Analysis of illumination-intensity-dependent j–V characteristics of ZnO/CdS/CuGaSe2 single crystal solar cells

Current–voltage characteristics of ZnO/CdS/CuGaSe₂ single crystal solar cells measured at room temperature are investigated depending on illumination intensity. The characteristics can be described using the two-diode model, indicating two current transport mechanisms acting in the cells. The first and dominant mechanism is recombination of carriers at the interface between CdS and CuGaSe₂. The second one is recombination in the depletion region, which has been found to have a small effect on the solar cell photovoltaic performance. Both the diode ideality factor and the saturation current density of the dominant diode increase under illumination. A model based on interface recombination can explain these results. This model allows the estimation of diffusion voltage, capture cross-section of holes at the interface and mobility of electrons in the CdS layer.     

Impacts of conservation agriculture on soil aggregation and aggregate-associated N under an irrigated agroecosystem of the Indo-Gangetic Plains

We evaluated impacts of conservation agriculture (zero tillage, bed planting and residue retention) on changes in total soil N (TSN) and aggregate-associated N storage in a sandy loam soil of the Indo-Gangetic Plains. Cotton (Gossypium hirsutum) and wheat (Triticum aestivum) crops were grown during the first 3 years (2008–2011) and in the last year, maize (Zea mays) and wheat were cultivated. Results indicate that after 4 years the plots under zero tillage with bed planting (ZT-B) and zero tillage with flat planting (ZT-F) had 15 % higher TSN concentrations than conventional tillage and bed planting plots (CT-B) (0.63 g kg^?1 soil) in the 0–5 cm soil layer. CT-B plots had lower soil bulk density that ZT plots in that layer. Plots under ZT-B (0.57 Mg ha^?1) contained 20 % higher TSN stock in the 0–5 cm soil layer than CT-B plots (0.48 Mg ha^?1). However, tillage had no impact on TSN concentration or stock in the sub-surface (5–15 and 15–30 cm) soil layers. Thus, in the 0–30 cm soil layer, ZT-B plots contained 6 and 5 % higher (P > 0.05) TSN stock compared with CT-B (2.15 Mg N ha^?1) and CT-F (2.19 Mg N ha^?1) plots respectively after 4 years. Plots that received cotton/maize + wheat residue (C/M + W RES) contained 16 % higher TSN concentration than plots with residues removed (N RES; 0.62 g kg^?1 soil) in the surface (0–5 cm) layer. Plots with only cotton/maize residue (C/M RES) or only wheat residue (W RES) retention/incorporation had similar TSN concentrations and stocks in the subsurface layer. Plots under ZT-B also had more macroaggregates (0.25–8 mm) and greater mean weight diameter with lower silt + clay sized particles than CT-B plots in that layer. A greater proportion of large macroaggregates (2–8 mm) in the plots under C/M + W RES compared with N RES were observed. In the 5–15 cm soil layer ZT-B and C/M + W RES treated plots had more macroaggregates and greater mean weight diameter than CT-B and N RES treated plots, respectively. Because of the greater amount of large aggregates, plots under ZT-B and C/M + W RES had 49 and 35 % higher large macroaggregate-associated N stocks than CT-B (38 kg TSN ha^?1) and N RES (40 kg TSN ha^?1) plots, respectively, in the 0–5 cm soil layer, although aggregates had similar TSN concentrations in all plots. Both tillage and residue retention had greater effects on aggregate-associated N stocks in the 5–15 cm layers. In addition to N content within large macroaggregates, small macroaggregate-associated N contents were also positively affected by ZT-B and C/M + W RES. Tillage and residue retention interaction effects were not significant for all parameters. Thus, the adoption of ZT in permanent beds with crop residue addition is a better management option for improvement of soil N (and thus possibly a reduced dose of fertilizer N can be adopted in the long run), as the management practice has the potential to improve soil aggregation with greater accumulation of TSN within macroaggregates, and this trend would likely have additive effects with advancing years of the same management practices in this region.     

Correction to: Synthesis of Co3O4 @ Organo/Polymeric Bentonite Structures as Environmental Photocatalysts and Antibacterial Agents for Enhanced Removal of Methyl Parathion and Pathogenic Bacteria

Journal of Inorganic and Organometallic Polymers and Materials -     

Effects of compression on water distribution in gas diffusion layer materials of PEMFC in a point injection device by means of synchrotron X-ray imaging

In this study, ex-situ experiments performed with a point injection device are conducted to evaluate water distributions in gas diffusion layer (GDL) materials which serve as porous transport media in polymer electrolyte membrane fuel cells (PEMFCs). In this regard, GDL samples manufactured by SGL Group are placed into the point injection device and visualized by means of synchrotron X-ray radiographic and tomographic imaging. The resulting image data undergoes a coordinate transformation that ascertains water agglomerations in GDL pores with regard to their radial displacements from the injection point. In this way, water transport in two different GDL samples possessing the same structural characteristics, but with unique compression rates, are investigated in terms of in-plane water distribution. The radial displacement analysis indicated that the pore saturation of the compressed GDL is higher in both the micro porous layer (MPL) region and the carbon fiber substrate region than that of the uncompressed GDL. The water agglomerations in the uncompressed GDL are predominantly observed in the vicinity of the injection point, indicating a limited in-plane transport. Conversely, in the compressed case water accumulations are detected far from the injection point, even at the edge of the GDL, pointing out that compression promotes the in-plane transport. Prior to the ex-situ experiments, both GDL samples have undergone an ageing procedure to mimic realistic cell operating conditions.     

Fill factor losses in ZnO/CdS/CuGaSe2 single-crystal solar cells

Current–voltage characteristics of ZnO/CdS/CuGaSe₂ single-crystal solar cells with solar conversion efficiency values of η=3.5%, 6.0%, 6.7% and 9.7% were analyzed using the single diode equation. The effect of each of the achieved parameters on the fill factor was calculated. The calculations revealed that the fill factor reduction due to the series resistance remained below Δff=4.4% under illumination, while this effect would have been much higher if the illumination had not reduced the series resistance markedly. The calculation furthermore revealed that the fill factor reduction due to the shunt resistance remained below Δff=3.6% under illumination. This effect would have been negligible if the illumination had not also reduced the shunt resistance in all studied cells. The increase of the saturation current density under illumination has brought about considerably high fill factor losses (at least Δff=8.3%) in all studied cells. Already the dark saturation current density and the diode ideality factor in such cells have been found to be much higher than the ones in the cells based on CuInSe₂. This seems to be the most substantial restriction to the fill factor, and thus to the performance, of solar cells based on CuGaSe₂. An explanation for this different behavior seems to lie in the different band structures of these cells.     

Novel dynamic semiempirical proton exchange membrane fuel cell model incorporating component voltages

This paper introduces a novel dynamic semiempirical model for the proton exchange membrane fuel cell (PEMFC). The proposed model not only considers the stack output voltage but also provides valid waveforms of component voltages, such as the no‐load, activation, ohmic, and concentration voltages of the PEMFC stack system. Experiments under no‐load, ramping load, and dynamic load conditions are performed to obtain various voltage components. According to experimental results, model parameters are optimised using the lightning search algorithm by providing valid theoretical ranges of parameters to the lightning search algorithm code. In addition, the correlation between the vapour and water pressures of the PEMFC is obtained to model the component voltages. Finally, all component voltages and the stack output voltage are validated by using the experimental/theoretical waveforms mentioned in previous research. The proposed model is also compared with a recently developed semiempirical model of PEMFC through particle swarm optimisation. The proposed dynamic model may be used in future in‐depth studies on PEMFC behaviour and in dynamic applications for health monitoring and fault diagnosis.     

Specifying the Optimal Transmission Manner in WSNs: Analysis and Simulation

Wireless Personal Communications - Employing multi-hop transmission (MH) in wireless sensor networks achieves the uniform distribution of energy cost between nodes. However, the minimum energy cost...     

Mixing of low-dose cohesive drug and overcoming of pre-blending step using a new gentle-wing high-shear mixer granulator

The objective of this study was to examine the influence of drug amount and mixing time on the homogeneity and content uniformity of a low-dose drug formulation during the dry mixing step using a new gentle-wing high-shear mixer. Moreover, the study investigated the influence of drug incorporation mode on the content uniformity of tablets manufactured by different methods. Albuterol sulfate was selected as a model drug and was blended with the other excipients at two different levels, 1% w/w and 5% w/w at impeller speed of 300?rpm and chopper speed of 3000?rpm for 30?min. Utilizing a 1?ml unit side-sampling thief probe, triplicate samples were taken from nine different positions in the mixer bowl at selected time points. Two methods were used for manufacturing of tablets, direct compression and wet granulation. The produced tablets were sampled at the beginning, middle, and end of the compression cycle. An analysis of variance analysis indicated the significant effect (p?相似文献   

Exhaust emission profiling of fatty acid methyl esters and NOx control studies using selective synthetic and natural additives

Clean Technologies and Environmental Policy - The present study was focused on the optimized biodiesel production using Moringa oleifera (M. oleifera) and rice bran oils, characterization, and...