营尔凹陷下白垩统油气勘探应避开高压水层

营尔凹陷下白垩统(K₁₎存在下沟组和赤金堡组2套源岩，目前它们已到成熟阶段。凹陷东侧长沙岭构造在下白垩统下沟组和赤金堡组储层中也发现油藏，但主要分布在高压水层的顶部及下部，而高压水层段存在良好的储层，并未发现油气。文章根据高压水层段的储层荧光特征，通过储层烃与源岩的对比，分析了下白垩统高压水层对油气运移的影响。研究结果表明：高压水层段，储层荧光弱，储层抽提物特征既不同于赤赤金堡组源岩，也不同于下构组源岩，为就近捕获的产物；高压水层未发生大规模的油气运移，其形成时间早于油气运移的时间。建议该区油气勘探目标的选择应避开高压水层，选择凹陷附近的圈闭、高压水层以下的层位。     

扬声器系统时域结构系数的仿真

从扬声器系统的等效类比线路出发,得出了阻抗特性Z(jω)的表达形式及其曲线。采用全面最小二乘法识别扬声器系统的时域函数的全套系数,从而测出扬声器系统的低频特性参数。以计算机仿真技术为基础,通过MATLAB和EWB软件进行系统模拟分析仿真,得到扬声器系统的阶跃响应、阻抗曲线等特性。     

小水电工程径流计算的教训和建议

以2个小水电站径流计算为实例，分析移用降雨径流关系和参证站选择的教训，对改进小水电站径流计算方法提出了建议。表4个。     

如何控制堤防施工质量

在近几年堤防建设过程中,通过实践,总结出控制堤防施工质量的经验,以及堤防建设过程中土料质量控制和堤身碾压过程常见的质量事故及处理方法。     

工作流技术及其应用研究

文章介绍了工作流技术及其发展历史,对工作流的系统模型进行了详细分析,探讨了工作流技术在企业管理信息系统中的实际应用。     

基于混合智能的多Agent个性化信息推荐

在基于Agent的个性化网页推荐中，目前主要有两种过滤方法：基于内容的过滤和基于多Agent合作的过滤。在分析了单独使用这两种方法存在的不足之后，提出了基于改进蚁群算法的聚类分析建立用户模型的算法，并给出了结合两种方法优点的用户模型主动学习算法，最后给出了个性化信息推荐模型及相关算法。     

Laterally coupled buried heterostructure high-Q ring resonators

All-buried InP-InGaAsP ring resonators laterally coupled to bus waveguides are demonstrated. The buried configurations offer a lower built-in refractive index step along the resonator periphery, which affords enhanced optical coupling coefficients between the waveguides and reduced scattering losses caused by the resonator sidewall imperfections. Very low optical intensity attenuations of 0.4 cm/sup -1/ and coupling-limited quality factors of greater than 10/sup 5/ are observed from 200-/spl mu/m-radii ring resonators. The measured spectral linewidth is as narrow as 0.0145 nm.     

A decision support system for interactive decision making - Part II: analysis and output interpretation

For pt.I see ibid., p.42-55 (2003). The development of a comprehensive decision support system, GMCR II, for the systematic study of real-world interactive decision problems is presented. The companion paper (Part I), discusses how GMCR II elicits, stores, and manages conflict models; here (Part II), the focus is on GMCR IIs analysis and output interpretation subsystems. Specifically, this paper describes the powerful and efficient analysis engine contained in GMCR II, its informative output presentation and interpretation facilities, and a number of follow-up analyses. Furthermore, an illustrative case study is used to demonstrate how GMCR II can be conveniently applied in practice.     

Iterative detection/decoding for two-track partial response channels

In this letter, we investigate the iterative detection/decoding algorithms for two-track partial response channels. We first describe the iterative algorithm as an iterative message-passing/processing algorithm over a high-level normal graph and then propose two trellis-based detection algorithms. The natural one is based on a joint trellis, which can be implemented for low-order channels. For moderate-order channels, we propose a separated detection, which is based on two single-track trellises. Compared with the joint detection, the separated detection is simpler in most cases. Simulation results show that, for two-track EPR4 channels with minor intertrack interferences, the separated detection causes only marginal degradation in performance.     

新型的芯片间互连用CMOS/BiCMOS驱动器

从改善不同类型 IC芯片之间的电平匹配和驱动能力出发 ,设计了几例芯片间接口 (互连 )用 CMOS/Bi CMOS驱动电路 ,并提出了采用 0 .5 μm Bi CMOS工艺 ,制备所设计驱动器的技术要点和元器件参数。实验结果表明所设计驱动器既具有双极型电路快速、大电流驱动能力的特点 ,又具备 CMOS电路低压、低功耗的长处 ,因而它们特别适用于低电源电压、低功耗高速数字通信电路和信息处理系统。