Catalytic partial oxidation of methane to synthesis gas in a ceramic membrane reactor

Methane has been selectively converted to synthesis gas using a two-zone fixed bed of a Ni/Al₂O₃ catalyst inside a modified ceramic membrane. The first zone of the reactor was surrounded by an impervious wall, and therefore behaved as a conventional fixed bed reactor. In the second zone, some of the reaction products could preferentially diffuse out of the reactor, which yielded higher than equilibrium methane conversions. The influence of the different operating conditions has been studied, and the performance of the membrane reactor has been compared to that of a fixed bed reactor. The membrane reactor has also been used at pressures above atmospheric (2 bar), with good conversions and selectivities.     

Structure and Properties of Long-Wavelength-Transmitting Halide Glasses

The lower halides of zinc, namely, ZnCl₂, ZnBr₂, and ZnI₂, may act as network formers in glasses that also contain modifying alkali halides such as KCI, KBr, KI, NaI, or CsI. Compositions which contain only Br⁻ or I⁻ anions are of particular interest because of their extended infrared transmission, which includes the ∼10-μm region, in addition to full visible transparency. A series of modified zinc halide glasses were prepared and characterized by differential scanning calorimetry, middle and far Fourier transform infrared spectroscopy, and polarized Raman spectroscopy. T _g values were characteristically low, around 40°C. Bulk glass infrared transmission up to 15 to 20 μm was recorded. The most probable glass structures are discussed and compared to oxide glass models. An attenuation of  0.001 dB/km has been projected as a possible intrinsic minimum for optical fibers operating near ∼6 μm.     

Miscibility and morphology of poly(vinylidene fluoride)/poly[(vinylidene fluoride)‐ran‐trifluorethylene] blends

This study presents an investigation of the effect of the different crystalline phases of each blend component on miscibility when blending poly(vinylidene fluoride) (PVDF) and its copolymer poly[(vinylidene fluoride)‐ran‐trifluorethylene] [P(VDF–TrFE)] containing 72 mol % of VDF. It was found that, when both components crystallized in their ferroelectric phase, the PVDF showed a strong effect on the crystallinity and phase‐transition temperature of the copolymer, indicating partial miscibility in the crystalline state. On the other hand, immiscibility was observed when both components, after melting, were crystallized in their paraelectric phase. In this case, however, a decrease in crystallization temperatures suggested a strong interaction between monomers in the liquid state. Blend morphologies indicated that, in spite of the lack of miscibility in the crystalline state, there is at least miscibility between PVDF and P(VDF–TrFE) in the liquid state, and that a very intimate mixture of the two phases on the lamellar level can be maintained upon crystallization. © 2002 Wiley Periodicals, Inc. J Appl Polym Sci 85: 1362–1369, 2002     

Off-line optimization and control for real time integration of a three-phase hydrogenation catalytic reactor

In order to develop and test the integration procedure, in this paper a real time process integration involving the optimization and control of the process is presented, in this case, with the two-layer approach. The used optimization algorithms were Levenberg–Marquardt and SQP that solve a non-linear least square problem subject to bounds on the variables. The two-layer approach is a hierarchical control structure where an optimization layer calculates the set points and manipulated variables to the advanced controller, which is based on the dynamic matrix control with constraints (QDMC). The non-isothermal dynamic model of the three-phase slurry catalytic reactor with appropriate solution procedure was utilized in this work (Vasco de Toledo, E. C., Santana, P. L., Maciel, M. R. W., & Maciel Filho, R. (2001). Dynamic modeling of a three-phase catalytic slurry reactor. Chemical Engineering Science, 56, 6055–6061). The model consists on mass and heat balance equations for the catalyst particles as well as for the bulk phases of gas and liquid. The model was used to describe the dynamic behavior of hydrogenation reaction of o-cresol to obtain 2-methil-cyclohexanol, in the presence of a catalyst Ni/SiO₂.     

Update on the pharmacology of Spirulina (Arthrospira), an unconventional food

Spirulina (Arthrospira), a filamentous, unicellular alga, is a cyanobacterium grown in certain countries as food for human and animal consumption. It is also used to derive additives in pharmaceuticals and foods. This alga is a rich source of proteins, vitamins, amino acids, minerals, and other nutrients. Its main use, therefore, is as a food supplement. Over the last few years, however, it has been found to have many additional pharmacological properties. Thus, it has been experimentally proven, in vivo and in vitro that it is effective to treat certain allergies, anemia, cancer, hepatotoxicity, viral and cardiovascular diseases, hyperglycemia, hyperlipidemia, immunodeficiency, and inflammatory processes, among others. Several of these activities are attributed to Spirulina itself or to some of its components including fatty acids omega-3 or omega-6, beta-carotene, alpha-tocopherol, phycocyanin, phenol compounds, and a recently isolated complex, Ca-Spirulan (Ca-SP). This paper aims to update and critically review the results published over the last few years with regards to these properties. The conclusion is that even if this cyanobacterium has been one of the most extensively studied from the chemical, pharmacological and toxicological points of view, it is still necessary to expand the research in order to have more consistent data for its possible use in human beings.     

Effect of vanadium and chromium on the microstructural features of V–Cr–Mn–Ni spheroidal carbide cast irons

The objective of this investigation is to study the influence of vanadium（5.0wt%–10.0wt%） and chromium（0–9.0wt%） on the microstructure and hardness of Cr-V-Mn-Ni white cast irons with spheroidal vanadium carbides. The alloys＇ microstructural features are presented and discussed with regard to the distribution of phase elements. The structural constituents of the alloys are spheroidal VC, proeutectoid cementite, ledeburite eutectic, rosette-shaped carbide eutectic（based on M7C3）, pearlite, martensite, and austenite. Their combinations and area fraction（AF） ratios are reported to be influenced by the alloys＇ chemical composition. Spheroidized VC particles are found to be sites for the nucleation of carbide eutectics. Cr and V are shown to substitute each other in the VC and M7C3 carbides, respectively. Chromium alloying leads to the formation of a eutectic（γ-Fe ＋ М7С3）, preventing the appearance of proeutectoid cementite in the structure. Vanadium and chromium are revealed to increase the total carbide fraction and the amount of austenite in the matrix. Cr is observed to play a key role in controlling the metallic matrix microstructure.     

Fabrication of hybrid proton-exchange membranes using a brandnew high temperature ionic liquid as charge transporting and clay modifier

The search for more compatibility between ionic liquids (ILs) and polymer matrices in proton-exchange membrane fuel cells (PEMFCs) is one of the ways in which IL leaking from proton-exchange membranes could be minimized. In this work, it is presented the synthesis of an aromatic high temperature ionic liquid (HTIL), which, incorporated into an aromatic matrix such as sulfonated polyether ether ketone (sPEEK), is expected to diminish the IL leaking that normally affects PEMFC. Phenylethylammonium trifluoromethane sulfonate (PhetaTfO) was successfully synthesized and characterized. Its melting point of 88°C makes it to classify as a HTIL and it was employed as modifier of natural Montmorillonite, forming the phenylethylammonium intercalated montmorillonite (MmtPheta) and thus, ternary membranes containing PhetaTfO, MmtPheta, and sPEEK were prepared and characterized. Immersion tests demonstrated a higher compatibility of PhetaTfO with matrix when compared to the reference DemaTfO, which was reflected in up to 30% lower IL loss by the synthesized IL than the DemaTfO; X-rays diffraction (XRD) patterns demonstrated that the modified clay was properly dispersed inside the membranes, while dynamic mechanical analyses (DMA) results indicated a strong plasticizer effect along the increase of PhetaTfO content inside the membrane, while at the same time, the conductivity increased in an exponential manner, which permitted to identify an empiric exponential equation to evaluate the effect of concentration on ionic conductivity. The maximum conductivity obtained at IL concentrations of around 38 wt% was 0.2 mS/cm. It could expect high ionic conductivities of 10 mS/cm when the concentration of this IL is 60%; nevertheless, in order to achieve that, crosslinking treatments should be done to give the membranes enough mechanical resistance.     

When a Tritrophic Interaction Goes Wrong to the Third Level: Xanthoxylin From Trees Causes the Honeybee Larval Mortality in Colonies Affected by the River Disease

The “River Disease” (RD), a disorder impacting honeybee colonies located close to waterways with abundant riparian vegetation (including Sebastiania schottiana, Euphorbiaceae), kills newly hatched larvae. Forager bees from RD-affected colonies collect honeydew excretions from Epormenis cestri (Hemiptera: Flatidae), a planthopper feeding on trees of S. schottiana. First-instar honeybee larvae fed with this honeydew died. Thus, we postulated that the nectars of RD-affected colonies had a natural toxin coming from either E. cestri or S. schottiana. An untargeted metabolomics characterization of fresh nectars extracts from colonies with and without RD allowed to pinpoint xanthoxylin as one of the chemicals present in higher amounts in nectar from RD-affected colonies than in nectars from healthy colonies. Besides, xanthoxylin was also found in the aerial parts of S. schottiana and the honeydew excreted by E. cestri feeding on this tree. A larva feeding assay where xanthoxylin-enriched diets were offered to 1^st instar larvae showed that larvae died in the same proportion as larvae did when offered enriched diets with nectars from RD-colonies. These findings demonstrate that a xenobiotic can mimic the RD syndrome in honeybee larvae and provide evidence of an interspecific flow of xanthoxylin among three trophic levels. Further, our results give information that can be considered when implementing measures to control this honeybee disease.

     

Alternative technique for hydroxyapatite coatings

Flame Assisted Chemical Vapor Deposition (FACVD), a novel technique that shows an enormous potential in porous oxides deposition, was employed for the first time aiming to obtain hydroxyapatite (HA) coatings on 316 L stainless steel metallic substrates. Calcium acetate and ammonium phosphate diluted in ethanol were employed as precursor salts. A Ca/P molar ratio of 1.66 was employed in precursor solution, which is equivalent to stoichiometric hydroxyapatite. A porous coating, formed by an open and interconnected network, was observed by scanning electronic microscopy (SEM) and associated with homogenous reactions. Thickness of hydroxyapatite coating was 412 ± 3 μm. X-ray diffraction (XRD) analysis indicated the presence of crystalline coatings, mainly constituted by hydroxyapatite phase and traces of tricalcium phosphate (β-TCP). Carbonate in the hydroxyapatite coatings was identified by Fourier transform-infrared (FTIR) spectroscopy.