硅晶片双面超精密化学机械抛光

为提高硅晶片双面超精密抛光的抛光速率,在分析双抛工艺过程基础上,采用自制大粒径二氧化硅胶体磨料配制了SIMIT8030-Ⅰ型新型纳米抛光液,在双垫双抛机台上进行抛光实验.抛光液、抛光前后厚度、平坦性能及粗糙度通过SEM、ADE-9520型晶片表面测试仪、AFM进行了表征.结果表明:与进口抛光液Nalco2350相比,SIMIT8030-Ⅰ型抛光液不仅提高抛光速率40%(14μm/h vs 10μm/h);而且表面平坦性TTV和TIR得到改善;表面粗糙度由0.4728nm降至0.2874nm,即提高抛光速率同时显著改善了抛光表面平坦性和粗糙度.     

二维地震过障碍观测系统模式及其参数设计

在二维地震勘探中,为了避免因地表障碍物使地震反射剖面出现间断现象,需要改变观测系统设计,跨越障碍物(江河、城镇等),以保证反射同相轴能连续追踪对比。在以往地震勘探中,有时因过障碍观测系统设计不合理,不但增加勘探费用,而且影响采集质量。因此只有科学合理地设计过障碍观测系统模式和参数,才能保证地震测线顺利通过障碍物,得到较好的障碍物下方的地震资料并降低勘探成本。为此本文在调查和研究大量野外实际的过障碍观测系统的基础上,总结归纳成三大类过障碍观测系统模式,并分析其特点和应用范围。采用图解法,推导出主要模式的跨越宽度、最小炮检距及最大炮检距等参数公式。采用这套过障碍观测模式不仅可以得到和障碍区两侧等质量的地震资料,而且可以有效地降低勘探成本。     

Patterns of knowledge production: The case of information and telecommunication sector in Korea

In recent years, the topic of knowledge production has been widely investigated in the advanced countries. However, the process by which knowledge is produced in the developing countries has not been fully explored or characterized. In Korea, the science and engineering fields strongly reflect systems of knowledge production in the universities and demonstrate the dynamics of systems of innovation for knowledge production. Through using a case study including data for knowledge production, in the field of information and telecommunication, the following general trends were observed. Firstly, there has been a trend towards increasing the capabilities for knowledge production, via domestic and foreign collaboration. Secondly, there has been an increasing trend towards the diversification of knowledge sources such as university-industry, and university-public research institutes. Finally, the establishment of a nation's knowledge base is influenced by governmental research and development policies. This revised version was published online in August 2006 with corrections to the Cover Date.     

A One‐Kilobit PQR‐CMOS Smart Pixel Array

The photonic quantum ring (PQR) laser is a three dimensional whispering gallery (WG) mode laser and has anomalous quantum wire properties, such as microampere to nanoampere range threshold currents and √T‐dependent thermal red shifts. We observed uniform bottom emissions from a 1‐kb smart pixel chip of a 32×32 InGaAs PQR laser array flip‐chip bonded to a 0.35 µm CMOS‐based PQR laser driver. The PQR‐CMOS smart pixel array, now operating at 30 MHz, will be improved to the GHz frequency range through device and circuit optimization.     

A QoS management framework for distributed multimedia systems

This paper proposes a high‐performance connection management architecture to design a common QoS framework applied to an ATM network based on the Open Distributed Processing (ODP) concept. We design the QoS framework in accordance from the RM‐ODP information and computational viewpoints. Copyright © 2003 John Wiley & Sons, Ltd.     

Extraction of penicillin G from simulated media by an emulsion liquid membrane process

The extraction of penicillin G from simulated media was performed by water/oil/water (w/o/w) emulsion liquid membranes (ELMs) and studied under various operational conditions in a batch system. The degree of extraction achieved was between 80% and 95% under specific conditions. A concentration of greater than nine times the initial concentration of penicillin G in the external phase was obtained in the internal phase. The pH of the internal aqueous solution, containing a basic salt, was theoretically calculated on the basis of the amount of penicillin G transported into the internal phase. The calculated results agreed with the experimental data well and were used to select a suitable type and concentration of a basic salt in the internal phase to give a pH within the range 5 to 8 where penicillin G was stable after the termination of extraction. The extraction of penicillin G was successfully performed by the ELM process with sodium carbonate in the internal phase.     

有杆泵抽油系统可靠性分析

抽油机井有杆果采油装置检泵故障数据的特点在于相邻两次检泵间隔之间的时间并非总是来自同一总体，可能有某种趋势的变化。通过对故障数据的趋势性检验，可验证其对某一随机过程模型的适应性，从而判定某一口井或某一批工况大致相同油井的运行可靠性，实现对生产井运行可靠性的定量评估。还通过实例说明了有杆泵抽油系统检泵故障数据的可靠性分析方法。     

Monolithic SiGe Up‐/Down‐Conversion Mixers with Active Baluns

The purpose of this paper is to describe the implementation of monolithically matching circuits, interface circuits, and RF core circuits to the same substrate. We designed and fabricated on‐chip 1 to 6 GHz up‐conversion and 1 to 8 GHz down‐conversion mixers using a 0.8 µm SiGe hetero‐junction bipolar transistor (HBT) process technology. To fabricate a SiGe HBT, we used a reduced pressure chemical vapor deposition (RPCVD) system to grow a base epitaxial layer, and we adopted local oxidation of silicon (LOCOS) isolation to separate the device terminals. An up‐conversion mixer was implemented on‐chip using an intermediate frequency (IF) matching circuit, local oscillator (LO)/radio frequency (RF) wideband matching circuits, LO/IF input balun circuits, and an RF output balun circuit. The measured results of the fabricated up‐conversion mixer show a positive power conversion gain from 1 to 6 GHz and a bandwidth of about 4.5 GHz. Also, the down‐conversion mixer was implemented on‐chip using LO/RF wideband matching circuits, LO/RF input balun circuits, and an IF output balun circuit. The measured results of the fabricated down‐conversion mixer show a positive power conversion gain from 1 to 8 GHz and a bandwidth of about 4.5 GHz.     

Shortest path algorithms: A computational study with the C programming language

The main purpose of this study is to evaluate the computational efficiency of algorithms for calculating shortest paths when they are correctly coded by using the C programming language. The eight algorithms that we selected for this experiment are the most efficient, either measured in terms of worst-case bounds or marked as such from previous computational studies; they include the redistributive heap algorithm. We suggest computer implementations that use the full power of C. In particular, the network representation and the various data structures used to keep the scan eligible list may be managed by using only additions and no multiplications, while it is not possible with FORTRAN. These capabilities, unique to C, yield several interesting conclusions: one may expect to speed up a shortest path algorithm by a factor of 20%; in some cases, this factor may reach 30%. Interestingly, the level of programming difficulty required to achieve these benefits is not greater than that required by implementations using arrays.