An experimental behaviour of concrete-filled steel tubular columns

In this paper results of tests conducted on 27 concrete-filled steel tubular columns are reported. The test parameters were the column slenderness, the load eccentricity covering axially and eccentrically loaded columns with single or double curvature bending and the compressive strength of the concrete core. The test results demonstrate the influence of these parameters on the strength and behaviour of concrete-filled steel tubular columns. A comparison of experimental failure loads with the predicted failure loads in accordance with the method described in Eurocode 4 Part 1.1 showed good agreement for axially and eccentrically loaded columns with single curvature bending whereas for columns with double curvature bending the Eurocode loads were higher and on the unsafe side. More tests are needed for the case of double curvature bending.     

Interaction of bacteriophage R17 and reovirus type III with the clay mineral allophane

A study has been made of the adsorption of bacteriophage R17 and reovirus type 3 by the amorphous aluminosilicate clay mineral allophane. In agreement with previous studies of virus adsorption to other minerals such as montmorillonite and aluminium hydroxide, the principal factors influencing adsorption were found to be mixing time, pH and the concentrations and isoelectric points of both the virus and the absorbent. However, allophane was found to be a much better adsorbent for reovirus and R17 over the pH range 5–7, the natural pH range of many fresh waters.By using highly purified radioactive reovirus it was possible to follow both the distribution of radioactive virus in a clay suspension and the specific infectivity of the virus. This study revealed that when adsorbed virus was eluted by neutral phosphate solutions it retained its physical integrity but was of a lower specific infectivity.     

A steady-state model for the rotating biological disc reactor

A steady-state model for substrate removal in a rotating biological disc reactor is presented. The model considers the consumption of substrate by micro-organisms in the biofilm attached to the rotating disc, and mass transfer from the attached liquid film to the biofilm. A mass balance on substrate over the liquid in the trough provides an expression for effluent substrate in terms of the microbial kinetic constants, the geometry of the system and the operating conditions. In order to simplify the solution of the equations in the model, first order kinetics are assumed for the rate of microbial growth and substrate utilization. This simplified model can be solved, for example, by using a programmable calculator. The model predicts that the fractional removal of substrate per stage is strongly dependent on the hydraulic loading rate per unit disc area but independent of feed substrate concentration. It predicts constant removal independent of disc size provided the hydraulic loading per unit area is kept constant. The rotational speed has only a slight predicted effect on the rate of substrate removal. The predictions of the model are compared with published data from the literature for both domestic wastewater and some industrial wastes. Trends observed in the field are predicted qualitatively by the model.     

Spatial and temporal trends of petroleum hydrocarbons in wild mussels from the Galician coast (NW Spain) affected by the Prestige oil spill

Polycyclic aromatic hydrocarbons (PAHs) were determined in tissues of wild mussels (Mytilus galloprovincialis) from the Galicia coast (NW Spain) in order to assess the extent of the environmental impact caused by the Prestige oil spill (November 13, 2002). Three sampling campaigns were carried out in February, June and November 2003 at 24 stations along the Galicia coast, from La Guardia (Pontevedra) to Ribadeo (Lugo). The spatial distribution of PAHs found in the first sampling period, clearly revealed the central area (Costa da Morte) as the most affected by the oil spill. In these stations, concentrations up to 7780 microg/kg dw of the sum of 13 parent PAHs were found 2-3 months after the spill. Molecular parameters within the aliphatic and aromatic fractions confirmed the presence of the Prestige oil in these samples. The levels markedly decreased at most of the stations in the second sampling and recovered to levels found before the spill in November 2003, 1 year after the accident (29-279 microg/kg dw, av. 133+/-83 microg/kg dw). However, a certain increase was observed in some sites which could be related to the remobilization of oil residues from still unclean intertidal spots or sediments due to the winter marine weather conditions.     

Betons a hautes performances,a granulats artificiels actifs

High strength concretes, in particular at early ages (more than 40 MPa at 3 days and up to 80 MPa at 7 days), are obtained by replacement of certain granular size ranges of sand or gravel by cement-active artificial aggregates in a given concrete composition elaborated with a local supply of aggregates and cement. The strengthening of the paste-aggregate bond by chemical reactions between the artificial aggregates and the cement also involves an improvement of other concrete performances and not only of mechanical strengths. The cracking ability is decreased, the wear strength is higher, and water permeability is low or even nil for certain compositions. The laboratory results are confirmed by tests on the site and show the possibility of achieving high strength concretes without any particular selection of cement and natural aggregates.     

Concurrent denitrification and oxygen uptake in microbial films

Mixed microbial films were grown on the inner walls of a tubular reactor with recirculation of the reactor contents and continuous flow-through of nutrient solution. The loss of total oxidized nitrogen was correlated to the film population, the nitrite concentration and the dissolved oxygen concentration in the reactor. When film population was greater than 0.5 × 10⁹ cells cm⁻², reactor dissolved oxygen concentration greater than 1 mg l⁻¹ had little effect on the nitrate loss. Nitrate loss declined for film populations greater than 2 × 10⁹ cells cm⁻². Models based on Monod and zero-order microbial kinetics were calibrated using these data and a nonlinear least squares method. There was little difference in the residual errors with these methods.     

Tunnelling projects in Southern Africa

Until some thirty years ago tunnelling in southern Africa for civil engineering purposes had been on a relatively small scale and of a sporadic nature. The first major tunnel to be built in the region was the 82 km long Orange-Fish Tunnel. Since 1970 more than 175 tunnels with an aggregate length of just over 400 km have been built. Much of the first phase of the Lesotho Highlands Water Project, which will have more than 100 km of tunnels, is about to be completed. The last thirty years represent the busiest period of tunnelling by civil engineers that southern Africa has ever known. The paper starts by summarising the early history of tunnelling in the region, and goes onto describe recent and current tunnelling projects. It also gives an indication of the possible demand for tunnels in the future.     

Effect of chlorination practice on soluble organics

As the practice of chlorination for the disinfection of waste effluents is apparently to be extended, this study was initiated to examine the possibility that chlorinated organics could be formed in the disinfection process. A group of pure compounds that had been demonstrated to be susceptible to chlorination were examined under conditions likely to apply under normal disinfection practice.From the results obtained, it appears only organics with ring structures and electron activating substituents, or amino groupings are capable of chlorination. The frequent presence of ammonia or amino groups means that chloramine formation with its asociated toxicity is likely. However, the presence of ammonia or amino groups will retard the reaction with other compounds making chlorination of these unlikely.     

Conceptual aspects of water re-use

A simplified model of a municipal water recycle system is presented and gives a clear picture of the relationship between process variables such as the intensity of the treatment, the accumulation of pollutants and the number of times the water is re-used. The model can be used to determine the necessary requirements for the treatment process in order to reach a certain desired drinking water quality. This model is extended to cover a variety of practical conditions. It is also shown that accumulation under practical conditions is limited, even if there is no treatment. The model predicts that the recycle system can utilise a low quality supplementary supply, e.g. brackish water. Although the model is derived for a recycle system for domestic water supply it can be used for any closed loop water system.