Criteria for versatile GaN MOVPE tool:high growth rate GaN by atmospheric pressure growth

Growth rate has a direct impact on the productivity of nitride LED production.Atmospheric pressure growth of GaN with a growth rate as high as 10μm/h and also Al_0.1Ga_0.9N growth of 1μm/h by using 4 inch by 11 production scale MOVPE are described.XRD of（002） and（102） direction was 200 arcsec and 250 arcsec, respectively.Impact of the growth rate on productivity is discussed.     

EXOS-D (AKEBONO) very low frequency plasma wave instruments (VLF)

The Akebono (EXOS-D) satellite has been successfully observing the Earth's magnetosphere since it was launched on February 21, 1989. The objectives of VLF instruments on board the satellite were to investigate the behavior of plasma waves associated with accelerated auroral particles, wave-particle interaction mechanisms, and propagation characteristics of whistler-mode waves in the magnetosphere. The instruments measured not only the dynamic spectra of VLF waves up to 15 kHz by a wideband receiver, but also their absolute field intensities, wave normal vectors, and Poynting vectors. Two electric and three magnetic components with a bandwidth of about 50 Hz up to 12.5 kHz are sent to measure the wave normal vectors and Poynting vectors. The antenna impedance is measured to determine the correct absolute electric field intensities. The instruments have successfully measured the wave spectra, the wave normal vectors. Poynting vectors, the precise wave intensities, the antenna impedance, etc. The present paper describes the unique features of the instruments, especially the Poynting flux analyzers in more detail. Obtained scientific results are also reviewed     

Numerical Analysis of the Boundary Scattering Effect on Transport Properties in Bi-Sb Nanowires

In this study, we have numerically analyzed the transport properties of Bi-Sb nanowires, taking into account wire boundary scattering. Wire boundary scattering slightly decreased the Seebeck coefficient of Bi-Sb nanowires. This effect is due to the observation that boundary scattering and the mobility ratio of L-point electrons to T-point holes in the nanowires are smaller than those in bulk Bi-Sb because the wire boundary scattering suppresses the mobilities of L-point electrons and heavy holes. The largest Seebeck coefficient for all wire diameters was obtained when the Sb concentration was 5 at.%. The effective mass approached zero near 5 at.% Sb, and the small effective mass led to a large subband shift in each band. Thus, a small effective mass enhances the quantum effect at a fixed wire diameter, even if wire boundary scattering is taken into account.     

Analysis and experimental validation of force bandwidth for force control

Controlling robots in contact with the environment is an important problem in industry applications. In the conventional force control, much research has paid attention to develop novel force control systems and implemented force sensors to detect external force. This paper shows that narrow bandwidth of force sensor has a big influence on the force control system. Generally, to solve the instability in force control, the velocity feedback gain is enlarged. The system becomes unstable with small velocity feedback gain, and robot's response becomes slow with large one. Inasmuch as there is a tradeoff between the stability and the response, it is considered that force control by robots is difficult. This paper proposes a force control system with disturbance observer. It is possible to obtain the force information with wide bandwidth by using the disturbance observer. This paper shows that bandwidth of force sensing is very important for contact motion control. By using the wide bandwidth of force sensing, both stability and response are improved. Furthermore, force control is attainable by the construction of the easiest force control architecture. Therefore, the ideal zero-stiffness-force control is attained. The numerical and experimental results show viability of the proposed method.     

Nonlinear Sagnac interferometer switch and its applications

Ultrafast all-optical switching based on the optical Kerr effect in a Sagnac interferometer which consists of a dichroic polarization-maintaining fiber coupler and dispersion-shifted polarization-maintaining fiber loop is reported. This nonlinear Sagnac interferometer switch has the advantage of high stability originating from completely balanced interfering arms. In addition, because dispersion-shifted fibers were used, increases in switching power and switching time were prevented. Moreover, polarization fluctuation was completely suppressed due to the all-polarization maintaining fiber configuration. The required switching power for complete switching was measured to be 1.8 W for a 200-m-long fiber. All-optical time division demultiplexing and logic operations, including inversion and operation, using the nonlinear Sagnac interferometer switch were successfully demonstrated at 5 Gb/s     

Performance limits of coded multilevel DPSK in cellular mobileradio

Performance limits of coded multilevel differential PSK (MDPSK) in multipath Rayleigh fading channels are described. The simple Gaussian metric is assumed for reasons for practicality even though it is not the maximum likelihood. The channel cutoff rate, R₀ of MDPSK is analyzed based on the metric. Account is taken of additive white Gaussian noise (AWGN), cochannel interference, and multipath channel delay spread. For the analysis of the spectrum efficiency of a cellular mobile radio system employing coded MDPSK, its service area is defined as the area in which, with a bit rate of R information bit/symbol (R⩽R₀), reliable communications are possible. Three optimal information bit rates are determined from the channel cutoff rate to minimize the required average signal energy per information bit-to-noise power spectral density ratio (E_b/N₀) to maximize the tolerable r.m.s. delay spread τ_r.m.s. and to maximize the spectrum efficiency     

Wideband and high-power compressively strained GaInAsP/InPmultiple-quantum-well ridge waveguide lasers emitting at 1.3 μm

Compressively strained 1.3-μm GaInAsP/InP multiple-quantum-well (MQW) ridge waveguide lasers were fabricated. Through optimizing the total well thickness, large bandwidth over 11 GHz was achieved, together with high quantum efficiency of about 0.48 W/A and high power output of 60 mW before rollover. The laser also showed less temperature sensitivity up to an elevated temperature of 85°C