Improving the Pressurized Flushing Efficiency in Reservoirs: an Experimental Study

Sediment flushing in many reservoirs of the world is accomplished with low efficiency. In this study, a new configuration was proposed for reservoir bottom outlet to increase the pressurized flushing efficiency. In the new configuration, a projecting semi-circular structure was connected to the upstream edge of bottom outlet. It was observed that by employing the projecting bottom outlet, the sediment removal efficiency increased significantly compared to the flushing via typical bottom outlet. In the case of new-configuration bottom outlet with L _sc /D _outlet  = 5.26 and D _sc /D _outlet  = 1.32, the dimensionless length, width and depth of flushing cone increased 280%, 45% and 14%, respectively, compared to the reference test. The proposed structure can ensure the sustainable use of reservoirs.     

Participatory Modeling Workshops in a Water-Stressed Basin Result in Gains in Modeling Capacity but Reveal Disparity in Water Resources Management Priorities

Participatory modeling workshops were held in Sonora, México, with the goal of developing water resources management strategies in a water-stressed basin. A model of the water resources system, consisting of watershed hydrology, water resources infrastructure, and groundwater models, was developed deliberatively in the workshops, along with scenarios of future climate and development. Participants used the final version of the water resources systems model to select management strategies. The performance of the strategies was based on the reliability of meeting current and future demands at a daily time scale over a year’s period. Pre- and post-workshop surveys were developed and administered. The survey questions focused on evaluation of participants’ modeling capacity and the utility and accuracy of the models. The selected water resources strategies and the associated, expected reliability varied widely among participants. Most participants could be clustered into three groups with roughly equal numbers of participants that varied in terms of reliance on expanding infrastructure vs. demand modification; expectations of reliability; and perceptions of social, environmental, and economic impacts. The wide range of strategies chosen and associated reliabilities indicate that there is a substantial degree of uncertainty in how future water resources decisions could be made in the region. The pre- and post-survey results indicate that participants believed their modeling abilities increased and beliefs in the utility of models increased as a result of the workshops.     

Ecosystem Service Impacts of Urban Water Supply and Demand Management

Utilities face the challenge of enhancing long-term water security while minimising undesirable economic, social and environmental impacts of supply and demand management options. This paper provides an example of how the ecosystem services concept can be used to enumerate and organise broad impacts of water supply options. A case study of Adelaide, South Australia, is used to examine costs and benefits associated with different sources of water and source-water mix scenarios. Ecosystem service impacts are estimated using estimates from the literature. Seven water supply and demand management options are considered for Adelaide: 1) the River Murray, 2) Mt. Lofty Ranges catchments, 3) wastewater reuse, 4) desalination, 5) stormwater harvesting, 6) groundwater and 7) water conservation. The largest costs are associated with sourcing water from conservation measures such as water restrictions on outdoor watering estimated at $1.87/kL. Salinity damage costs associated with residential uses are estimated at up to $1.54/kL. Salinity damage costs of wastewater reuse were estimated at $1.16/kL. The largest benefit is coastal amenity services associated with stormwater harvesting and treatment estimated at $1.03/kL. Results show that there is a trade-off between financial costs and ecosystem services impacts with source-water mix scenarios with the highest ecosystem services cost having the lowest financial O&M cost and vice versa. This highlights the importance of taking ecosystem services into account when evaluating water supply options.     

陕北无定河流域土壤侵蚀与植被覆盖和降雨关系研究

基于2000—2014年陕北无定河流域日降水、DEM、土壤类型、MODIS NDVI等数据,利用修正通用土壤流失方程(RUSLE)估算了流域土壤侵蚀情况,定量分析了植被覆盖和降雨在土壤侵蚀中的作用,结果表明:(1)无定河流域土壤侵蚀以微度侵蚀为主,平均占流域面积的88.35%,各土壤侵蚀等级面积比例随等级的升高而降低。2000—2014年微度侵蚀面积比例为下降趋势,轻度及以上等级面积比例均为上升趋势。(2)不考虑降雨因子影响时,无定河流域仍以微度侵蚀为主,且为增加趋势,而其他土壤侵蚀等级均为下降趋势。不考虑植被覆盖因子时,流域土壤侵蚀与模型计算结果的变化趋势基本一致。(3)植被覆盖对土壤侵蚀面积比例和变化速率的贡献率分别为13.67%和24.55%,而降雨作用达到86.33%和75.44%,表明降雨是流域土壤侵蚀的主要动力和控制因子,降雨变化主导着流域土壤侵蚀变化过程。     

固定床催化合成N,N-二甲基丙胺的研究

以正丙醇和二甲胺为主要原料,采用浸渍法制备负载活性金属的Al2O3催化剂,在固定床反应器中考察了催化剂载体预处理及反应条件对合成N,N-二甲基丙胺的影响.结果表明:一次磷酸处理的A12O3上负载入活性组分(Cu10%,Cr12%)的催化剂具较满意的选择性和活性.较合适的反应工艺条件为压力0.8Mpa,反应温度220℃,空间速度为0.3h-1,进料比为二甲胺:丙醇=3:1,此时产品的收率达到90%以上.     

仙人掌超氧化物歧化酶的纯化及其部分性质研究

10 0 0g仙人掌茎经匀浆、硫酸铵分级沉淀、SephadexG - 75凝胶层析和DEAE - 5 2离子交换层析 3个步骤 ,将仙人掌SOD纯化到SDS -PAGE均一纯 ,得白色粉状SOD 0 8985g ,比活 910U/mg,活力回收 4 3 1% ,纯化倍数 76。该酶相对分子质量 37 1kD ,H2 O2 和KCN的抑制实验结果表明为Cu、Zn -SOD。该酶的最大紫外吸收在 2 75nm处。 5 0℃保温 15 0min ,SOD的活性不变 ,在pH =5 0～ 9 0时SOD有较好的稳定性     

德士古气化炉的提温操作

通过更换煤种使生产消耗得到了大幅度降低，生产能力得到了较大的提高，但渣中可燃物较设计指标提高了2－3倍，为此进行了提高炉温的试验，考察渣中可燃物随炉温的变化关系，则时考核不同渣中可燃物含量下的氧耗和煤耗。     

Polyethylene-layered silicate nanocomposites prepared by the polymerization-filling technique: synthesis and mechanical properties

Polyethylene-layered silicate nanocomposites were prepared by the in situ intercalative polymerization of ethylene by the so-called polymerization-filling technique and analyzed by transmission electron microscopy (TEM), X-ray diffraction analysis (XRD), differential scanning calorimetry, dynamic mechanical analysis and tensile testing. Non-modified montmorillonite and hectorite were first treated by trimethylaluminum-depleted methylaluminoxane before being contacted by a Ti-based constrained geometry catalyst. The nanocomposite was formed by addition and polymerization of ethylene. In the absence of a chain transfer agent, ultra high molecular weight polyethylene was produced. The tensile properties of these nanocomposites were poor and essentially independent of the nature and content of the silicate. Upon hydrogen addition, the molecular weight of the polyethylene was decreased with parallel improvement of the tensile and shear moduli, in relation to the filler content. The exfoliation of the layered silicates was confirmed by XRD analysis and TEM observation. The mechanical kneading of the molten nanocomposites resulted in the partial collapse of the exfoliated structure driven by the thermodynamic stability of the layered filler.     

Detecting Fixed Patterns in Chordal Graphs in Polynomial Time

The Contractibility problem takes as input two graphs G and H, and the task is to decide whether H can be obtained from G by a sequence of edge contractions. The Induced Minor and Induced Topological Minor problems are similar, but the first allows both edge contractions and vertex deletions, whereas the latter allows only vertex deletions and vertex dissolutions. All three problems are NP-complete, even for certain fixed graphs H. We show that these problems can be solved in polynomial time for every fixed H when the input graph G is chordal. Our results can be considered tight, since these problems are known to be W[1]-hard on chordal graphs when parameterized by the size of H. To solve Contractibility and Induced Minor, we define and use a generalization of the classic Disjoint Paths problem, where we require the vertices of each of the k paths to be chosen from a specified set. We prove that this variant is NP-complete even when k=2, but that it is polynomial-time solvable on chordal graphs for every fixed k. Our algorithm for Induced Topological Minor is based on another generalization of Disjoint Paths called Induced Disjoint Paths, where the vertices from different paths may no longer be adjacent. We show that this problem, which is known to be NP-complete when k=2, can be solved in polynomial time on chordal graphs even when k is part of the input. Our results fit into the general framework of graph containment problems, where the aim is to decide whether a graph can be modified into another graph by a sequence of specified graph operations. Allowing combinations of the four well-known operations edge deletion, edge contraction, vertex deletion, and vertex dissolution results in the following ten containment relations: (induced) minor, (induced) topological minor, (induced) subgraph, (induced) spanning subgraph, dissolution, and contraction. Our results, combined with existing results, settle the complexity of each of the ten corresponding containment problems on chordal graphs.