Numerical Study of Self-Complementary Antenna Characteristics on Substrate Lenses at Terahertz Frequency

This paper presents a numerical study of self-complementary antennas on substrate lenses made of high-permittivity dielectric material. Bowtie, logarithmically periodic, and logarithmic spiral antennas with the same outer and inner dimensions were selected for study, and their overall performances were compared in the terahertz band at frequencies up to 5.0?THz. The resonance and radiation characteristics of the three antennas were investigated in terms of input impedance, directivity, and radiation efficiency, using a full electromagnetic simulator. This study provides useful guidelines and partially solves the difficult problems of choosing the proper feed and optimizing the lens structure for a THz broadband integrated lens antenna.     

Different Directions of Switching of Chromium Oxide Thin Films

We have investigated the switching behavior of as-deposited CrO _x and post-annealed CrO _y films by use of a variety of electrodes (top electrode Ag, Ti; bottom electrode Pt, fluorine tin oxide (FTO)). Resistance switching is highly dependent on electrode material and post-annealing treatment. Among Pt devices, I–V hysteresis was observed for the Ag/CrO _x /Pt device only; no resistance switching was observed for Ag/CrO _y /Pt, Ti/CrO _x /Pt, and Ti/CrO _y /Pt devices. Among FTO devices, I–V hysteresis was observed for the Ag/CrO _x /FTO device whereas I–V hysteresis with the opposite switching direction was observed for Ag/CrO _y /FTO, Ti/CrO _x /FTO, and Ti/CrO _y /FTO devices. The direction of switching depends not only on electrode material but also on post-annealing treatment, which affects the density of grain boundaries. Thus, the density of grain boundaries determines the type of charge carrier involved in the switching process. For as-deposited CrO _x films with a high density of grain boundaries Ag filament paths mediated by electrochemical redox reaction were observed, irrespective of bottom electrode material (Pt or FTO). Post-annealed CrO _y films with a low density of grain boundaries suppressed electrochemical redox reaction in the Ag/CrO _y /Pt device but promoted short-range movement of O^2? ions through the bottom interface, resulting in resistance switching in the Ag/CrO _y /FTO device. Electrochemical redox reaction-controlled resistance switching occurred solely in oxides with a high density of grain boundaries or dislocations.     

On proportional fairness of uplink spectral efficiency in cell‐free massive MIMO systems

This paper is concerned with the proportional fairness (PF) of the spectral efficiency (SE) maximization of uplinks in a cell‐free (CF) massive multiple‐input multiple‐output (MIMO) system in which a large number of single‐antenna access points (APs) connected to a central processing unit (CPU) serve many single‐antenna users. To detect the user signals, the APs use matched filters based on the local channel state information while the CPU deploys receiver filters based on knowledge of channel statistics. We devise the maximization problem of the SE PF, which maximizes the sum of the logarithm of the achievable user rates, as a jointly nonconvex optimization problem of receiver filter coefficients and user power allocation subject to user power constraints. To handle the challenges associated with the nonconvexity of the formulated design problem, we develop an iterative algorithm by alternatively finding optimal filter coefficients at the CPU and transmit powers at the users. While the filter coefficient design is formulated as a generalized eigenvalue problem, the power allocation problem is addressed by a gradient projection (GP) approach. Simulation results show that the SE PF maximization not only offers approximately the achievable sum rates as compared to the sum‐rate maximization but also provides an improved trade‐off between the user rate fairness and the achievable sum rate.     

A 146-mm/sup 2/ 8-gb multi-level NAND flash memory with 70-nm CMOS technology

An 8-Gb multi-level NAND Flash memory with 4-level programmed cells has been developed successfully. The cost-effective small chip has been fabricated in 70-nm CMOS technology. To decrease the chip size, a one-sided pad arrangement with compacted core architecture and a block address expansion scheme without block redundancy replacement have been introduced. With these methods, the chip size has been reduced to 146 mm/sup 2/, which is 4.9% smaller than the conventional chip. In terms of performance, the program throughput reaches 6 MB/s at 4-KB page operation, which is significantly faster than previously reported and very competitive with binary Flash memories. This high performance has been achieved by the combination of the multi-level cell (MLC) programming with write caches and with the program voltage compensation technique for neighboring select transistors. The read throughput reaches 60 MB/s using 16I/O configuration.     

接触面陷阱密度对a-InSnZnO薄膜晶体管器件电气性能的影响研究

We reported the influence of interface trap density（Nt） on the electrical properties of amorphous InSnZnO based thin-film transistors,which were fabricated at different direct-current（DC） magnetron sputtering powers.The device with the smallest N_t of 5.68×10¹¹ cm^-2 and low resistivity of 1.21×10^-3Ω·cm exhibited a turn-on voltage(V_ON) of-3.60 V,a sub-threshold swing（S.S） of 0.16 V/dec and an on-off ratio(I_ON/I_OFF) of⁸ x 108.With increasing N_t,the V_ON,S.S and I_ON/I_OFF were suppressed to-9.40 V,0.24 V/dec and 2.59×10⁸,respectively.The V_TH shift under negative gate bias stress has also been estimated to investigate the electrical stability of the devices.The result showed that the reduction in N_t contributes to an improvement in the electrical properties and stability.     

Poly(arylene piperidinium) Hydroxide Ion Exchange Membranes: Synthesis,Alkaline Stability,and Conductivity

A series of poly(arylene piperidinium)s (PAPipQs) devoid of any alkali‐sensitive aryl ether bonds or benzylic sites are prepared and studied as anion exchange membranes (AEMs) for alkaline fuel cells. First, the excellent alkaline stability of the model compound 4,4‐diarylpiperidinium is confirmed. Medium molecular weight poly(arylene piperidine)s are then synthesized in polycondensations of N‐methyl‐4‐piperidone and either bi‐ or terphenyl via superelectrophilic activation in triflic acid. Film‐forming PAPipQs are subsequently prepared in Menshutkin reactions with methyl, butyl, hexyl, and octyl halides, respectively. AEMs based on poly(terphenyl dimethylpiperidinium) show the best performance with no structural degradation detectable by ¹H NMR spectroscopy after storage in 2 m aq. NaOH at 60 °C after 15 d, and a mere 5% ionic loss at 90 °C. In the fully hydrated state these AEMs reach an OH^? conductivity of 89 mS cm^?1 at 80 °C. The presence of longer pendant N‐alkyl chains (butyl to octyl) is found to significantly promote Hofmann ring‐opening elimination reactions and the degradation rate increases with increasing alkyl chain length. The results of the present study demonstrate that PAPipQs are efficiently prepared from readily available monomers and show excellent alkaline stability and OH^? conductivity when devoid of pendant N‐alkyl chains.     

Short packet communication in underlay cognitive network assisted by an intelligent reflecting surface

We propose short packet communication in an underlay cognitive radio network assisted by an intelligent reflecting surface (IRS) composed of multiple reconfigurable reflectors. This scheme, called the IRS protocol, operates in only one time slot (TS) using the IRS. The IRS adjusts its phases to give zero received cumulative phase at the secondary destination, thereby enhancing the end-to-end signal-to-noise ratio. The transmitting power of the secondary source is optimized to simultaneously satisfy the multi-interference constraints, hardware limitations, and performance improvement. Simulation and analysis results of the average block error rates (BLERs) show that the performance can be enhanced by installing more reconfigurable reflectors, increasing the blocklength, lowering the number of required primary receivers, or sending fewer information bits. Moreover, the proposed IRS protocol always outperforms underlay relaying protocols using two TSs for data transmission, and achieves the best average BLER at identical transmission distances between the secondary source and secondary destination. The theoretical analyses are confirmed by Monte Carlo simulations.