涤纶工业丝环吹风改造的设计计算

应用PET纤维的冷却成形理论 ,结合空气调节的相关知识 ,提出了环吹风的设计计算方法 ,对涤纶工业丝环吹风进行了设计改造 ,满足了纺丝工艺要求     

Disciplinary and linguistic considerations for academic Web linking: An exploratory hyperlink mediated study with Mainland China and Taiwan

The Web has become an important means of academic information exchange and can be used to give new insights into patterns of informal scholarly communication. This study develops new methods to examine patterns of university Web linking, focusing on Mainland China and Taiwan, and including language considerations. Multiple exploratory investigations into Web links were conducted between universities in these two places. Firstly, inlinks were counted to each university Web site from its national peers using four alternative Web document models. The results were shown to correlate significantly with research productivity in Taiwan but not in the Mainland, although in the latter case less reliable institutional data could have been the cause. For Taiwan, this is the first evidence of a scholarly association with academic linking for a non-English speaking region. It was then ascertained that the same link counts associated more strongly with scientific than social scientific research productivity in Taiwan. This confirms the general assumption of greater Web use by the hard sciences. We then investigated Taiwan-Mainland university cross-links, and found that although English is extensively used on the Web, there was no evidence that it was the language of preference for informal scholarly communication between the two areas. This revised version was published online in August 2006 with corrections to the Cover Date.     

半导体量子点中极化子的有效质量

研究了半导体量子点中极化子的有效质量.采用改进的线性组合算符方法,导出在电子-体纵光学声子(LO)强耦合时抛物量子点中极化子的振动频率、相互作用能和有效质量随受限强度和电子-声子耦合强度的变化.对RbCl晶体量子点进行了数值计算,结果表明,量子点受限越强,半导体量子点中强耦合极化子的振动频率和有效质量就越大;极化子的相互作用能随受限强度的增加先急剧增加,当达到极值后,随受限强度的增加而急剧减少     

应用激光活化饵料藻种的研究

应用Nd:YAG激光(波长1.06μm,功率5w,照射时间0.5-3 min)和Ar+激光(波长488nm,功率70mw,照射时间5-15min)对长期保存的不同保存形式的塔胞藻(Pyramidomonassp.)进行辐照处理。研究了不同剂量激光辐照对藻体生长和叶绿素含量的影响。实验结果表明:照射剂量为60s的Nd:YAG激光及剂量为15min的Ar+激光对液体保存形式的藻种有较明显的促长效果,接种后这两种激光处理组的比生长速率分别较对照提高达53.33%和28.89%,叶绿素含量分别增加73.33%和65.69%。两种激光对液体保存藻种的活化效果均好于固体保存种。     

锂离子电池用聚合物电解质的最新进展II.含液聚合物电解质

由于干态聚合物电解质目前还不能满足聚合物锂离子电池的应用要求,人们致力于开发含液体增塑剂的聚合物电解质,包括凝胶型和微孔型两类体系。本文综述了含液聚合物电解质的最新进展,重点论述了各种新体系和新方法。     

基于谐振原理的硅微机械加速度计

基于力学振动原理 ,导出敏感梁类谐振振动的微分方程 ,给出了振梁型加速度计的设计原理。指出了加速度计谐振梁频率的相对变化量与梁的厚度无关 ;为避免输出非线性频率信号 ,频率的相对变化率和激励振动的振幅都不宜太大     

宽工作电压范围单电源CMOS误差放大器

采用0.8μm标准数字CMOS工艺(VTN0=0.836V,VTP0=0.930V),设计并流片验证了具有宽工作电压范围(3～6V),可作SOC系统动态电源管理芯片内部误差放大器应用的单电源CMOS运算放大器。该误差放大器芯核同时具有适合低电压工作,并对工艺参数变化不敏感的优点。对于相同的负载情况,在3V的工作电压下,开环电压增益AD=83.1dB,单位增益带宽GB=2.4MHz,相位裕量Φ=85.2°,电源抑制比PSRR=154.0dB,转换速率Sr=2.2V/μs;在6V工作电压下,AD=85.1dB,GB=2.4MHz,Φ=85.4°,PSRR=145.3dB,Sr=3.4V/μs。     

End‐Capping as a Method for Improving Carrier Injection in Electrophosphorescent Light‐Emitting Diodes

The electronic properties, carrier injection, and transport into poly(9,9‐dioctylfluorene) (PFO), PFO end‐capped with hole‐transporting moieties (HTM), PFO–HTM, and PFO end‐capped with electron‐transporting moieties (ETM), PFO–ETM, were investigated. The data demonstrate that charge injection and transport can be tuned by end‐capping with HTM and ETM, without significantly altering the electronic properties of the conjugated backbone. End‐capping with ETM resulted in more closely balanced charge injection and transport. Single‐layer electrophosphorescent light‐emitting diodes (LEDs), fabricated from PFO, PFO–HTM and PFO–ETM as hosts and tris[2,5‐bis‐2′‐(9′,9′‐dihexylfluorene)pyridine‐κ²NC_3′]iridium(III ), Ir(HFP)₃ as the guest, emitted red light with brightnesses of 2040 cd m^–2, 1940 cd m^–2 and 2490 cd m^–2 at 290 mA cm^–2 (16 V) and with luminance efficiencies of 1.4 cd A^–1, 1.4 cd A^–1 and 1.8 cd A^–1 at 4.5 mA cm^–2 for PFO, PFO–HTM, and PFO–ETM, respectively.     

Modeling of a constant Voltage transformer

This paper presents a comprehensive nonlinear model of the controlled constant voltage transformer also known as the ferroresonant transformer. Saturation is a normal mode of operation for this device. This paper derives an equivalent electrical circuit that relates to the physical structure of a typical design. The level of detail includes winding resistances, continuously nonlinear magnetizing inductances, tapped windings, and leakage inductances. The paper describes methods to extract the winding resistances, leakage inductances, and hysteresis loops of the transformer and how to fit the latter into single-valued nonlinear functions. The paper compares computer simulation results of the model with those obtained analytically and experimentally. The results show that the derived circuit will be very useful for designers of the ferroresonant transformer, which is used in uninterruptible power supplies.