Features of Investigation into the Properties of Glasses and Melts from the Late 19th Century to the Present Day

The evolution of investigations into glass properties is described with the use of the SciGlass information system on the basis of an analysis of the world literature on glass from the end of the 19th century to the present day. Variations in the total amount of published data, in the interest of researchers in certain glass components and their properties, in the specific features of forming research groups, and in the general quality of publications are considered. Measures are proposed that can prevent a further decline in the quality of published experimental results.     

Adjuvant arthritis: influence of the adjuvant volume and composition on the non-specific inflammation

Adjuvant-induced arthritis is an animal model of chronic inflammatory disease widely used in anti-inflammatory and immunosuppressive drugs testing. When the development and the inhibition of the induced arthritis are measured by the injected paw oedema, it is difficult to delineate the immunological contribution from the persistent non-specific primary section. To study the influence of volume and composition of the injected adjuvant upon the primary non-specific inflammation, we devised a 3X4 factorial experiment on a strain of inbred rats with a low susceptibility to adjuvant-induced arthritis. The injection of mineral oil alone produces a persistent oedema. The injection of mycobacteriae in suspension in saline induces a rapid inflammatory response followed by a fast decrease of the oedema. When complete adjuvant is used, there is always a very strong interaction between the effects of the two components of the adjuvant, i.e. the measured oedemas are much greater than the calculated values, For a given injected volume, the inflammation is maximum when the concentration of mycobacteriae is 2.5 mg/ml. All the rats injected with complete adjuvant present a transient oedema of the non-injected hind paw. This oedema is very small and proportional to the amount of mycobacteria injected.     

Determining pheromone content of hairpencils from individual virgin males ofPseudaletia unipuncta (Haw.) (Lepidoptera: Noctuidae)

Levels of benzaldehyde recovered from virginPseudaletia unipuncta (Haw.) males were not influenced by (1) the time hairpencils remained in the solvent (1-72 hr), (2) anesthetization or agitation of males prior to excision of hairpencils, or (3) the time (photophase or scotophase) that hairpencils were excised. Thus the interindividual variability observed is not a methodological artifact. Most males had similar concentrations in both hairpencils, although in some cases only one hairpencil contained pheromone. In one case, a male with partially extruded hairpencils had no benzaldehyde at all. Neither pupal weight nor hairpencil length proved to be reliable indicators of pheromone content.Contribution No. 373, Département de biologie, Université Laval.     

CoGaInS4: A new layered compound

We report on the synthesis results obtained for some compositions in the Co(GaxIn_1-x)₂S₄ family, whose intermediate member CoGaInS₄ is shown to display a layered structure. This result is discussed and compared with the literature.     

Infrared spectra of poly(ethylene terephthalate) yarns. Fitting of spectra,evaluation of parameters,and applications

A quantitative model for fitting infrared spectra of polyethyleneterephthalate samples over the region from 1100 to 720 cm^?1 has been evaluated. The absorbance was described as the sum of a linear base line and a set of symmetrical bell-shaped Pearson VII curves. Using this model, experimental transmission spectra of yarns, measured with the electric vector parallel and perpendicular to the fiber axis, were fitted. It was found that each of the trans bands near 972 and 845 cm^?1 consists of two components, a narrow and a broad one. These two components represent the crystalline and amorphous phases respectively. The band due to the out of plane benzene ring C? H deformation vibration at about 875 cm^?1 appeared also to be composed of two contributions. In this case, the narrow component was found to be due to molecules having interactions with direct neighbors. So this narrow component not only contains the molecules in the crystalline phase but also those forming part of bundles which are too small to be detected by x-ray diffraction. For a detailed insight into the molecular arrangement of the amorphous regions, the infrared detection of trans-guache transitions, fold content, detection of bundlelike structures, and molecular stress on tie molecules turned out to be of great practical importance. The structural details, which can be revealed by the infrared technique, cannot be obtained by other means. The potential of the method is illustrated with some practical examples.     

Crystallization and agglomeration kinetics of nickel ammonium sulphate in an MSMPR crystallizer

Precipitation of nickel ammonium sulphate achieved by mixing solutions of nickel sulphate and ammonium sulphate in a 5 1 MSMPR crystallizer is used to investigate both crystallization and agglomeration kinetics from the steady-state crystal size distribution. An iterative non-linear parameter estimation procedure is used to deduce the kinetic rate parameters in the solution of the agglomeration model suggested by Liao and Hulburt from the data-set obtained by size analysis of the product crystals. The results obtained are correlated in terms of conventional power law kinetic expressions.     

DRYING OF GRANULAR PARTICLES IN A MULTISTAGE INCLINED FLUIDIZED BED WITH MECHANICAL VIBRATION

A mathematical model for the drying rate of granular particles in a multistage inclined fluidized bed(IFB) is presented from the standpoint of simultaneous heat and mass transfer, with taking the effect of mechanical vibration added vertically into consideration.

Steady-state distributions for the temperatures and concentrations of the particles and the heating gas, and for the moisture content of the particles are numerically calculated based on the present model. The calculated results show fairly good agreement with the experimental data, which were obtained from the drying experiments of brick particles in a three-stage IFB using comparatively low temperature air(40-60°C) as the heating gas.

It has been found within the range of the experimental conditions employed that, the mechanical vibration added vertically enhances the over-all drying rate of the particles and its effect can be considered equivalent to an increase in the air velocity.     

Hydrolysis of 4-methylumbelliferyl butyrate: A convenient and sensitive fluorescent assay for lipase activity

A rapid, sensitive and convenient fluorescent assay was developed to screen for lipase activity. The non-fluorescent substrate, 4-methylumbelliferyl butyrate (4-MUB), solubilized in either liposomal dispersions or bile salt/lecithin mixed micelles, is hydrolyzed to butyric acid and the highly fluorescent compound, 4-methylumbelliferone (4-MU). Assays are run at 37 C for 10 min, terminated, and the changes in fluorescence quantitated with a Turner III fluorometer. Both lingual and pancreatic lipases exhibit activity against this artificial substrate. The assay has several advantages: nmoles 4 MU/ml/hr are measured allowing the detection of very low lipolytic activity; multiple samples may be simultaneously assayed, and only a brief incubation period is required.