Outdoor NOx and stroke mortality: adjusting for small area level smoking prevalence using a Bayesian approach

There is increasing evidence, mainly from daily time series studies, linking air pollution and stroke. Small area level geographical correlation studies offer another means of examining the air pollution-stroke association. Populations within small areas may be more homogeneous than those within larger areal units, and census-based socioeconomic information may be available to adjust for confounding effects. Data on smoking from health surveys may be incorporated in spatial analyses to adjust for potential confounding effects but may be sparse at the small area level. Smoothing, using data from neighbouring areas, may be used to increase the precision of smoking prevalence estimates for small areas. We examined the effect of modelled outdoor NOx levels on stroke mortality using a Bayesian hierarchical spatial model to incorporate random effects, in order to allow for unmeasured confounders and to acknowledge sampling error in the estimation of smoking prevalence. We observed an association between NOx and stroke mortality after taking into account random effects at the small area level. We found no association between smoking prevalence and stroke mortality at the small area level after modelling took into account imprecision in estimating smoking prevalence. The approach we used to incorporate smoking as a covariate in a single large model is conceptually sound, though it made little difference to the substantive results.     

Contribution to flashover modelling: Development of a validated numerical model for ignition of non-contiguous wood samples

A computational model of flashover is presented that closely follows the experimental setup at CNRS-ENSMA-Poitiers. A propane burner with thermal power of 55 kW is used as a primary source of fire and square beech wood samples (30 mm×30 mm×5 mm) as fire spread targets. The computational model describes the wood pyrolysis with a progress variable. Using the conservation of heat fluxes at the solid–gas interface, the thermal diffusion in the wood samples is coupled with the convective and the radiative heat transfer in the ambient gas phase. The incoming heat flux at the upper surface of the wood samples reaches values between 20 and 30 kW/m². With the ignition and subsequent combustion of the pyrolysis volatiles, the heat flux increases by approx. 12 kW/m². The results show that the ignition of the wood samples is triggered at an approx. surface temperature of 650 K. Due to large local variations in incident heat flux, significant differences in the ignition times of the wood samples are observed. The comparison of the calculated and the experimentally measured temperature shows a good agreement for the first wood sample and the model predicts the ignition time very well. But for the second and the third wood samples the model overpredicts the temperature, which leads to a premature ignition of these wood samples.     

An innovative Geonail system for soft ground stabilization

Soil nails are widely used in stabilizing and retaining the ground during constructions, with the high yield steel bar the most commonly used soil nail material at present. The classical method of soil nail construction is, however, not effective in soft clay as it is difficult to establish a good bond strength and global soil improvement. An innovative soil nail installation method has been developed for the Airport link in Australia, which combines the applications of fracture grouting techniques and composite GFRP soil nails to stabilize the ground soil as well as to compensate for the settlement of ground. Extensive laboratory and in-situ tests have been carried out to verify the mass soil properties methods and the performance of the Geonail system for the local and global stabilization of the soft ground.     

Demonstration of a room temperature 2.48-2.75 THz coherent spectroscopy source

We report the first demonstration of a continuous wave coherent source covering 2.48-2.75 THz, with greater than 10% instantaneous tuning bandwidth and having 1-14 μW of output power at room temperature. This source is based on a 91.8-101.8 GHz synthesizer followed by a power amplifier and three cascaded frequency triplers. It demonstrates for the first time that purely electronic solid-state sources can generate a useful amount of power in a region of the electromagnetic spectrum where lasers (solid state or gas) were previously the only available coherent sources. The bandwidth, agility, and operability of this THz source have enabled wideband, high resolution spectroscopic measurements of water, methanol, and carbon monoxide with a resolution and signal-to-noise ratio unmatched by any other existing system, providing new insight in the physics of these molecules. Furthermore, the power and optical beam quality are high enough to observe the Lamb-dip effect in water. The source frequency has an absolute accuracy better than 1 part in 10(12) and the spectrometer achieves sub-Doppler frequency resolution better than 1 part in 10(8). The harmonic purity is better than 25 dB. This source can serve as a coherent signal for absorption spectroscopy, a local oscillator for a variety of heterodyne systems and can be used as a method for precision control of more powerful but much less frequency agile quantum mechanical terahertz sources.     

Development of Short-Range Repulsive Potentials in Aqueous, Silicon Nitride Slurries

The properties of aqueous, dispersed, silicon nitride slurries, with an isoelectric point of pH 5.5, can be changed with additions of NH₄CI. At pH 10 the effect of adding NH₄Cl is similar to that suggested by DLVO theory; namely, for concentrations .0.5 M , the viscosity vs shear rate behavior, the elastic modulus, and the relative packing density are identical to those for slurries prepared at the isoelectric point. On the other hand, the effect of salt on dispersed slurries prepared at pH 2 differs from the behavior implied by classic DLVO theory; i.e., measurement of the same properties showed that the attractive interparticle potential was much weaker relative to that produced at the isoelectric point. As previously reported for alumina slurries, the results suggest that a short-range, repulsive interparticle potential is developed in salt-added slurries prepared at pH 2 which prevents attractive particles in the slurry from touching and aids particle packing. The same short-range potential apparently is not developed with salt additions at pH 10. The difference between silicon nitride and alumina slurries is apparent when the slurries are consolidated. Bodies consolidated from any silicon nitride slurry are elastic (i.e., they fracture before they flow) unlike salt-added alumina slur-ries, which are plastic.     

Degradation of trichloronitromethane by iron water main corrosion products

Halogenated disinfection byproducts (DBPs) may undergo reduction reactions at the corroded pipe wall in drinking water distribution systems consisting of cast or ductile iron pipe. Iron pipe corrosion products were obtained from several locations within two drinking water distribution systems. Crystalline-phase composition of freeze-dried corrosion solids was analyzed using X-ray diffraction, and ferrous and ferric iron contents were determined via multiple extraction methods. Batch experiments demonstrated that trichloronitromethane (TCNM), a non-regulated DBP, is rapidly reduced in the presence of pipe corrosion solids and that dissolved oxygen (DO) slows the reaction. The water-soluble iron content of the pipe solids is the best predictor of TCNM reaction rate constant. These results indicate that highly reactive DBPs that are able to compete with oxygen and residual disinfectant for ferrous iron may be attenuated via abiotic reduction in drinking water distribution systems.     

Bright field and dark field STEM‐IN‐SEM imaging of polymer systems

The microstructural analysis of polymer systems (e.g., polymers and their composites) has largely been conducted by transmission electron microscopy (TEM). However, hard materials (e.g., metals and ceramics) are better suited for TEM imaging because such materials can withstand the high energy electron beam generated in TEM instruments. Recently, scanning TEM in scanning electron microscopy (STEM‐IN‐SEM) has emerged as a viable alternative to TEM imaging of polymer systems. STEM‐IN‐SEM uses a versatile and user‐friendly SEM instrument for examining the microstructure of polymer systems. In this study, we outline our method for STEM‐IN‐SEM imaging and apply it to the imaging of various commercial and model polymer systems. Imaging results are evaluated on the basis of measured signal intensity, which compare favorably to microstructural analysis using more costly TEM and STEM instruments. Furthermore, these comparable signal intensities are achieved through STEM‐IN‐SEM imaging with specimens that are three times thicker than those required for conventional TEM imaging. In this respect, as compared to TEM, STEM‐IN‐SEM offers faster specimen preparation times coupled with easier usability and lower maintenance costs, which are all attractive attributes for efficient quality control measures in industry. © 2014 Wiley Periodicals, Inc. J. Appl. Polym. Sci. 2014 , 131, 40851.     

Chirp-pulse-compression three-dimensional lidar imager with fiber optics

A coherent three-dimensional (angle-angle-range) lidar imager using a master-oscillator-power-amplifier concept and operating at a wavelength of 1.5 microm with chirp-pulse compression is described. A fiber-optic delay line in the local oscillator path enables a single continuous-wave semiconductor laser source with a modulated drive waveform to generate both the constant-frequency local oscillator and the frequency chirp. A portion of this chirp is gated out and amplified by a two-stage fiber amplifier. The digitized return signal was compressed by cross correlating it with a sample of the outgoing pulse. In this way a 350-ns, 10-microJ pulse with a 250-MHz frequency sweep is compressed to a width of approximately 8 ns. With a 25-mm output aperture, the lidar has been used to produce three-dimensional images of hard targets out to a range of approximately 2 km with near-diffraction-limited angular resolution and submeter range resolution.     

Computed tomography, ultrasound and lymphography in the diagnosis of malignant lymphoma

Lymphographic findings were compared with the results at histopathology in 42 laparotomized patients with malignant lymphoma. Of 12 patients with lymphographically suggested lesions in normal-sized lymph nodes, only one had pathologic changes at histologic examination. Computed tomography gave a better idea of the extent of the disease than lymphography. Moreover, CT had an equal diagnostic accuracy as lymphography for demonstrating enlarged para-aortic lymph nodes. CT should therefore be able to replace lymphography in examination of malignant lymphoma. Ultrasound had the same diagnostic accuracy as CT regarding the upper and middle abdomen but not in the lower abdomen. Ultrasound is of special value in thin patients and when guided needle biopsy is required.     

Efficient gene transfer to human squamous cell carcinomas by the herpes simplex virus type 1 amplicon vector

We determined the diagnostic value of the EEG in young children with Angelman syndrome (AS) and Rett syndrome (RS). EEGs, recorded before 5 years of age, of 10 patients with AS, 10 with RS and 10 with mental retardation of other origin were studied blindly by two examiners for the presence of the following items: (A) 4-6 Hz rhythmic activity of over 200 microV; (B) 2-3 Hz frontal activity of 200-500 microV; (C) posterior spikes; (D) triphasic frontal waves; (E) central and/or centro-temporal spike-wave complexes; and (F) other epileptic discharges. Based on these items the EEGs were scored as AS (A-D); RS (E-F); or other. Examiners never made a mistake between AS and RS. One examiner labeled 6 of 10 AS cases correctly, the other 5; 4 (5) were characterized as 'other.' In RS cases 5 were labeled as 'other' by the first examiner and 3 by the second one. We conclude that EEG patterns of AS and RS are sufficiently different to help differentiate between AS and RS at a young age, which has a bearing on genetic counseling.