Toward homogeneous nanostructured polyaniline/resin blends

The high interest in applications of conducting polymers, especially polyaniline (PANI), makes it important to overcome limitations for effective usage due to poor processability and solubility. One promising approach is to make blends of PANI in polymeric resins. However, in this approach other problems related to the difficulty of achieving a homogeneous PANI dispersion arise. The present article is focused on this general problem, and we discuss how the synthesis method, choice of dopant and solvent as well as interfacial energies influence the dispersibility. For this purpose, different synthesis methods and dopants have been employed to prepare nanostructures of polyaniline. Dynamic light scattering analysis of dispersions of the synthesized particles in several solvents was employed in order to understand how the choice of solvent affects PANI aggregation. Further information on this subject was achieved by scanning electron microscopy studies of PANI powders dried from various solutions. On the basis of these results, acetone was found to be a suitable dispersion medium for PANI. The polymer matrix used to make the blends in this work is a UV-curing solvent-free resin. Therefore, there is no low molecular weight liquid in the system to facilitate the mixing process and promote formation of homogeneous dispersions. Thus, a good compatibility of the components becomes crucial. For this reason, surface tension and contact angle measurements were utilized for characterizing the surface energy of the PANI particles and the polyester acrylate (PEA) resin, and also for calculating the interfacial energy between these two components that revealed good compatibility within the PANI/PEA blend. A novel technique, based on centrifugal sedimentation analysis, was employed in order to determine the PANI particle size in PEA resin, and high dispersion stability of the PANI/PEA blends was suggested by evaluation of the sedimentation data.     

Impact of industrial discharges on the zooplankton community in the Messaieed industrial area,Qatar (Persian Gulf)

Zooplankton samples were collected from the Messaieed Marine Area that is subject to industrial and sewage discharge, thermal pollution, as well as oil loading and unloading activities. Copepods formed 74% of the zooplankton community followed by bivalves (7.6%) and Gastropod veligers (5.5%), Ostracods (4.7%) and Cladocera (3.4%). Industrial discharge not only impacted the total number of zooplankton but also species diversity. Diversity indices were higher for inner coastal waters. Pollution levels more than reduction in food source impacted the distribution of main zooplankton groups. The pollution stress changed the structure of zooplankton community rather than impacting the total population. Copepods showed resistance to oil pollution but were reduced in numbers at areas affected by oxygen demanding wastes. Polychaete larvae and Chaetognatha withstand elevated temperature, ammonia and pH levels.     

Predicting the risk of contractor default in Saudi Arabia utilizing artificial neural network (ANN) and genetic algorithm (GA) techniques

The construction project is subject to several risks, one of the most important of which is contractor default because contractor default may increase the final project cost considerably. In the US construction industry, owners commonly shield themselves from the risk of contractor default by transferring this risk to the contractor, who in turn transfers this risk to a surety company. On the other hand, the General Directorate of Military Works (GDMW) of the Kingdom of Saudi Arabia retains the risk of contractor default rather than transferring it to a third party. An artificial neural network (ANN) and a genetic algorithm (GA) are used in this study to predict the risk of contractor default in construction projects undertaken for the Saudi armed forces. Based on this prediction, the Saudi GDMW can make a decision to engage or not to engage the services of a contractor. In case the models are not able to generate reliable predictions (or generate contradictory outcomes), the GDMW will have to augment its budget with contingency funds to be used in the event of contractor default. The outcome of this study is of particular relevance to construction owners because it proposes an approach that can allow them to replace an indiscriminate blanket policy by a policy that is rational, effective, prudent and economical.     

Geochemical reactions resulting from in situ oxidation of PCE-DNAPL by KMnO4 in a sandy aquifer

Although the potential for KMnO4 to destroy chlorinated ethenes in situ was first recognized more than a decade ago, the geochemical processes that accompany the oxidation have not previously been examined. In this study, aqueous KMnO4 solutions (10-30 g/L) were injected into an unconfined sand aquifer contaminated by the dense non-aqueous-phase liquid (DNAPL) tetrachloroethylene (PCE). The effects of the injections were monitored using depth-specific, multilevel groundwater samplers, and continuous cores. Two distinct geochemical zones evolved within several days after injection. In one zone where DNAPL is present, reactions between KMnO4 and dissolved PCE resulted in the release of abundant chloride and hydrogen ions to the water. Calcite and dolomite dissolved, buffering the pH in the range of 5.8-6.5, releasing Ca, Mg, and CO2 to the pore water. In this zone, the aqueous Ca/Cl concentration ratio is close to 5:12, consistent with the following reaction for the oxidation of PCE in a carbonate-rich aquifer: 3C2Cl4 + 5CaCO3(s) + 4KMnO4 + 2H+ --> 11CO2 + 4MnO2(s) + H2O + 12Cl- + 5Ca2+ + 4K+. In addition to Mg from dolomite dissolution, increases in the concentration of Mg as well as Na may result from exchange with K at cation-exchange sites. In the second zone, where lesser amounts of PCE were present, KMnO4 persisted in the aquifer for more than 14 months, and the porewater pH increased graduallyto between 9 and 10 as a resultof reaction between KMnO4 and H2O. A small increase in SO4 concentrations in the zones invaded by KMnO4 suggests that KMnO4 injections caused oxidation of sulfide minerals. There are important benefits of carbonate mineral buffering during DNAPL remediation by in situ oxidation. In a carbonate-buffered system, Mn(VII) is reduced to Mn(IV) and is immobilized in the groundwater by precipitating as insoluble manganese oxide. Energy-dispersive X-ray spectroscopy analyses of the manganese oxide coatings on aquifer mineral grains have detected the impurities Al, Ca, Cl, Cu, Pb, P, K, Si, S, Ti, U, and Zn indicating that, similar to natural systems, precipitation of manganese oxide is accompanied by coprecipitation of other elements. In addition, the consumption of excess KMnO4 by reaction with reduced minerals such as magnetite will be minimized because the rates of these reactions increase with decreasing pH. Aquifer cores collected after the KMnO4 injections exhibit dark brown to black bands of manganese oxide reaction products in sand layers where DNAPL was originally present. Mineralogical investigations indicate that the manganese oxide coatings are uniformly distributed over the mineral grains. Observations of the coatings using transmission electron microscopy indicate that they are on the order of 1 microm thick, and consequently, the decrease in porosity through the formation of the coatings is negligible.     

The effect of gamma irradiation on the microbial load,mineral concentration and sensory characteristics of liquorice (Glycyrrhiza glabra L)

Ground liquorice roots were exposed to various doses (0, 5, 10, 15 and 20 kGy) of gamma radiation from a ⁶⁰Co source. Irradiated and non‐irradiated samples were stored at room temperature. Microbial population, viscosity, concentrations of some minerals and the sensory properties of the extracts were evaluated after 0 and 12 months of storage. Tests carried out immediately after irradiation showed that the microbial count had been reduced and that the dose required to reduce the count by 1 log cycle (D₁₀) was about 2 kGy. No effect was observed on the total dissolved solids in extracts of liquorice roots. Glycyrrhizinic acid concentration in the extracts and the viscosities of suspensions produced from irradiated roots were lower than those from non‐irradiated ones. Sensory evaluation indicated that there were no significant differences (P < 0.05) in colour, taste or flavour between extracts produced from irradiated and non‐irradiated roots. However, after 12 months of storage, some mineral ion (Na⁺, Ca²⁺ and K⁺) concentrations in extracts produced from irradiated roots were lower than in those from non‐irradiated ones; no significant differences (P < 0.05) in viscosity were found between suspensions of irradiated and non‐irradiated roots. © 2002 Society of Chemical Industry     

Framed slotted aloha based MAC protocol for low energy critical infrastructure monitoring networks

Recently, the IEEE TG4k has been formed to amend the IEEE 802.15 family to address the low energy critical infrastructure monitoring networks. The purpose is to facilitate point to multi‐thousands of point communication to collect the scheduled and event data from a large number of nonmains powered endpoints that are widely dispersed. It should support low energy operation, which is necessary for multiyear battery life. Other major features are application data rate up to 40 Kb/s, thousands of endpoints per mains powered infrastructure, asymmetric application data flow, small and infrequent messages, tolerant to data latency, etc. In this paper, we present a discussion on low energy critical infrastructure monitoring networks. We propose a medium access control protocol based on framed slotted aloha for these networks. We investigated probable packet sizes, energy consumptions, battery lifetime and the success rate for our protocol. The proposed protocol is simple to implement. Simulation results show that it is efficient in terms of packet success rate, energy consumption, and battery lifetime.Copyright © 2012 John Wiley & Sons, Ltd.     

Novel Heterogeneous Integration Technology of III–V Layers and InGaAs FinFETs to Silicon

Heterogeneous integration of III–V compound semiconductors to Si substrates is regarded as a necessary step for advancing high‐speed electronics and hybrid optoelectronic systems for data processing and communications, and is extensively being pursued by the semiconductor industry. Here, an innovative fab‐compatible, hybrid integration process of III–V materials to Si, namely InGaAs thin films to insulator‐on‐Si, is reported, and the first III–V FinFET devices on Si are demonstrated. Transfer of crystalline InGaAs layers with high quality to SiO2/Si is accomplished by the formation of a robust interfacial nickel‐silicide (NiSi) bonding interface, marking the first report for using silicides in III–V hybrid integration technology. The performance of optimally fabricated InGaAs FinFETs on insulator on Si is systematically investigated for a broad range of channel lengths and Fin perimeters with excellent switching characteristics. This demonstrates a viable approach to large‐scale hybrid integration of active III‐V devices to mainstream Si CMOS technology, enabling low‐power electronic and fully‐integrated optoelectronic applications.     

A Novel High Content Angiogenesis Assay Reveals That Lacidipine,L-Type Calcium Channel Blocker,Induces In Vitro Vascular Lumen Expansion

Angiogenesis is a critical cellular process toward establishing a functional circulatory system capable of delivering oxygen and nutrients to the tissue in demand. In vitro angiogenesis assays represent an important tool for elucidating the biology of blood vessel formation and for drug discovery applications. Herein, we developed a novel, high content 2D angiogenesis assay that captures endothelial morphogenesis’s cellular processes, including lumen formation. In this assay, endothelial cells form luminized vascular-like structures in 48 h. The assay was validated for its specificity and performance. Using the optimized assay, we conducted a phenotypic screen of a library containing 150 FDA-approved cardiovascular drugs to identify modulators of lumen formation. The screening resulted in several L-type calcium channel blockers being able to expand the lumen space compared to controls. Among these blockers, Lacidipine was selected for follow-up studies. We found that the endothelial cells treated with Lacidipine showed enhanced activity of caspase-3 in the luminal space. Pharmacological inhibition of caspase activity abolished the Lacidipine-enhancing effect on lumen formation, suggesting the involvement of apoptosis. Using a Ca²⁺ biosensor, we found that Lacipidine reduces the intracellular Ca²⁺ oscillations amplitude in the endothelial cells at the early stage, whereas Lacidipine blocks these Ca²⁺ oscillations completely at the late stage. The inhibition of MLCK exhibits a phenotype of lumen expansion similar to that of Lacidipine. In conclusion, this study describes a novel high-throughput phenotypic assay to study angiogenesis. Our findings suggest that calcium signalling plays an essential role during lumen morphogenesis. L-type Ca²⁺ channel blockers could be used for more efficient angiogenesis-mediated therapies.     

Morphological redescription and phylogenetic assessment of Spauligodon aspiculus (Oxyuroidea: Pharyngodonidae) infecting the white‐spotted gecko,Tarentola annularis (Squamata: Gekkonidae)

Thirty white‐spotted geckos, Tarentola annularis, from the South Sinai desert in Egypt, were examined for helminth parasites. Spauligodon aspiculus was observed to infect 19 geckos with 63.33% as a prevalence of parasitic infection. The present nematode species is separated from congeners by morphological and metrical characteristics such as lateral alae, aspinose filamentous tail, and no spicule, and three pairs of caudal papillae with posterior pair excluded from envelopment by the caudal alae in the male worms, and knobbed eggs, and postbulbar vulva in females. It compared morphometrically with other Spauligodon species described previously and showed few differences in measurements. Molecular characterization based on the partial 28S rRNA nuclear ribosomal gene sequence showed that there was a close identity, up to 72%, with other sequences retrieved from GenBank. Phylogenetic analysis showed that the parasite sequence in conjunction with existing data facilitates the investigation of the placement of this pharyngodonid species within Oxyuridae. The present species is deeply embedded in the genus Spauligodon with close relationships to previously described Spauligodon nicolauensis (gb| JN619349.1, and JF829243.1) as more related sister taxa. This study highlights the importance of combining genetic and morphological data with taxonomy in pharyngodonid species.