Effects of the neem tree compounds azadirachtin, salannin, nimbin, and 6-desacetylnimbin on ecdysone 20-monooxygenase activity

The effects of azadirachtin, salannin, nimbin, and 6-desacetylnimbin on ecdysone 20-monooxygenase (E-20-M) activity were examined in three insect species. Homogenates of wandering stage third instar larvae of Drosophila melanogaster, or abdomens from adult female Aedes aegypti, or fat body or midgut from fifth instar larvae of Manduca sexta were incubated with radiolabeled ecdysone and increasing concentrations (from 1 x 10(-8) to 1 x 10(-3) M) of the four compounds isolated from seed kernels of the neem tree, Azadirachta indica. All four neem tree compounds were found to inhibit, in a dose-dependent fashion, the E-20-M activity in three insect species. The concentration of these compounds required to elicit a 50% inhibition of this steroid hydroxylase activity in the three insect species examined ranged from approximately 2 x 10(-5) to 1 x 10(-3).     

Effect of beam voltage on the properties of aluminium nitride prepared by ion beam assisted deposition

The effects of nitrogen-beam voltage on the structure, stress, energy band gap and hardness of AIN thin films deposited on Si (111), Si (100) and sapphire (0001) by ion beam assisted deposition (IBAD) are reported. As the nitrogen-beam voltage was increased from 50 to 200 V, the stress and disorder in the AIN films increased as determined by X-ray diffraction, FTIR and Raman spectroscopy. The preferred orientation of the film's c-axis changed from completely normal to the film at 100 V, to a mixture of normal and in the plane of the film at 200 V. For AIN films deposited under the same conditions, the films were more highly oriented on sapphire (0001) than in Si (111). The hardness of the films increased from 18.2 to 23.7 GPa with the nitrogen-beam voltage, and possible reasons for this change in hardness are considered.     

Unique ESD failure mechanisms during negative to Vcc HBM tests

HBM ESD tests on two types of 0.6 μm DRAM devices showed that internal circuit or output driver failures would occur after the input or I/O pins were ESD stressed negative with respect to Vcc at ground. These failures occurred at lower than expected ESD stress voltages due to power-up circuit interactions that either turned-on unique internal parasitic ESD current paths or disrupted the normal operation of the output pin’s ESD protection circuit. ESD analysis found there exists a set of power-up sensitive circuits and if placed near a Vcc bond pad can result in low voltage ESD failures.     

The systemic inflammatory response to cardiopulmonary bypass and the brain

The acquired immune deficiency syndrome (AIDS) is a lethal multisystem disease. Its ocular manifestations have received relatively little attention in the literature. Between 73% and 100% of AIDS patients develop ocular lesions. The commonest lesions seen are retinal--either infectious or noninfectious retinopathy. Involvement of the conjunctiva with Kaposi's sarcoma, infected tears and infected cornea as well as the vitreous are less common. Infections with cytomegalovirus and varicella zoster virus are common causes of visual loss and can be treated with antiviral agents such as ganciclovir and foscarnet. This greatly increases the quality of life in these patients by preventing visual loss.     

Cardiovascular effects of conventional sulfonylureas and glimepiride

Sulfonylureas have, in the past, been reported to have adverse cardiovascular effects. Glimepiride is a new sulfonylurea. In spite of stimulating less insulin secretion, it has, depending on the species, equal or higher blood glucose decreasing activity and according to preliminary studies less cardiovascular activity than glibenclamide. Further studies were performed to confirm the lower cardiovascular activity of glimepiride. The IC50 for inhibition of rilmakalim-activated KATP channel currents in isolated ventricular myocytes was 31.6 nM for glimepiride and 6.8 nM for glibenclamide. In endotoxin shock-rats at a dose of 1 x 2 mg/kg i.v., glibenclamide induced a significantly higher blood pressure increase than glimepiride. At two i.v. doses of 20 mg/kg 4 min apart, in normal rats, glibenclamide produced signs of ischemia in the ECG in nearly all animals, glimepiride almost none, in diabetic rats, glibenclamide produced in all animals a lethal cardiogenic shock preceeded by serious ECG changes, glimepiride only in one fifth of the animals. In open-chest dogs, on intracoronary infusion of equieffective blood glucose-lowering doses, glibenclamide, gliclazide and glimepiride all reduced coronary blood flow, increased coronary resistance, depressed the mechanical activity of the heart, enhanced myocardial O2-extraction, reduced the serum potassium level and induced a moderate endocardial ST-segment elevation, but glimepiride to a significantly less extent than glibenclamide and gliclazide. The presented data confirm that glimepiride at equivalent blood glucose decreasing doses has less cardiovascular activity than conventional sulfonylureas.     

Performance characteristics of a composite multivariate quality control system.

We present the results of an evaluation of the performance characteristics of a composite multivariate quality control (CMQC) system that incorporates quality control rules for univariate, multivariate, and correlation conditions. The CMQC system evaluated is designed to help analysts detect unacceptable trends and systematic error in one or more variables, unacceptable random error in one or more variables, and unacceptable changes in the correlation structure of any pair of variables. It is also designed to be tolerant of missing data, to allow analysts to reject as few as one or as many as all variables in a run, and to provide analysts with control statistics and graphics that logically relate to sources of analytical error. We show that the various components of the CMQC system have adequate statistical power to detect systematic errors, random errors, and correlation changes under the conditions likely to be encountered with multivariate analytical measurement systems: (1) a single variable with increased systematic or random error; (2) all variables or a subgroup of variables affected by a common problem that increases systematic or random error; and (3) missing data for one or more variables in a run. We also show that the power of the multivariate component of the CMQC system to detect systematic and random errors is higher than the power of an alternative multivariate test criterion.     

Accelerated aging of extruded dielectric power cables. I. Controland monitoring methodology

An improved accelerated cable life test is described. Through the use of programmable logic controllers (PLCs), very precise and consistent control of the accelerated aging process has been achieved. A computer has been utilized to make continuous real-time acquisition and storage of key operating parameters possible. This precise control and monitoring methodology has permitted the study of the synergistic effects of voltage and temperature on the accelerated aging of full-sized cables in the laboratory     

A STUDY OF SUPERIMPOSED FRACTURE MODES I, II AND III ON PMMA

A test apparatus has been developed to study the fracture behaviour of engineering materials subjected to superimposed tensile and shear (Mode I and II) loads using a single edge notch specimen. Stress intensity factors were calculated using finite element analysis. Test results for PMMA are reported. Results from circumferentially notched round bar specimens, subjected to combined tension and torsion (Mode I and III) loading are also reported. The Mode I/II results are consistent with the mixed mode fracture response of a wide range of brittle materials, although there is some evidence of non-linear behaviour. The fracture behaviour for superimposed Modes I and III indicates the strong influence of non-linear deformation which causes the mixed mode toughness to be dependent on the sequence and type of loading.