Novel one-step route for synthesizing sub-micrometer PSt hollow spheres via redox interfacial-initiated method in inversed emulsion

Interfacial-initiated polymerization of styrene (St) was carried out in inversed emulsion with cumene hydroperoxide (CHPO) and ferrous sulfate (FeSO₄)/disodium ethylenediaminetetraacetate (NaEDTA)/sodium formaldehyde sulfoxylate (SFS) as the redox initiation system. The water-soluble Fe²⁺-NaEDTA-SFS acted as the reducing component and the oil-soluble CHPO as the oxidant component of the redox initiation system. Therefore, the primary radicals were produced mainly at the oil/water interface to initiate the polymerization of St. Thus, sub-micrometer hollow polystyrene (PSt) spheres were obtained by one-stage polymerization, which was supported by the techniques of transmission electron microscopy (TEM) and field emission scanning electron microscopy (FESEM).     

N-Type Field-Effect Transistors Using Multiple Mg-Doped ZnO Nanorods

Nanorod field-effect transistors (FETs) that use multiple Mg-doped ZnO nanorods and a SiO₂ gate insulator were fabricated and characterized. The use of multiple nanorods provides higher on-currents without significant degradation in threshold voltage shift and subthreshold slopes. It has been observed that the on-currents of the multiple ZnO nanorod FETs increase approximately linearly with the number of nanorods, with on-currents of ~1 muA per nanorod and little change in off-current (~4times10^-12). The subthreshold slopes and on-off ratios typically improve as the number of nanorods within the device channel is increased, reflecting good uniformity of properties from nanorod to nanorod. It is expected that Mg dopants contribute to high n-type semiconductor characteristics during ZnO nanorod growth. For comparison, nonintentionally doped ZnO nanorod FETs are fabricated, and show low conductivity to compare with Mg-doped ZnO nanorods. In addition, temperature-dependent current-voltage characteristics of single ZnO nanorod FETs indicate that the activation energy of the drain current is very low (0.05-0.16 eV) at gate voltages both above and below threshold     

2D Image Construction from Low Resolution Response of a New Non‐invasive Measurement for Medical Application

This paper presents an application of digital signal processing to data acquired by the radio imaging method (RIM) that was adopted to measure moisture distribution inside the human body. RIM was originally developed for the mining industry; we are applying the method to a biomedical measurement because of its simplicity, economy, and safety. When a two‐dimensional image was constructed from the measured data, the method provided insufficient resolution because the wavelength of the measurement medium, a weak electromagnetic wave in a VHF band, was longer than human tissues. We built and measured a phantom, a model simulating the human body, consisting of two water tanks representing large internal organs. A digital equalizer was applied to the measured values as a weight function, and images were reconstructed that corresponded to the original shape of the two water tanks. As a result, a two‐dimensional image containing two individual peaks corresponding to the original two small water tanks was constructed. The result suggests the method was applicable to biomedical measurement by the assistance of digital signal processing. This technique may be applicable to home‐based medical care and other situations in which safety, simplicity, and economy are important.     

浅谈江西电网稳定装置的配置

对江西电网稳定控制系统的发展历程、现状作了简要的回顾，并提出了部分建议。     

Bias-temperature instabilities of polysilicon gate HfO/sub 2/ MOSFETs

Bias-temperature instabilities (BTI) of HfO/sub 2/ metal oxide semiconductor field effect transistors (MOSFETs) have been systematically studied for the first time. NMOS positive BTI (PBTI) exhibited a more significant V/sub t/ instability than that of PMOS negative BTI (NBTI), and limited the lifetime of HfO/sub 2/ MOSFETs. Although high-temperature forming gas annealing (HT-FGA) improved the interface quality by passivating the interfacial states with hydrogen, BTI behaviors were not strongly affected by the technique. Charge pumping measurements were extensively used to investigate the nature of the BTI degradation, and it was found that V/sub t/ degradation of NMOS PBTI was primarily caused by charge trapping in bulk HfO/sub 2/ rather than interfacial degradation. Deuterium (D/sub 2/) annealing was found to be an excellent technique to improve BTI immunity as well as to enhance the mobility of HfO/sub 2/ MOSFETs.     

A borrow-and-return model to reduce client waiting time for broadcasting-based VOD services

One way to broadcast a popular video is to use multiple channels, each broadcasting a portion of the video periodically. Among the many schemes falling in this category, this paper focuses on several representative schemes (such as FB, Pagoda, and RFS ), which all share a FSFC property by repeatedly broadcasting the first segment of the video on the first channel. We propose a general borrow-and-return model that can be immediately applied to any scheme owning the FSFC property to reduce the viewer's waiting time without increasing the number of channels required. Given a group of videos, the basic idea is to lend the free time slots of videos without viewers to those videos with viewers to speedup the latter's transmission. By so doing, some bandwidth may be vacated by the borrowing videos to benefit others' transmission. The effectiveness of this model is analyzed by applying it to the FB scheme.     

WLAN chip antenna mountable above the system ground plane of a mobile device

A novel wireless local-area network (WLAN) chip antenna suitable to be mounted above the system ground plane of a mobile device is presented. The antenna in the study is easily fabricated from folding a single metal plate onto a foam base, and mainly comprises a short-circuited radiating strip and an antenna ground. The antenna ground occupies the bottom surface and two adjacent side surfaces of the foam base. When the antenna is mounted at the corner of the system ground plane, this antenna ground structure is expected to effectively reduce the antenna's possible fringing electromagnetic fields inside the mobile device. In this case, when the associated element such as the radio-frequency shielding metal case is placed under the proposed antenna, small or negligible variations in the antenna performance are obtained. Design considerations of the proposed antenna for WLAN operation in the 2.4 GHz band are described, and results of the constructed prototypes are presented.     

基于模糊理论的江垭水库移民安置区模式优选

水库移民安置区的优化选择关系到移民社区未来的社会稳定和可持续发展。为此,对影响移民安置区的指标体系进行了研究,利用模糊理论建立了优选模型,并通过江垭水库移民安置区的实际情况对模型进行了验证。结果表明,研究采用的指标体系和方法可满足移民安置区优选的需要。     

Design and analysis of low-power cache using two-level filter scheme

Power consumption is an increasingly pressing problem in modern processor design. Since the on-chip caches usually consume a significant amount of power, it is one of the most attractive targets for power reduction. This paper presents a two-level filter scheme, which consists of the L1 and L2 filters, to reduce the power consumption of the on-chip cache. The main idea of the proposed scheme is motivated by the substantial unnecessary activities in conventional cache architecture. We use a single block buffer as the L1 filter to eliminate the unnecessary cache accesses. In the L2 filter, we then propose a new sentry-tag architecture to further filter out the unnecessary way activities in case of the L1 filter miss. We use SimpleScalar to simulate the SPEC2000 benchmarks and perform the HSPICE simulations to evaluate the proposed architecture. Experimental results show that the two-level filter scheme can effectively reduce the cache power consumption by eliminating most unnecessary cache activities, while the compromise of system performance is negligible. Compared to a conventional instruction cache (32 kB, two-way) implemented with only the L1 filter, the use of a two-level filter can result in roughly 30% reduction in total cache power consumption. Similarly, compared to a conventional data cache (32 kB, four-way) implemented with only the L1 filter, the total cache power reduction is approximately 46%.