Transport properties of 1,1-difluoroethane (R152a)

Based on reliable. carefully selected data sets. equations for the thermal conductivity and the viscosity of the refrigerant R 112a are presented. They are valid at temperatures from 240 to 440 K, pressures up to 20 MPa. and densities up to 1050 kg · m^–3. including the critical region.     

Dynamics of the transient buildup of emission inNd3+-doped fiber lasers

The two-stage process of the transient buildup of emission in Nd ⁴⁺-doped fiber lasers is described both experimentally and theoretically. After switching on the pump, spontaneous emission increases first until the gain becomes sufficient to compensate for the cavity losses; the laser field then develops and reaches the steady state after more or less regular oscillations. During this second stage, an almost chaotic spiking is obtained either for high pumping rates and/or at low temperatures. The whole set of these dynamical scenarios is not described under the usual assumptions of uniform cavity losses over the whole field spectrum and of pure homogeneous broadening for the transition line, but rather a modified form of the Maxwell-Bloch equations which retains some frequency dependence for the losses in the cavity and the inhomogeneous broadening as well is proposed     

An Eigen-Analysis of Compact Antenna Arrays and Its Application to Port Decoupling

Placing the radiators of antenna arrays closer than aggravates the problem of power mismatch. Based on efficiency considerations, a general analysis of this effect is presented, putting forward a simple tool to quantify, compare, and optimize the performance of antenna arrays. This analysis is not restricted with respect to the number of radiators or the degree of compactness. In order to improve power matching, a systematic approach for the design of lossless decoupling and matching networks based on 180 directional couplers is suggested for up to eight radiators. Implications of network losses, which have not yet received appropriate attention by researchers in the past, will be analyzed and discussed by means of a manufactured three-element prototype array.     

Quantitative measurement of gas hold-up distribution in a stirred chemical reactor using X-ray cone-beam computed tomography

Cone-beam type X-ray computed tomography (CBCT) is a potential method to measure three-dimensional phase distributions in vessels. An example for that is the measurement of gas profiles in stirred chemical reactors. Such data are highly valuable for the assessment and evaluation of chemical processes, for optimisation of the reactor and stirrer design, and for evaluation of computational fluid dynamics codes used to model the fluid flow and heat transfer in reactive systems. However, there are considerable difficulties for accurate quantitative measurements due to beam hardening and radiation scattering effects. In a theoretical and experimental work we have investigated the non-linear effects of both physical phenomena and developed a suitable measurement setup as well as calibration and software correction methods to achieve a highly accurate measurement of void fraction profiles with CBCT.     

Decisive arrival law parameters and a general finite capacity queueing problem

This paper addresses the problem of finding the parameters of the arrival law which most significantly influence expected occupation and loss of a finite capacity queue. The input process is supposed to be ergodic and wide sense stationary. We show that it is mostly possible to fit an MMPP(2) to the decisive parameters of observational data. Numerical examples illustrate the importance of the decisive parameters, called key parameters, and also show the accuracy of the proposed fitting procedure. Finally, in the appendix we present the solution of the finite capacity queueing problem with Special Semi Markov Process (SSMP) arrivals and a general service strategy.     

A fast response impedance meter for acoustic reflex measurements

The response time of the instrument is a crucial parameter for the measurement of accurate morphology and latency of the acoustic reflex. An improved impedance meter accounting for this particular problem was designed for the measurement of the contralateral acoustic reflex. The temporal characteristic of the measurement apparatus is shown, as well as an example of an application in a normal hearing individual. The module can be incorporated into already existing instruments with some modifications     

News: Titanium dioxide photocatalysis: Treatment hype or hope?

Technology.