(Fe_(0.86)Zr_(0.033)Nb_(0.033)B_(0.068)Cu_(0.01))_x(Al_2O_3)_(1-x)颗粒膜的霍耳效应

用磁控溅射方法制备了系列 (Fe0 .86 Zr0 .0 33Nb0 .0 33B0 .0 6 8Cu0 .0 1 ) x(Al2 O3) 1 -x颗粒膜样品 ,体积百分比x从 0 .3 3～ 0 .63 ,样品厚度约为10 0nm。室温下在Fe0 .86 Zr0 .0 33Nb0 .0 33B0 .0 6 8Cu0 .0 1 体积百分比x =0 .43时得到 17.5 μΩ·cm的最大饱和霍耳电阻率 ,比纯铁磁金属提高了 3～ 4个量级。对其磁性和微结构进行了研究 ,样品霍耳电阻率随外场的变化曲线 ρxy～H与磁场平行于膜面时的磁化曲线M～H有相似性 ,说明霍尔电阻率 ρxy与磁化强度M相关。样品电阻率 ρxx随金属体积百分比x的减小而增加 ,在x =0 .43附近发生突变 ,从金属导电变为绝缘体。根据微结构和输运性质对可能的机制进行了探讨     

Single nucleotide polymorphism data analysis - State-of-the-art review on this emerging field from a signal processing viewpoint

The basic structural units of the genome are nucleotides. A single nucleotide polymorphism (SNP) is a mutation at a single nucleotide position. This paper discusses several major problems in SNP data analysis and review some existing solutions in this work. Generally speaking, a rich set of SNP analysis problems are cast in the signal processing framework. Our objective is to offer a state-of-the art review on this topic from a signal processing viewpoint so that researchers in the signal processing field can grasp the important domain knowledge to overcome the barrier between the two fields     

蒸发式空冷器的运行实践

通过了解蒸发式空冷器的工作原理和结构,在运行实践过程中,对组成设备出现的问题提出相应的解决方案,并对部分组成设备提出改进的建议,以方便检修和维护,并提出了在冬季长时间高炉休风情况下保证水温不下降过低的解决方案。     

Subspace-Based Blind Channel Identification for Cyclic Prefix Systems Using Few Received Blocks

In this paper, a novel generalization of subspace-based blind channel identification methods in cyclic prefix (CP) systems is proposed. For the generalization, a new system parameter called repetition index is introduced whose value is unity for previously reported special cases. By choosing a repetition index larger than unity, the number of received blocks needed for blind identification is significantly reduced compared to all previously reported methods. This feature makes the method more realistic especially in wireless environments where the channel state is usually fast-varying. Given the number of received blocks available, the minimum value of repetition index is derived. Theoretical limit allows the proposed method to perform blind identification using only three received blocks in absence of noise. In practice, the number of received blocks needed to yield a satisfactory bit-error-rate (BER) performance is usually on the order of half the block size. Simulation results not only demonstrate the capability of the algorithm to perform blind identification using fewer received blocks, but also show that in some cases system performance can be improved by choosing a repetition index larger than needed. Simulation of the proposed method over time-varying channels clearly demonstrates the improvement over previously reported methods.     

锗酸铋（Bi4Ge3O12）单晶热物理性质的研究

本文用不同的测试技术和方法测定了锗酸铋(BGO)单晶的比热(300～800K)热膨胀系数(100～1100K)和导温系数(140～700K),进而导出了 BGO 单晶不同温度下的导热系数、定容比热、德拜温度和格虑内森数。本文还对 BGO 单晶热物理性质的变化规律作了理论解释。     

无线信道中的电波传播

分析了信号在无线信道中传输时所经受的两种衰落,介绍了主要的无线传播模型,在此基础上提出了对抗衰落的措施。     

Penalty interference of nonlinear intra-channel effects and PMD inultra high-speed TDM systems

Penalty interference of nonlinear propagation impairments and polarisation mode dispersion (PMD) caused signal distortions is experimentally investigated     

动态聚焦电子枪的模拟与实验研究

动态聚焦技术是为了满足大屏幕高分辨率彩色显像管及高分辨率彩色显示管的发展需求而产生的一项新技术。在本文中，作者首先提出了一种动态聚焦电子枪结构，进行了数值计算与分析，制作了动态聚焦电子枪并装管实验。通过对实验样管的测试与分析。证实该枪性能良好，动态聚集效果明显。     

Assessment of underground cable ratings based on distributed temperature sensing

Numerous power utilities have installed advanced distributed temperature sensing (DTS) systems to measure the temperature of underground cables. This paper presents a general procedure for real-time assessment of underground cable ratings based on DTS. After the identification and location of hot spots on a cable, the cable installation data, load, and DTS-recorded temperature over a period of time are used to estimate soil thermal parameters and assess cable ratings under normal and overloading conditions. In order to accurately estimate soil thermal parameters, a combined technique of the finite-element method and gradient-based optimization is used. The technique was validated in the laboratory and applied to a rating assessment of a 230-kV/500-MVA cable circuit. The assessed continuous and emergency ratings are helpful in improving the operation of this circuit.     

InGaN/GaN MQW p–n junction photodetectors

InGaN/GaN multiquantum well (MQW) p–n junction photodetectors with semi-transparent Ni/Au electrodes were fabricated and characterized. It was found that the fabricated InGaN/GaN MQW p–n junction photodetectors exhibit a 20 V breakdown voltage and a 3.5 V forward 20 mA turn on voltage. It was also found that the photocurrent to dark current contrast ratio is higher than 10⁵ when a 0.4 V reverse bias was applied to the InGaN/GaN MQW p–n junction photodetectors. Furthermore, it was found that the maximum responsivity was 1.28 and 1.76 A/W with a 0.1 and 3 V applied reverse bias, respectively.