Surface enhanced fluorescence of anti-tumoral drug emodin adsorbed on silver nanoparticles and loaded on porous silicon

Fluorescence spectra of anti-tumoral drug emodin loaded on nanostructured porous silicon have been recorded. The use of colloidal nanoparticles allowed embedding of the drug without previous porous silicon functionalization and leads to the observation of an enhancement of fluorescence of the drug. Mean pore size of porous silicon matrices was 60 nm, while silver nanoparticles mean diameter was 50 nm. Atmospheric and vacuum conditions at room temperature were used to infiltrate emodin-silver nanoparticles complexes into porous silicon matrices. The drug was loaded after adsorption on metal surface, alone, and bound to bovine serum albumin. Methanol and water were used as solvents. Spectra with 1 μm spatial resolution of cross-section of porous silicon layers were recorded to observe the penetration of the drug. A maximum fluorescence enhancement factor of 24 was obtained when protein was loaded bound to albumin, and atmospheric conditions of inclusion were used. A better penetration was obtained using methanol as solvent when comparing with water. Complexes of emodin remain loaded for 30 days after preparation without an apparent degradation of the drug, although a decrease in the enhancement factor is observed. The study reported here constitutes the basis for designing a new drug delivery system with future applications in medicine and pharmacy.     

Lipid Transfer to HDL is Higher in Marathon Runners than in Sedentary Subjects,but is Acutely Inhibited During the Run

Although exercise increases HDL-cholesterol, exercise-induced changes in HDL metabolism have been little explored. Lipid transfer to HDL is essential for HDL’s role in reverse cholesterol transport. We investigated the effects of acute exhaustive exercise on lipid transfer to HDL. We compared plasma lipid, apolipoprotein and cytokine levels and in vitro transfer of four lipids from a radioactively labeled lipid donor nanoemulsion to HDL in sedentary individuals (n = 28) and in marathon runners (n = 14) at baseline, immediately after and 72 h after a marathon. While HDL-cholesterol concentrations and apo A1 levels were higher in marathon runners, LDL-cholesterol, apo B and triacylglycerol levels were similar in both groups. Transfers of non-esterified cholesterol [6.8 (5.7–7.2) vs. 5.2 (4.5–6), p = 0.001], phospholipids [21.7 (20.4–22.2) vs. 8.2 (7.7–8.9), p = 0.0001] and triacylglycerol [3.7 (3.1–4) vs. 1.3 (0.8–1.7), p = 0.0001] were higher in marathon runners, but esterified-cholesterol transfer was similar. Immediately after the marathon, LDL- and HDL-cholesterol concentrations and apo A1 levels were unchanged, but apo B and triacylglycerol levels increased. Lipid transfer of non-esterified cholesterol [6.8 (5.7–7.2) vs. 5.8 (4.9–6.6), p = 0.0001], phospholipids [21.7 (20.4–22.2) vs. 19.1 (18.6–19.3), p = 0.0001], esterified-cholesterol [3.2 (2.2–3.8) vs. 2.3 (2–2.9), p = 0.02] and triacylglycerol [3.7 (3.1–4) vs. 2.6 (2.1–2.8), p = 0.0001] to HDL were all reduced immediately after the marathon but returned to baseline 72 h later. Running a marathon increased IL-6 and TNF-α levels, but after 72 h these values returned to baseline. Lipid transfer, except esterified-cholesterol transfer, was higher in marathon runners than in sedentary individuals, but the marathon itself acutely inhibited lipid transfer. In light of these novel observations, further study is required to clarify how these metabolic changes can influence HDL composition and anti-atherogenic function.     

Image reconstruction using interval simulated annealing in electrical impedance tomography

Electrical impedance tomography (EIT) is an imaging technique that attempts to reconstruct the impedance distribution inside an object from the impedance between electrodes placed on the object surface. The EIT reconstruction problem can be approached as a nonlinear nonconvex optimization problem in which one tries to maximize the matching between a simulated impedance problem and the observed data. This nonlinear optimization problem is often ill-posed, and not very suited to methods that evaluate derivatives of the objective function. It may be approached by simulated annealing (SA), but at a large computational cost due to the expensive evaluation process of the objective function, which involves a full simulation of the impedance problem at each iteration. A variation of SA is proposed in which the objective function is evaluated only partially, while ensuring boundaries on the behavior of the modified algorithm.     

RERBEE: robust efficient registration via bifurcations and elongated elements applied to retinal fluorescein angiogram sequences

We present RERBEE (robust efficient registration via bifurcations and elongated elements), a novel feature-based registration algorithm able to correct local deformations in high-resolution ultra-wide field-of-view (UWFV) fluorescein angiogram (FA) sequences of the retina. The algorithm is able to cope with peripheral blurring, severe occlusions, presence of retinal pathologies and the change of image content due to the perfusion of the fluorescein dye in time. We have used the computational power of a graphics processor to increase the performance of the most computationally expensive parts of the algorithm by a factor of over × 1300, enabling the algorithm to register a pair of 3900 × 3072 UWFV FA images in 5-10 min instead of the 5-7 h required using only the CPU. We demonstrate accurate results on real data with 267 image pairs from a total of 277 (96.4%) graded as correctly registered by a clinician and 10 (3.6%) graded as correctly registered with minor errors but usable for clinical purposes. Quantitative comparison with state-of-the-art intensity-based and feature-based registration methods using synthetic data is also reported. We also show some potential usage of a correctly aligned sequence for vein/artery discrimination and automatic lesion detection.     

Electrochemical Energy Storage Technologies and Applications

The current need to fasten the implementation of renewable energies greatly depends on the development of competitive storage devices, and while there is not a single technology which is likely capable to competitively cover the wide range of possible demands, electrochemical technologies are one of the most promising for many of them. For the realization of this promise, new materials fulfilling criteria such as high energy density, high power density, competitive cost, reliability, and environmental compatibility need to be developed in the near future. Electrochemical energy storage devices can be classified into two main technologies： supercapacitors and batteries （including redox flow batteries）. Materials and applications for these technologies are discussed and compared, listing current status, technical and strategic challenges.     

Dead Zones in LX‐17 and PBX 9502

Pin and X‐ray corner turning data have been taken on ambient LX‐17 and PBX 9052, and the results are listed in tables as an aid to future modeling. The results have been modeled at 4 zones/mm with a reactive flow approach that varies the burn rate as a function of pressure. A single rate format is used to simulate failure and detonation in different pressure regimes. A pressure cut‐off must also be reached to initiate the burn. Corner turning and failure are modeled using an intermediate pressure rate region, and detonation occurs at high pressure. The TATB booster is also modeled using reactive flow, and X‐ray tomography is used to partition the ram‐pressed hemisphere into five different density regions. The model reasonably fits the bare corner turning experiment but predicts a smaller dead zone with steel confinement, in contradiction with experiment. The same model also calculates the confined and unconfined cylinder detonation velocities and predicts the failure of the unconfined cylinder at 3.75 mm radius. The PBX 9502 shows a smaller dead zone than LX‐17. An old experiment that showed a large apparent dead zone in Composition B was repeated with X‐ray transmission and no dead zone was seen. This confirms the idea that a variable burn rate is the key to modeling. The model also produces initiation delays, which are shorter than those found in time‐to‐detonation.     

Hydrophilic CNC‐Pincer Palladium Complexes: A Source for Highly Efficient,Recyclable Homogeneous Catalysts in Suzuki–Miyaura Cross‐Coupling

The Suzuki biaryl coupling of a range of electronically dissimilar arylboronic acids and aryl bromides is performed in neat water with excellent to quantitative yields by means of a new CNC‐pincer palladium catalyst that is soluble in water due to its para‐carboxy group. Extremely high turnover numbers and frequencies combined with a remarkable robustness allow an effective catalyst reuse in sustainable conditions.     

Distribution and mobility of arsenic in the Río Dulce alluvial aquifers in Santiago del Estero Province, Argentina

Factors controlling arsenic (As) mobilization in the aquifers of the Río Dulce alluvial cone were investigated. Groundwater analyses show severe As contamination (average concentration of 743 mug/L) from geogenic sources, but spatial variability of As concentration is considerable. Sequential leaching of sediment samples from unsaturated zone using de-ionised water, bicarbonate, acetate, and oxalate extracted As to different extents. Sediment oxalate extraction showed that Al and Mn oxide and hydroxides are more abundant than Fe oxides and hydroxides, in spite of similar total Fe, Mn, and Al concentrations in the sediment. Speciation calculations performed for saturated zone samples indicated that Fe and Al oxides and hydroxides are stable in groundwater, suggesting that As adsorption processes may be to some extent controlled by the presence of Fe and Al mineral phases. Principal Component Analysis (PCA) showed that As is related to F, V, Mo, B, Si, most likely due to their common origin in volcanic ash. This suggests the volcanic ash as the probable source of groundwater As. Locally, elevated pH values linked to carbonate dissolution, cation exchange, and dissolution of silicates promote release of adsorbed As. Another factor contributing to the release of As locally may be the input of organic matter from excessive irrigation. The conceptual model of As release includes: i) As influx from dissolution of volcanic glass in volcanic ash, ii) adsorption of As on the surface of Fe and Al mineral phases in relatively low pH zones, and iii) high mobility of As in high pH zones. Future work should be focused on the determination of mineralogical forms of As in volcanic ash and on detailed investigation on factors controlling As mobility.     

Operations research in the high-level synthesis of integrated circuits

The acceptance of high-level synthesis tools and methodologies by the design engineers depends on their efficiency in producing circuits with small silicon areas and high operating speeds. This paper shows how this efficiency can be achieved through the use of several operations research techniques applied to the many optimization problems that must be solved. These include: shortest path algorithms, integer programming techniques applied to silicon area minimization, force directed scheduling to optimize the number of operators and cost/speed trade-offs of logical gates. This paper presents several examples providing an operations research solution to each of them.