非晶硅薄膜激光晶化及其结构分析

以射频(频率为13.6MHz)磁控溅射系统制备的非晶硅薄膜为前驱物,采用激光晶化技术实现从非晶硅薄膜到纳米晶硅薄膜的相变过程。采用拉曼光谱仪和高分辨透射电镜对激光晶化薄膜的组织结构进行了研究。结果表明:薄膜由非晶硅结构转变为微晶硅结构,微晶硅晶粒尺寸在纳米级。激光晶化存在一个最佳工艺参数,功率太高或太低都不利于晶化。     

无线技术的新领域--WUSB

无线USB(WUSB)技术是一个全新的无线传输标准.实现USB(通用串行总线)无线化以后,既可以保持有线USB的高速传输等优点,又可以去掉电缆的羁绊,给各种设备带来更大的便捷和移动性.文中首先介绍了WUSB技术的由来--UWB技术规范的标准化难以确定,然后对WUSB技术的规范标准进行了阐述,最后概述了WUSB技术的发展现状及目前和今后的技术研发重点,并对WUSB的发展前景进行了展望.     

Thermal cycling analysis of flip-chip solder joint reliability

The reliability concern in flip-chip-on-board (FCOB) technology is the high thermal mismatch deformation between the silicon die and the printed circuit board that results in large solder joint stresses and strains causing fatigue failure. Accelerated thermal cycling (ATC) test is one of the reliability tests performed to evaluate the fatigue strength of the solder interconnects. Finite element analysis (FEA) was employed to simulate thermal cycling loading for solder joint reliability in electronic assemblies. This study investigates different methods of implementing thermal cycling analysis, namely using the "dwell creep" and "full creep" methods based on a phenomenological approach to modeling time independent plastic and time dependent creep deformations. There are significant differences between the "dwell creep" and "full creep" analysis results for the flip chip solder joint strain responses and the predicted fatigue life. Comparison was made with a rate dependent viscoplastic analysis approach. Investigations on thermal cycling analysis of the temperature range, (ΔT) effects on the predicted fatigue lives of solder joints are reported     

High‐Performance Transition Metal Dichalcogenide Photodetectors Enhanced by Self‐Assembled Monolayer Doping

Most doping research into transition metal dichalcogenides (TMDs) has been mainly focused on the improvement of electronic device performance. Here, the effect of self‐assembled monolayer (SAM)‐based doping on the performance of WSe₂‐ and MoS₂‐based transistors and photodetectors is investigated. The achieved doping concentrations are ≈1.4 × 10¹¹ for octadecyltrichlorosilane (OTS) p‐doping and ≈10¹¹ for aminopropyltriethoxysilane (APTES) n‐doping (nondegenerate). Using this SAM doping technique, the field‐effect mobility is increased from 32.58 to 168.9 cm² V^?1 s in OTS/WSe₂ transistors and from 28.75 to 142.2 cm² V^?1 s in APTES/MoS₂ transistors. For the photodetectors, the responsivity is improved by a factor of ≈28.2 (from 517.2 to 1.45 × 10⁴ A W^?1) in the OTS/WSe₂ devices and by a factor of ≈26.4 (from 219 to 5.75 × 10³ A W^?1) in the APTES/MoS₂ devices. The enhanced photoresponsivity values are much higher than that of the previously reported TMD photodetectors. The detectivity enhancement is ≈26.6‐fold in the OTS/WSe₂ devices and ≈24.5‐fold in the APTES/MoS₂ devices and is caused by the increased photocurrent and maintained dark current after doping. The optoelectronic performance is also investigated with different optical powers and the air‐exposure times. This doping study performed on TMD devices will play a significant role for optimizing the performance of future TMD‐based electronic/optoelectronic applications.     

热处理对Ag-30Pd粉末相结构与形貌的影响

研究了热处理条件对不同方法制备的Ag-30Pd粉末的相结构与形貌的影响。结果表明,采用水合肼还原制备的Ag-30Pd共沉淀粉末,在335℃下经过油酸或氮气介质中液相或固相热处理后,粉末均朝合金化结构转变;采用抗坏血酸还原制备出的银钯合金粉初始为团聚颗粒,经400~450℃氮气气氛下热处理后,颗粒发生烧结而变得密实,结晶性提高;总体上,银钯共沉淀粉在335℃,合金粉在450℃的氮气保护下保温处理4 h后,粉末致密,粒径为1~3μm,可更好地满足银钯浆料的使用要求。     

一种新型基于石英的热光型光开关

一种采用基于石英的平面光波回路技术（PLC）制造的热光型光开关正越来越引起关注，它具有低耦合损耗、高稳定性及适于大规模集成等优点。首先描述了采用热光相移器构成马赫-曾德于涉仪（MZI）结构的热光型光开关，然后讨论2×2MZI热光型开关的工作原理及基本特性，最后介绍了由2×2MZI热光型开关单元构成的大规模光开关阵列以及一种采用悬梁式结构热光相移器的低功率消耗的光开关。     

LiNbO3光波导DBR结构透射特性分析

本文采用等效波导光栅Ｆ－ｐ腔方法分析了有耗情况下ＬｉＮｂＯ３光波导ＤＢＲ结构的透射特性，给出了利用这一结构设计电光强度调制器以及电调频分器的方法。     

无线数据通信网发展趋势

无线数据通信具有两大发展趋势，即低速的广域移动数据网及高速的局域无线数据网。本文介绍了其技术特点、应用情况和市场前景，分析了无线数据通信传输技术、网络结构和媒质接入控制等问题。     

无线传感网络中的动态集群密钥管理方案

Wireless sensor networks are open architectures, so any potential threat can easily intercept, wiretap and counterfeit the information. Therefore, the safety of WSN is very important. Since any single key system cannot guarantee the security of the wireless sensor network for communications, this paper introduces a hierarchical key management scheme based on the different abilities of different sensor nodes in the clustered wireless sensor network. In this scheme, the nodes are distributed into several clusters, and a cluster head must be elected for each cluster. Private communication between cluster heads is realized through the encryption system based on the identity of each head while private communication between cluster nodes in a same cluster head is achieved through the random key preliminary distribution system. Considering the characteristics of WSN, we adopt dynamic means called dynamic cluster key management scheme to deal with master key, so master key will be updated according to the changed dynamic network topology. For cluster head node plays a pivotal role in this scheme, a trust manage-ment system should be introduced into the election of the cluster head which will exclude the malicious node from outside the cluster, thus improve the whole network security.     

Evaluation of a new alkaline/microbe/polymer flooding system for enhancing heavy oil recovery

The new alkaline/microbe/polymer (AMP) flooding system was first constructed and evaluated for enhancing oil recovery. The system is composed of 0.3?wt% Na₂CO₃, 2?wt% microbial cultures and 0.2?wt% polymer. Compared with the conventional alkaline/surfactant/polymer (ASP) system, the AMP system exhibits identical displacement properties. Chromatography analysis reveals crude oil is not negatively affected by the microbes in AMP system. Further comparative core flooding experiments using the AMP and ASP systems demonstrate that the AMP system possesses greater potential for enhancing heavy oil recovery, which shows the characteristic of two-stage additional oil increment with total additional oil recovery of 17.11%–19.91%.