Physicochemical Properties of Different Types of Starch Phosphate Monoesters

Different types of starch were phosphorylated to different degrees of substitution using monosodium and disodium hydrogen orthophosphate at 160 °C under vacuum. Generally, phosphation enhanced the physicochemical properties of the modified starches compared to their native counterparts. Solubility and swelling power greatly increase when phosphorylation was carried out to a low degree of substitution, while the solubility and swelling power decreased gradually by increasing the degree of substitution. However, the values of the monoesters were still higher than those of the corresponding native polysaccharides. Viscosities of different starch types except corn amylose showed the highest values at the lowest degree of substitution, when the degree of phosphation increased the viscosity values decreased. Native potato starch formed a clear paste (96% transmittance) due to the presence of phosphate groups while the paste clarity of potato starch decreased gradually by increasing the degree of phosphation. Generally, phosphorylation increased the light transmittance of the other starches investigated at the lowest degree of substitution but the clarity decreased by increasing the degree of substitution.     

Experimental Analysis of Punch-Through Conditions in Power P-I- N Diodes

Commercial power diodes are optimized to feature punch-through behavior. However, a tradeoff between the width and the doping level of the diode epitaxial layer leads to various levels of optimization. For a given breakdown voltage, a shorter epitaxial layer width leads to better transient performances. Device datasheets do not cover this issue and a simple experimental setup is presented to assess the optimization conditions inside the diode epitaxial layer. Three commercial devices are tested and experimental results are confronted to device simulations. A good agreement is found     

Modeling of Field Effect Transistor Channel as a Nonlinear Transmission Line for Terahertz Detection

This paper revisits the theory of operation of field effect transistor in the extremely high frequency scale, where the analysis has gone beyond the conventional cutoff frequency of the transistor. In this range, which is typically the terahertz (THz) and sub-terahertz range, the transistor blocks the high frequency signal and generates a rectified signal related to the input high frequency signal. An analytical model is derived for the channel of the FET in the linear mode of operation in non-resonant THz detection conditions. A transmission line distributed circuit model is applied. This is, from the authors’ point of view, the suitable model for high frequency non-quasi static operation and the characteristic parameters of this model are derived from the differential equation governing the electron gas in the channel. A comparison is presented for the calculated photoresponse with previously published experimental one showing good agreement away from the threshold potential. Finally, the effects of coupling between the present model and the external input circuit have been taken into account including the loading effects of the antenna and a discussion is given for the effect on frequency selectivity of the FET.     

Distributed Simulation and Middleware for Networked UAS

As a result of the advances in solid state, electronics, sensor, wireless communication technologies, as well as evolutions in the material science and manufacturing technologies, unmanned aerial vehicles (UAVs) and unmanned aerial systems (UAS) have become more accessible by civilian entities, industry, as well as academia. There is a high level of market driven standardisation in the electronics and mechanical components used on UAVs. However, the implemented software of a UAS does not exhibit the same level of standardisation and compartmentalisation. This is a major bottleneck limiting software maintenance, and software reuse across multiple UAS programs. This paper addresses the software development processes adapted by the Australian Centre for Field Robotics (ACFR) in major UAS projects. The presented process model promotes software reuse without sacrificing the reliability and safety of the networked UAS with particular emphasis on the role of distributed simulation and middleware in the development and maintenance processes.     

Rigorous comparison of parabolically tapered and conventional multimode-interference-based 3-dB power splitters in InGaAsP/InP waveguides

Design issues such as optical transmission, interference mechanisms, the splitting ratio, the polarization dependence, and the fabrication tolerances of a compact parabolically tapered multimode-interference (MMI)-based 3-dB power splitter on an InP-based deeply etched ridge waveguide, by use of the finite-element-based beam-propagation method, are presented. The benefits and drawbacks of the use of the tapered structure, in comparison with an untapered MMI-based 3-dB splitter, have also been investigated.     

Effect of various steps of purification on ash content and ash constitution of cellulose. I. Cellulose prepared from cotton linters

The effect of the various steps of purification on the ash content and ash constitution of cellulose prepared from cotton linters has been examined. After each step of purification, samples were analysed for total ash, SiO₂, Ca, Mg, Fe, Al, Cu and Mn. Two methods of bleaching were investigated. The first involves double treatment of cellulose with sodium hypochlorite solution, and the second one treatment with hypochlorite followed by another treatment with sodium chlorite solution. The second method has a better effect in diminishing the ash content.     

A physically based diode model for circuit simulation

A physically based power PiN diode model is presented. Eigen value internal approximation method is used to solve the ambipolar diffusion equation. This model is implemented in SIMPLORER circuit simulator using VHDL‐AMS language. The proposed model can be used in both circuit simulators and the optimization of a given power PiN diode. Good agreement is obtained by comparing the results of the suggested model with experimental data. Copyright © 2013 John Wiley & Sons, Ltd.     

Nanosecond dynamics of phase transitions in chromophoredoped ferroelectric crystals

The microscopic dynamics of phase transitions in ferroelectric crystals are studied using time-resolved fluorescence spectroscopy. Fluorescence decay times of the molecular probe tryptophan, embedded in the ferroelectric crystals potassium dihydrogen phosphate (KDP) and triglycine sulfate (TGS), are measured over a large temperature range. The dependence of the lifetime data on temperature were different between the two crystals. The magnitude of the fluorescence lifetime shows a rapid change around the phase transition temperature in KDP, while the changes in the lifetime data of the TGS crystal have been smooth. The data indicate that the order of the phase transition in solids (first or second) can be recovered using this technique. Since fluorescence lifetime is related to the dynamic interactions between the chromophore and the environment, insight into the emergence of macroscopic phase transition behavior from microscopic fluctuations near the phase transition region may be realized.     

ANN-Based STATCOM Tuning for Performance Enhancement of Combined Wind Farms

Although the wind farms based on squirrel cage induction generators (SCIG) is cheaper than the wind farms based on doubly fed induction generators (DFIG), it is always in desperate need for reactive power compensation. Nevertheless, the wind farms based on DFIG are expensive compared with the SCIG wind farm, it features by its ability to control the active power independent of reactive power. However, combined wind farm (CWF) has been developed to collect the benefits of SCIG and DFIG wind turbines in the same wind farm. In this article, artificial neural network (ANN) is used to evaluate gain parameters of static synchronous compensator (STATCOM) in order to improve the stability performance of CWF. The impact of tuned STATCOM on the performance of CWF during gust wind speed and during three-phase fault is comprehensively investigated. The performance of CWF with STATCOM tuned by ANN is compared with its performance when the STATCOM tuned by the multiobjective genetic algorithm (MOGA) and whale optimization algorithm (WOA). The results show that the performance of CWF can be enhanced using STATCOM tuned by ANN more than MOGA and WOA.