Stabilization of bioethanol recovery with silicone rubber‐coated ethanol‐permselective silicalite membranes by controlling the pH of acidic feed solution

In order to produce highly concentrated bioethanol by pervaporation using an ethanol‐permselective silicalite membrane, techniques to suppress adsorption of succinic acid, which is a chief by‐product of ethanol fermentation and causes the deterioration in pervaporation performance, onto the silicalite crystals was investigated. The amount adsorbed increased as the pH of the aqueous succinic acid solution decreased. The pervaporation performance also decreased with decreasing pH when the ternary mixtures of ethanol/water/succinic acid were separated. Using silicalite membranes individually coated with two types of silicone rubber, pervaporation performance was significantly improved in the pH range of 5 to 7, when compared with that of non‐coated silicalite membranes in ternary mixtures of ethanol/water/succinic acid. Moreover, when using a silicalite membrane double‐coated with the two types of silicone rubber, pervaporation performance was stabilized at lower pH values. In the separation of bioethanol by pervaporation using the double‐coated silicalite membrane, removal of accumulated substances having an ultraviolet absorption maximum at approximately 260 nm from the fermentation broth proved to be vital for efficient pervaporation. Copyright © 2005 Society of Chemical Industry     

Recovery of pyruvic acid with weakly basic polymeric sorbents

BACKGROUND: Carboxylic acids are among the most important substances that can be manufactured from biomass. However, the recovery of carboxylic acids from fermentation broths presents a challenging separation problem. To avoid the production of waste salts and net consumption of chemicals in the calcium carboxylate salt process, the use of reversible chemical complexation with polymeric sorbents and extractants is attractive for carboxylic acid recovery. Pyruvic acid is widely used in the manufacture of medicines, pesticides and foodstuffs and can be produced by fermentation. Since the acidity of pyruvic acid (pK_a = 2.49) is stronger than that of normal carboxylic acids, and as few reports on the recovery of pyruvic acid are available, the sorption of pyruvic acid from aqueous solution on two types of weakly basic polymeric sorbent, tertiary amine D301R and primary amine D392, was investigated over a wide pH range and at various salt (MgSO₄) concentrations. RESULTS: Overloading adsorption of pyruvic acid on both weakly basic polymeric sorbents occurred, with the overloading of D392 being greater than that of D301R. The adsorption of pyruvic acid on both sorbents was greatly affected by the solution pH and the salt concentration in the aqueous phase. An overloading model was able to predict the experimental uptake data very well. CONCLUSION: Solution pH is one of the most important operating conditions, and both polymeric sorbents D392 and D301R can be used to recover pyruvic acid from dilute aqueous solution with high efficiency at a solution pH around 2. The uptake by D392 is greater than that by D301R owing to steric hindrance of the tertiary amine. Copyright © 2008 Society of Chemical Industry     

Synthesis and properties of PDMS modified waterborne polyurethane–acrylic hybrid emulsion by solvent-free method

A new type of polysiloxane modified polyurethane–acrylic hybrid emulsion was synthesized by solvent-free method and the polysiloxane was introduced into the soft segment of polyurethane chains using dihydroxybutyl-terminated polydimethylsiloxane (PDMS). The formed film from the hybrid emulsion could provide obviously higher water-resistance property. The preparation technologies such as the content of carboxy group and acrylic monomer, the rate and the time of emulsification were discussed systematically. The chain structure and the particle size were confirmed by the analysis of Fourier transform infrared spectroscopy and transmission electron microscopy, respectively. The effect of PDMS content on the water resistance and the mechanical property were investigated by absorbed water ratio, water contact angle and dynamic mechanical measurement.     

层次式级联多网络模型及其性能

本文提出了一种层次式级联多网络结构，论述了其训练算法，并验证了该结构的收敛性。这种结构在处理高阶非线性分布数据的分类问题方面具有优良的性能，用北京谱仪事例过滤进行性能测试结果表明，其训练和泛化性能都优于单个ＢＰ网络。     

DD—921钢铁常温发黑剂的研制和应用

研究了钢铁常温发黑过程的成膜机理,各组分之间的作用以及相互之间的影响,着重分析了常温发黑的优缺点,工艺控制参数以及经济性。     

LD7铝合金时效工艺的研究

通过试验系统地研究了ＬＤ７铝合金的单级和两级时效工艺。结果表明，与传统的单级时效相比，两级时效在不降低室温强度，硬度的前提下，可显著提高合金的电导率及高温性能。     

A spectroscopic study of the self-association and inter-molecular aggregation behaviour of pH-responsive poly(l-lysine iso-phthalamide)

The pH mediated intra-molecular association and inter-molecular aggregation of a range of amphiphilic poly(l-lysine iso-phthalamide) polymers have been investigated in aqueous solution over a range of pH values and concentrations. The desired functionality of these novel bioresponsive amphiphilic polymers was achieved by incorporating pendant hydrophilic carboxyl groups along the polymer backbone, via the l-lysine moiety, balanced by a degree of hydrophobicity introduced via the iso-phthaloyl moiety. Incorporation of low levels of bis-functional Cy3 (poly-Cy3) and/or Cy5 dye (poly-Cy3/5 or poly-Cy5) co-monomers in the responsive polymer backbone allowed detailed probing of the pH mediated hydrophobic association using a combination of optical spectroscopic techniques. Both steady-state fluorescence spectroscopy and fluorescence lifetime measurements of poly-Cy3 revealed a conformational transition at pH 4.5. Thus, below a critical pH the polymer collapsed into a compact globular structure (hypercoil) bringing the fluorophore molecules into close proximity with one another. This resulted in a dramatic reduction in fluorescence intensity and fluorescent lifetime in the single fluorophore systems (poly-Cy3) accompanied by a red shift in the maximum emission wavelength. Observed redshifts in the emission maxima and enhancements of fluorescent lifetimes with increasing polymer concentration suggested the formation of polymer aggregates. Fluorescence resonance energy transfer (FRET) was measured in mixtures of single fluorophore containing poly-Cy3 (donor) and poly-Cy5 (acceptor) and dual fluorophore containing poly-Cy3 (donor)/Cy5 (acceptor) in an effort to distinguish between intra-molecular versus inter-molecular association. The relevance of the results with respect to potential in vivo applications (drug delivery and biodiagnostics) is discussed.     

煤的荧光特性与其工艺性能的关系研究

简述了煤中镜质组荧光产生的机理及荧光参数的测量方法,通过测定一系列煤的粘结性和10kg小焦炉结焦性试验,探讨了煤的荧光特性与其工艺性能的关系。煤的荧光参数与其反射率呈正的线性相关关系,与其挥发分含量呈负的线性相关关系;煤的粘结性、结焦性均与其荧光参数有关;当煤化程度相同、煤岩组成基本相同时,煤的荧光强度愈强,其结焦性能愈好。     

热处理前后丙烯腈／溴乙烯共聚纤维的热性能和阻燃性能研究

分析了热处理前后丙烯腈／溴乙烯共聚纤维的热性能与溴乙烯含量、升温速率或热处理时间的关系，并对纤维的阻燃性与溴含量或热处理时间关系进行了研究。结果表明，溴含量的增加或热处理时间的延长对热稳定性和阻燃性的提高有较大影响，而且经热处理后纤维的阻燃性与溴无关。     

MACD与K线图技术在证券投机中的实证研究

利用MACD趋势指标与K线形态图进行相互验证技术,改进一般的基于MACD的证券买卖准则。实证结果表明,基于改进后的MACD买卖准则进行证券投机,几乎能使投机者捕捉到每一波段行情,从而获取较高收益。