Recent development of nucleic acid drug

The dynamics of ovarian follicular development and the pattern of pituitary and ovarian hormone concentration were investigated during the luteal phase in ewes with autotransplanted ovaries. The follicles were measured by ultrasound and samples of ovarian and jugular venous blood were collected at intervals of 12 h. Blood samples were collected before and after a GnRH challenge (250 ng GnRH, i.v.) to allow the determination of basal and LH-stimulated concentration of ovarian steroids. Throughout the luteal phase, large antral follicles developed in three waves, each of which was preceded by a rise in the concentration of FSH (P < 0.05). The concentrations of oestradiol and androstenedione in the unstimulated and LH-stimulated samples were similar (P > 0.05) during the first 3 days of the luteal phase but differed thereafter, with the LH-stimulated being significantly higher than the basal concentrations (P < 0.05). In the first wave of follicular development the changes in follicular size were accompanied by an increase in the concentration of ovarian steroids and inhibin A. During the second follicular wave, although changes in follicle diameter were similar to the first wave (P > 0.05), the basal concentration of ovarian steroids and inhibin A remained unchanged throughout the period of emergence and demise of the large follicles. These results confirm that the development of large antral follicles during the luteal phase of the sheep occurs in successive waves that are associated with fluctuations in FSH secretion. However while the results strongly suggest that fluctuations in both inhibin A and oestradiol secretion control FSH during the first follicular wave, the cause of the FSH fluctuations associated with waves two and three is unclear. Final resolution of this issue may need to await the development of a specific assay for dimeric inhibin B.     

Surface structures of synthetic diamonds

Diamond crystals of about 2 mm in size were grown by the temperature gradient method using Ni, Ni-Fe alloy and Fe as solvent metals. Several characteristic patterns were seen on the surfaces of the grown diamonds and were found to correspond to the texture of the quenched solvent metals. A vague vein-like pattern appeared when Ni was used. The surface patterns became finer with the increase of the content of Fe in Ni-Fe alloy, and when 70 wt% Fe-30 wt% Ni alloy was used, very fine dendritic patterns were seen on all of the faces of diamond in accordance with the symmetries of the lattice. The patterns are formed by the precipitation of carbon atoms in the space of the dendrites of the solvent metals during the quenching process. Lamellar patterns and etch pits were seen when Fe was used. The patterns are formed when Fe dissolves the diamond surfaces to produce Fe₃C during the quenching process.     

Wortmannin, a specific inhibitor of phosphatidylinositol-3-kinase, inhibits erythropoietin-induced erythroid differentiation of K562 cells

We report a large kindred in which a punctate palmoplantar keratoderma (PPK) is associated with malignancy, including Hodgkin's disease, renal, breast, pancreatic and colonic adenocarcinomas. The family was traced through four generations, and over 320 individuals were identified, of whom 49 had punctate PPK. The punctate PPK appeared to be inherited as an autosomal dominant trait with variable penetrance. Ten of the 43 adults (23%) with punctate PPK developed malignancies, and five of these developed before the age of 50. Of the 271 unaffected individuals, six (2%) have developed malignancies, one prior to the age of 50. The association of keratoderma and malignancy is discussed.     

Improvement of the precision of the gradient method and object tracking using optical flow

In this study, the spatial local optimization method was improved to obtain high precision of optical flow for cases in which the object movement changes substantially and a method to trace the loci of moving objects was considered. In the spatial local optimization method, the precision of the optical flow when the object movement changes substantially becomes a problem. Therefore, to make the object movement relatively small, we obtained flow vectors from the image sequence to drop the resolution of the original input image sequence to half the initial resolution. flow vectors were then obtained from the original input image sequence that were smaller than the threshold value. We show that the precision of the optical flow when the object movement changes substantially is improved by this method. Method used to trace the loci of moving objects was demonstrated. We obtained clusters from histograms of flow vectors and pursued each cluster. We show that it is possible to trace moving objects by this method. This work was presented, in part, at the 7th International Symposium on Artificial Life and Robotics, Oita, Japan, January 16–18, 2002     

Rapid Desensitization of Lipolysis in the Visceral and Subcutaneous Adipocytes of Rats

In adipocytes, short and long term stimulation of β adrenergic receptors (βAR) induces the desensitization to catecholamines, leading to a decrease in the intracellular accumulation of cAMP, but the roles played by this in lipolysis is not clear. In this study, we assessed the catecholamine-induced desensitization of lipolysis and compared this in adipocytes isolated from visceral and subcutaneous fat tissues of rats. When adipocytes were pretreated with isoproterenol (ISO), the norepinephrine (NE)-induced lipolysis was significantly reduced dose- and time-dependently. A similar reduction of the lipolytic response was also found in NE-, dobutamine-, terbutaline- or BRL37344-induced lipolysis. The ISO- and each βAR agonist-induced lipolysis in the visceral fat was not only higher than in the subcutaneous fat, but also markedly reduced by ISO- or NE-pretreatment. These results showed that short-term treatment of three subtypes of βAR by each agonist induces a rapid reduction in the lipolytic response to βAR stimulation. This suggests some common mechanism for the rapid desensitization of βAR-agonist-induced lipolysis, in contrast with previous reports on the characteristics of βAR subtypes. In addition, the regional difference of adipose tissue not only in inducing lipolysis but also in rapid desensitization was also apparent.     

Extraction of Trivalent Rare Earths and Minor Actinides from Nitric Acid with N,N,N’,N’-Tetradodecyldiglycolamide (TDdDGA) by Using Mixer-Settler Extractors in a Hot Cell

Single-stage batch experiments to reveal the extraction properties of N,N,N’,N’-tetradodecyldiglycolamide (TDdDGA) for Y, La, Eu, Nd, and Am in nitric acid were carried out. The distribution ratios of Y, Eu, Nd, and Am exceeded 10 when the nitric acid concentration was 1–2 mol/dm³ (M), and the distribution ratio of La was 5.5 when the nitric acid concentration was 2 M. A continuous counter-current experiment using 0.1 M TDdDGA diluted with n-dodecane was performed using mixer-settler extractors installed in a hot cell. Nitric acid with a concentration of 2.1 M containing minor actinides (MAs: Am and Cm), rare earths (REs: Y, La, Nd, and Eu), and other fission products (Sr, Cs, Zr, Mo, Ru, Rh, and Pd) was fed to the extractor. TDdDGA effectively extracted MAs and REs from the feed, while other fission products were barely extracted. The extracted MAs and REs were back-extracted by bringing them in contact with 0.02 M nitric acid, and they were collected as the MA–RE fraction. The results indicated that more than 98% of Am and Cm in the feed were recovered in the MA–RE fraction. The proportions of Y, La, Nd, and Eu in the MA–RE fraction were 94.0%, 99.9%, 99.9%, and 86.9%, respectively.     

Preparation of Porous Cr3C2 Grains with Cr2O3

Porous Cr₃C₂ grains (∼300 to 500 μm) with ∼10 wt% of Cr₂O₃ were prepared by heating a mixture of MgCr₂O₄ grains and graphite powder at 1450° to 1650°C for 2 h in an Al₂O₃ crucible covered by an Al₂O₃ lid with a hole in the center. The porous Cr₃C₂ grains exhibited a three-dimensional network skeleton structure. The mean open pore diameter and the specific surface area of the porous grains formed at 1600°C for 2 h were ∼3.5 (μm and ∼6.7 m²/g, respectively. The present work investigated the morphology and the formation conditions of the porous Cr₃C₂ grains, and this paper will discuss the formation mechanism of those grains in terms of chemical thermodynamics.     

Growth Morphology and Mechanism of a Hollow ZnO Polycrystal

When zinc oxide and graphite were placed into an alumina crucible, with a square hole (∼3 mm ×∼3 mm) near the top, and the crucible was covered by an alumina lid and heated at >1050°C, a hollow polycrystal composed of needlelike, ribbon(comb)-like, dendritic, and bulk zinc oxide crystals grew from the hole toward the outside of the crucible. The diameter and length of the polycrystal grown at 1050°C after 1 h were ∼2.2 mm and ∼20 cm, respectively. The diameter increased, while the length decreased, with increasing temperature. Most of the needlelike zinc oxide crystals in the hollow polycrystal were elongated along the c -axis.     

Surgical therapy for hepatocellular carcinoma with liver cirrhosis

Approximately 80% of hepatocellular carcinoma (HCC) patients in Japan have associated liver cirrhosis, which increases the difficulty of surgical treatment. Liver dysfunction associated with liver cirrhosis is one of the most important predictive prognostic factors for HCC patients. Percutaneous ethanol injection therapy (PEIT) is useful for patients with small HCC or with poor hepatic functional reserve. Transcatheter arterial chemoembolization (TACE) is also useful both for patients with unresectable HCC and patients with multiple intrahepatic recurrence. Liver resection, however, lead to better outcome than other treatments when liver function is maintained after surgery. To determine operative procedures, it is important to evaluate the exact function of remnant liver, based on the preoperative liver function test and the evaluation of tumor character. For advanced HCC patients with vascular invasion, non-surgical treatments such as PEIT or TACE are not indicated, and surgical intervention can be an effective modality to improve their survival. Improvements of surgical technique and perioperative management have decreased fatal complications at a major liver resection and allowed us to carry out liver resection on patients with advanced HCC.     

Interfacial microstructure and strength of steel/aluminum alloy joints welded by resistance spot welding with cover plate

We joined aluminum alloy A5052 to cold-rolled steel SPCC (Steel Plate Cold Commercial) and austenitic stainless steel SUS304 using resistance spot welding with a cover plate. The interfacial microstructure was observed using transmission electron microscopy. A thick two-layered reaction layer contains Fe₂Al₅ and FeAl₃ and a thin serration reaction layer contains Fe₂Al₅ and FeAl₃ were observed at the A5052/SPCC and A5052/SUS304 interface, respectively. Mechanical property analysis suggested that the reaction layer has no effect on the tensile shear strength of the A5052/SUS304 joint and that the tensile shear strength of the A5052/SPCC joint is influenced by the reaction layer formed at its interface.