-to-noise ratio (SNR) goes to zero, and the minimum bit energy is achieved at a nonzero SNR value below which one should not operate. The effect of the block length on both the minimum bit energy and the SNR value at which the minimum is achieved is investigated. Flash training and transmission schemes are analyzed and shown to improve the energy efficiency in the low-SNR regime. In the second part of this paper, the capacity and energy efficiency of training-based schemes are investigated when the channel input vector in each coherence block is subject to peak power constraints. The capacity-achieving input structure is characterized and the magnitude distribution of the optimal input is shown to be discrete with a finite number of mass points. The capacity, bit energy requirements, and optimal resource allocation strategies are obtained through numerical analysis. The improvements in energy efficiency when on-off keying (OOK) with fixed peak power and vanishing duty cycle is employed are studied.     

Tunable Fano-Resonant Metasurfaces on a Disposable Plastic-Template for Multimodal and Multiplex Biosensing

Metasurfaces are engineered nanostructured interfaces that extend the photonic behavior of natural materials, and they spur many breakthroughs in multiple fields, including quantum optics, optoelectronics, and biosensing. Recent advances in metasurface nanofabrication enable precise manipulation of light–matter interactions at subwavelength scales. However, current fabrication methods are costly and time-consuming and have a small active area with low reproducibility due to limitations in lithography, where sensing nanosized rare biotargets requires a wide active surface area for efficient binding and detection. Here, a plastic-templated tunable metasurface with a large active area and periodic metal–dielectric layers to excite plasmonic Fano resonance transitions providing multimodal and multiplex sensing of small biotargets, such as proteins and viruses, is introduced. The tunable Fano resonance feature of the metasurface is enabled via chemical etching steps to manage nanoperiodicity of the plastic template decorated with plasmonic layers and surrounding dielectric medium. This metasurface integrated with microfluidics further enhances the light–matter interactions over a wide sensing area, extending data collection from 3D to 4D by tracking real-time biomolecular binding events. Overall, this work resolves cost- and complexity-related large-scale fabrication challenges and improves multilayer sensitivity of detection in biosensing applications.     

Characterization of Double-Junction GaAsP Two-Color LED Structure

The structural, optical, electrical and electrical–optical properties of a double-junction GaAsP light-emitting diode (LED) structure grown on a GaP (100) substrate by using a molecular beam epitaxy technique were investigated. The p–n junction layers of GaAs_1?xP_x and GaAs_1?yP_y, which form the double-junction LED structure, were grown with two different P/As ratios. High-resolution x-ray diffraction (HRXRD), photoluminescence (PL), and current–voltage (I–V) measurements were used to investigate the structural, optical and electrical properties of the sample. Alloy composition values (x, y) and some crystal structure parameters were determined using HRXRD measurements. The phosphorus compositions of the first and second junctions were found to be 63.120% and 82.040%, respectively. Using PL emission peak positions at room temperature, the band gap energies (E_g) of the first and second junctions were found to be 1.867 eV and 2.098 eV, respectively. In addition, the alloy compositions were calculated by Vegard’s law using PL measurements. The turn-on voltage (V_on) and series resistance (R_s) of the device were obtained from the I–V measurements to be 4.548 V and 119 Ω, respectively. It was observed that the LED device emitted in the red (664.020 nm) and yellow (591.325 nm) color regions.