Determining stress intensity factors of composites using crack opening displacement

The main purpose of this paper is to find the mixed-mode stress intensity factors of composite materials using the crack opening displacement (COD). First, a series solution of the composite material with a crack was used to evaluate COD values. Then, the least-squares method was used to calculate mixed-mode stress intensity factors. This algorithm can be applied to any method that generates or measures COD values. The major advantage of this method is that COD values very near the crack tip are not necessary. Both finite element simulations and laboratory experiments were applied to validate this least-squares method with acceptable accuracy if the even terms of the series solution are removed.     

Biaxiale Ermüdung reibrührgeschweißter Strukturelemente

Biaxial fatigue of friction stir welded stiffened panels Within the framework of the European WelAir project, cruciform specimens made from stiffening FSW overlap joints were fatigued in the DLR biaxial test rig. To resemble the loading situation of pressurized fuselage structures, proportional loading without any phase shift, but with different load ratios λ between the loading components in both directions was applied.Natural crack initiation and subsequent crack growth were governed by the stiffness gradient caused by introducing the stringer. Cracks initiated and propagated at run‐in and run‐out locations in a direction perpendicular to the weld seam. The shortest fatigue life was observed for uniaxial loading in welding direction (λ = 0). An additional stress component perpendicular to the joint line (λ > 0) resulted in a higher number of cycles to failure. Similar to single stringer panels, increasing the load ratio also increased the number of cycles to failure for FSW clip‐stringer structural members, but additionally gives a different location of the fatal crack.     

ESR Refining Potential for Titanium Alloys using a CaF2‐based Active Slag

Since the end of the Cold War and due to the needs to produce titanium more cost‐efficient and thus more attractive for its civilian use, the electroslag remelting (ESR) process has become an increasingly important topic of international research programmes, because titanium and titanium aluminides can be chemically refined by ESR in some degree. Using ESR, titanium turnings from machining steps and scrap from foundries can be remelted, refined and provided as secondary titanium for the market at relatively favourable prices. This article investigates the removability of the main impurities out of titanium and titanium‐aluminium alloys by electroslag remelting using the active slag system CaF₂‐Ca‐(CaO). Thermochemical and kinetic aspects of the ESR process are considered.     

High-yield synthesis of single-crystalline 3C-SiC nanowires by a facile autoclave route

Single-crystalline 3C-SiC nanowires have been synthesized in large scale through a one-step autoclave route by the reaction of SiCl₄, (C₅H₅)₂Fe and metallic Na at 500 °C. Electron microscopy investigations show that the nanowires have typical diameters of 15-50 nm, lengths up to several tens of micrometers and grow along the [111] direction. The possible growth mechanism of the nanowires is discussed.     

Strategies to increase CdTe solar-cell voltage

There is a significant difference in performance between today's highest efficiency of CdTe solar cells and single-crystal cells of comparable band gap. The largest contribution to this difference is the voltage, where the values for the best CdTe cells are about 230 mV below the best GaAs cells when an appropriate adjustment is made for band gap. CdTe voltage and fill-factor are currently compromised by low recombination lifetime (near 1 ns), low hole density (near 10¹⁴ cm^− 3), and in some cases an excessive back-contact barrier. Numerical simulation is used to evaluate how combinations of lifetime, carrier density, back electron reflection, and interfacial properties affect voltage and cell performance. Two different strategies for improving voltage and performance are explored.