Investigation on the effect of spinning conditions on the properties of hollow fiber membrane for hemodialysis application

Polyethersulfone (PES) hollow fiber membranes were fabricated via the dry‐wet phase inversion spinning technique, aiming to produce an asymmetric, micro porous ultrafiltration hollow‐fiber specifically for hemodialysis membrane. The objective of this study is to investigate the effect of spinning conditions on the morphological and permeation properties of the fabricated membrane. Among the parameters that were studied in this work are air gap distance, dope extrusion rate, bore fluid flow rate, and the take‐up speed. The contact angle was measured to determine the hydrophilicity of the fibers. Membrane with sufficient hydrophilicity properties is desired for hemodialysis application to avoid fouling and increase its biocompatibility. The influences of the hollow fiber's morphology (i.e., diameter and wall thickness) on the performance of the membranes were evaluated by pure water flux and BSA rejection. The experimental results showed that the dope extrusion rate to bore fluid flow rate ratio should be maintained at 1:1 ratio to produce a perfectly rounded asymmetric hollow fiber membrane. Moreover, the flux of the hollow fiber spun at higher air gap distance had better flux than the one spun at lower air gap distance. Furthermore, spinning asymmetric hollow fiber membranes at high air gap distance helps to produce a thin and porous skin layer, leading to a better flux but a relatively low percentage of rejection for BSA separation. Findings from this study would serve as primary data which will be a useful guide for fabricating a high performance hemodialysis hollow fiber membrane. © 2016 Wiley Periodicals, Inc. J. Appl. Polym. Sci. 2016 , 133, 43633.     

Effect of fortification on physico-chemical and microbiological stability of whole wheat flour

Stability of fortified whole wheat flour (WWF) was evaluated using NaFeEDTA, elemental iron, ZnSO₄ and ZnO as fortificants. Fortified WWF was stored in tin boxes and polypropylene bags for 60 days under ambient storage condition (ASC) and controlled storage condition (CSC). Fortification significantly (p ? 0.05) decreased moisture and protein content and increased ash content to 5.44%, 6% and 23%, as compared to control. Fortified WWF, assayed periodically for mould contamination manifested a significant inhibition (∼1 log reduction) in flours containing elemental iron. Low storage temperature and relative humidity (RH) indicated lower level of mould count during extended storage time. Tin boxes, as storage material, exhibited a better protection against mould attack, acting as an effective barrier for moisture. Fortificants exerted a slight deteriorative effect on texture characteristics of the chapattis made of these flours but chapattis were still accepted by the judges. Zinc fortificants seemed like having little or no effect on the quality of the flours and chapattis, made of such flours. Shelf life of fortified flour may be extended by using elemental iron as fortificant and storing the product in tin boxes under relatively low temperature and RH.     

Bimetallic Zn/Ag doped polyurethane spider net composite nanofibers: A novel multipurpose electrospun mat

The objective of this study was to develop a new class of bimetallic ZnO/Ag embedded polyurethane multi-functional nanocomposite by a straightforward approach. Bimetallic nanomaterials, composed of two unlike metal elements, are of greater interest than the monometallic materials because of their improved characteristics. In the present study the bimetallic composite was prepared using sol–gel via the facile electrospinning technique. The utilized sol–gel was composed of zinc oxide, silver and poly(urethane). The physicochemical properties of as-spun composite mats were determined by X-ray diffraction pattern, field emission scanning electron microscopy, energy dispersive X-ray spectroscopy and transmission electron microscopy. The antibacterial activity was tested using Escherichia coli as model organism. The antibacterial test showed that ZnO:Ag/polyurethane composite possesses superior antimicrobial activity than pristine PU and ZnO/PU hybrids. Furthermore, our results illustrate that the synergistic effect of ZnO and Ag resulted in the advanced antimicrobial action of bimetallic ZnO/Ag composite mat. The viability and proliferation properties of NIH 3T3 mouse fibroblast cells on the ZnO:Ag/polyurethane composite nanofibers were analyzed by in vitro cell compatibility test. Our results indicated the non-cytotoxic behavior of bimetallic ZnO:Ag/polyurethane nanofibers towards the fibroblast cell culture. In summary, novel ZnO:Ag/polyurethane composite nanofibers which possess large surface to volume ratio with excellent antimicrobial activity were fabricated. The unique combination of ZnO and Ag nanoparticles displayed potent bactericidal effect due to a synergism. Hence the electrospun bimetallic composite indicates the huge potential in water filtration, clinical and biomedical applications.     

Synthesis,characterization, and cell viability of bifunctional medical-grade polyurethane nanofiber: Functionalization by bone inducing and bacteria ablating materials

There is an extensive possibility of improving characteristics of fibers used in hard tissue engineering, being hydrophobic and less osteoconductive, resulting in the dynamic growth of new tissues. The current work focuses on the fabrication of nanofibers incorporated with titanium dioxide (TiO₂) ''as osteoconductive'' and silver (Ag) ''as self-healing'' nanoparticles (NPs). The incorporation of AgNO₃ by in situ method not only helped to impart the antibacterial activity but also changed the contact angle from 81 ± 03° in the case of pristine nanofibers to 74 ± 03°, 61 ± 03°, 50 ± 08°, and 39 ± 1.1°, in the composite scaffolds containing 0.01, 0.03, 0.05, and 0.07 M of Ag salts. The incubation in simulated body fluid at 37°C to induce mineralization on nanofiber scaffolds indicated Ca and P crystals' formation. The antibacterial activity showed significantly more toxicity toward E. coli (8.3 ± 0.9 mm) than S. aureus (1.2 ± 0.1 mm). Biocompatibility studies using MTT assay on the pre-osteoblasts showed that both TiO₂ and Ag NPs present in the nanofibers are non-toxic to the bone-like cells. However, results show that a higher concentration of Ag NPs (i.e., 0.07 M) is toxic to cells growing. Finally, all the results suggest that the nanofiber scaffolds have considerable scope for future bone tissue engineering materials.     

Palyno‐morphological characteristics of gymnosperm flora of pakistan and its taxonomic implications with LM and SEM methods

The present study is intended to assess gymnosperms pollen flora of Pakistan using Light Microscope (LM) and Scanning Electron Microscopy (SEM) for its taxonomic significance in identification of gymnosperms. Pollens of 35 gymnosperm species (12 genera and five families) were collected from its various distributional sites of gymnosperms in Pakistan. LM and SEM were used to investigate different palyno‐morphological characteristics. Five pollen types (i.e., Inaperturate, Monolete, Monoporate, Vesiculate‐bisaccate and Polyplicate) were observed. Six In equatorial view seven types of pollens were observed, in which ten species were sub‐angular, nine species were Traingular, six species were Perprolate, three species were Rhomboidal, three species were semi‐angular, two species were rectangular and two species were prolate. While five types of pollen were observed in polar view, in which ten species were Spheroidal, nine species were Angular, eight were Interlobate, six species were Circular, two species were Elliptic. Eighteen species has rugulate and 17 species has faveolate ornamentation. Eighteen species has verrucate and 17 have gemmate type sculpturing. The data was analysed through cluster analysis. The study showed that these palyno‐morphological features have significance value in classification and identification of gymnosperms. Based on these different palyno‐morphological features, a taxonomic key was proposed for the accurate and fast identifications of gymnosperms from Pakistan.     

Simplified soft value extraction for M-PPM-modulated signals in FSO systems

In the following paper we propose a new approach for extracting soft values from Mth order pulse position modulation (M-PPM). A new low-complexity algorithm is developed, where soft information for each data bit is calculated based on the power received within the PPM time slots. In order to decrease the computational complexity we simplify the calculation of the conditional probability of data vector a given that PPM symbol Y is received. The Monte Carlo simulations applied to analyze the properties of the algorithm for turbo-coded M-PPM transmission in free space optic communication systems show acceptable degradation of system performance with regard to system simplification.     

Structured literature image finder: Parsing text and figures in biomedical literature

The SLIF project combines text-mining and image processing to extract structured information from biomedical literature.SLIF extracts images and their captions from published papers. The captions are automatically parsed for relevant biological entities (protein and cell type names), while the images are classified according to their type (e.g., micrograph or gel). Fluorescence microscopy images are further processed and classified according to the depicted subcellular localization.The results of this process can be queried online using either a user-friendly web-interface or an XML-based web-service. As an alternative to the targeted query paradigm, SLIF also supports browsing the collection based on latent topic models which are derived from both the annotated text and the image data.The SLIF web application, as well as labeled datasets used for training system components, is publicly available at http://slif.cbi.cmu.edu.     

Matching Trajectories of Anatomical Landmarks Under Viewpoint,Anthropometric and Temporal Transforms

An approach is presented to match imaged trajectories of anatomical landmarks (e.g. hands, shoulders and feet) using semantic correspondences between human bodies. These correspondences are used to provide geometric constraints for matching actions observed from different viewpoints and performed at different rates by actors of differing anthropometric proportions. The fact that the human body has approximate anthropometric proportion allows innovative use of the machinery of epipolar geometry to provide constraints for analyzing actions performed by people of different sizes, while ensuring that changes in viewpoint do not affect matching. In addition, for linear time warps, a novel measure, constructed only from image measurements of the locations of anatomical landmarks across time, is proposed to ensure that similar actions performed at different rates are accurately matched as well. An additional feature of this new measure is that two actions from cameras moving at constant (and possibly different) velocities can also be matched. Finally, we describe how dynamic time warping can be used in conjunction with the proposed measure to match actions in the presence of nonlinear time warps. We demonstrate the versatility of our algorithm in a number of challenging sequences and applications, and report quantitative evaluation of the matching approach presented.     

Quality-aware images.

We propose the concept of quality-aware image, in which certain extracted features of the original (high-quality) image are embedded into the image data as invisible hidden messages. When a distorted version of such an image is received, users can decode the hidden messages and use them to provide an objective measure of the quality of the distorted image. To demonstrate the idea, we build a practical quality-aware image encoding, decoding and quality analysis system, which employs: 1) a novel reduced-reference image quality assessment algorithm based on a statistical model of natural images and 2) a previously developed quantization watermarking-based data hiding technique in the wavelet transform domain.