Effects of error variation in means of measurement on reliability parameters in engineering-system monitoring

A method is given for calculating the monitoring reliability parameters (MRP) for an engineering system with allowance for the drift in the measurement error of the means of measurement (MM). The approach is based on introducing a biased MM error distribution into the traditional formulas for the conditional probabilities of spurious and unobserved failure. The bias at the center of the distribution is determined by the systematic error at the given instant. An example is given to illustrate the performance in MRP calculation.Translated from Izmeritel'naya Tekhnika, No. 1, pp. 12–13, January, 1994.     

Suppression control method for torque vibration of three-phase HB-type stepping motor utilizing feedforward control

This paper proposes a method to reduce the vibration of the three-phase HB-type stepping motor with cogging torque by the feedforward compensation control. The compensation signal to suppress the vibration of the motor frame is obtained by the repetitive controller installing an online Fourier transformer and utilizing an acceleration sensor attached to the motor frame or an acoustic sensor such as a microphone placed close to the frame. The sensor is used only for the acquisition of the feedforward compensation data. The feedforward compensation signal at an arbitrary operating point is derived from the amplitude and phase data of the frequency components and the operating point data. Compensation data obtained by the repetitive controller is applied to the operating point changed by reference frequency and load condition in steady state. The compensation signal for the new operating point will be generated from compensation data utilizing polynomial equation approximation and linear interpolation method. The effectiveness of this proposed method is confirmed by the experimental results.     

High performance of silicided silicon-sidewall source and drain (S4D) structure

A silicided silicon-sidewall source and drain (S⁴D) structure is proposed for sub-0.1-μm devices. The merit of the S⁴D structure is that the series resistance of the source and drain is significantly reduced since the silicide layer is attached very close to the gate electrode and the silicon sidewall can be doped very highly. Thus, very high drain current drive can be expected, Another advantage of this structure is that the source and drain extensions are produced by the solid-phase diffusion of boron from the highly doped silicon-sidewall. Thus, shallow extensions with very high doping can be realized. A 75-nm gate length pMOSFET fabricated with this structure is shown to exhibit excellent electrical characteristics     

Transgenesis by adenovirus-mediated gene transfer into mouse zona-free eggs

Zona-free mouse eggs at the pronucleus stage were infected with a replication-defective adenovirus vector containing a nuclear-targeted lacZ gene. Exogenous beta-galactosidase activity was detected in almost all eggs at the two-cell stage. Of 27 mice that developed from infected eggs, three carried the integrated exogenous gene mediated by the adenovirus. Two of the three expressed the lacZ gene, and all three mice transmitted the adenovirus-mediated transgene to F1 progeny Southern blot analysis was consistent with single copy integration. This finding should accelerate the development of new strategies for transgenesis and assist studies on the function of cloned genes in vivo.     

Drift hole mobility in strained and unstrained doped Si1-xGex alloys

Results of the drift hole mobility in strained and unstrained SiGe alloys are reported for Ge fractions varying from 0 to 30% and doping levels of 10¹⁵-10¹⁹ cm^-3. The mobilities are calculated taking into account acoustic, optical, alloy, and ionized-impurity scattering. The mobilities are then compared with experimental results for a boron doping concentration of 2×10¹⁹ cm^-3. Good agreement between experimental and theoretical values is obtained. The results show an increase in the mobility relative to that of silicon     

Efficient diode-pumped single-frequency erbium:ytterbium fiberlaser

We report a 7.6-mW single-frequency fiber laser operating at 1545 nm, using for the first time an Er³⁺:Yb³⁺ doped fiber and a fiber grating output coupler. The laser did not exhibit self-pulsation, which is a typical problem in short three-level fiber lasers, and had a relative intensity noise (RIN) level below -145.5 dB/Hz at frequencies above 10 MHz. The linewidth of the laser was limited by the relaxation oscillation sidebands in the optical spectrum and was typically less than 1 MHz     

Capacity enhancement of cellular CDMA by traffic-based control ofspeech bit rate

Variable rate speech coding is now recognized as an important system component for high-capacity cellular networks because it exploits speech statistics to reduce the average bit rate, which results in reduced interference and increased capacity. Once a variable rate capability is available, an additional capacity enhancement can be achieved by introducing network control of the user bit rate in response to changing traffic levels. We introduce the concept of network control of rate and propose a particular network-control method for code-division multiple access (CDMA) systems. Based on an M/M/∞//M queueing model applied to a cell under heavy traffic conditions and a new performance measure called averaged speech quality, we obtain simulation results to demonstrate how network control of rate can achieve improved speech quality or increased capacity for a given quality objective     

Lead content of rice collected from various areas in the world

Rice samples consumed by local populations were collected between 1990 and 1995 in 17 areas in the world, mostly from Asia (10 areas), but also from 7 areas outside of Asia. In total, 1528 samples were obtained (about one half from Japan) and were analyzed for lead (Pb) by electrothermal atomic absorption spectrometry. When the Pb contents in rice samples were classified into 10 areas in Asia, the highest and the lowest geometric means (GMs) were for Indonesia (38 ng/g) and Australia (2 ng/g), respectively. Among 7 regions outside Asia, the GM was highest for Spain (58 ng/g) and the lowest for the USA. (3 ng/g). Moreover, inter-regional differences were significant, when more than 100 samples from one area were divided into 3-9 regions and GMs for regions were compared. There was a marked difference in Pb contents in rice by areas and regions in the world. Nevertheless, comparison by area of the present results with those reported in literature show that there has been no substantial reduction in Pb in rice in the past decade either in Japan or elsewhere in the world.