Positively Thermo‐Sensitive Monodisperse Core–Shell Microspheres

In this paper, we report on a novel family of monodisperse thermo‐sensitive core–shell hydrogel microspheres that is featured with high monodispersity and positively thermo‐responsive volume phase transition characteristics with tunable swelling kinetics, i.e., the particle swelling is induced by an increase rather than a decrease in temperature. The microspheres were fabricated in a three‐step process. In the first step, monodisperse poly(acrylamide‐co‐styrene) seeds were prepared by emulsifier‐free emulsion polymerization. In the second step, poly(acrylamide) or poly[acrylamide‐co‐(butyl methacrylate)] shells were fabricated on the microsphere seeds by free radical polymerization. In the third step, the core–shell microspheres with poly‐ (acrylamide)/poly(acrylic acid) based interpenetrating polymer network (IPN) shells were finished by a method of sequential IPN synthesis. The proposed monodisperse core–shell microspheres provide a new mode of the phase transition behavior for thermo‐sensitive “smart” or “intelligent” monodisperse micro‐actuators that is highly attractive for targeting drug delivery systems, chemical separations, sensors, and so on.     

High‐Performance,Monolithic Polyaniline Electrochemical Actuators

New polyaniline (PANI) asymmetric membranes were fabricated using a phase‐inversion technique with hexane as the coagulation bath. These membranes exhibit a dense structure with macrovoids distributed asymmetrically throughout the cross‐section. A stress–strain study demonstrated that the Young's modulus (1.421 GPa) and strain at break (7.6 %) of the new PANI asymmetric membranes prepared from hexane are approximately 12 and 4 times higher, respectively, than the values reported previously for the PANI integrally skinned asymmetric membranes (ISAMs) (123 MPa Young's modulus and 1.8 % strain at break). Furthermore, monolithic electrochemical actuators based on a single PANI asymmetric membrane were constructed, and a bending movement of up to 20 Hz was experimentally recorded in a hydrochloric acid aqueous solution. A lifetime of over 329 500 cycles was determined for these actuators at a ± 2° angular displacement (5 Hz). The lifetime is limited by a bending fatigue that creates a transversal crack on the PANI membrane at the air–water interface. Control over the actuator movement is also manifested by the linear dependences of the bending angle on the charge and of the angular velocity on the current. These relationships are independent of both the kind of applied electric signal and the frequency used.     

Possibilities and extension of XRD material response analysis in failure research for the advanced evaluation of the damage level of Hertzian loaded components

Due to clearly distinguishable damage symptoms, it is differentiated between the surface and sub‐surface failure mode of rolling bearings. Material states red out by X‐ray diffraction (XRD) residual stress measurements point to a variety of loading conditions especially at raceway surfaces that are associated with several competing failure mechanisms. The corresponding lifetime reduction can range from the lower fatigue strength region to material ratcheting in extreme cases. Relevant position of the microstructural changes and nature of the failure mechanisms are characterized. The time alteration of the XRD material parameters measured at or near the surface and at the depth of the maximum equivalent stress correlates, in a different manner, with the statistical parameter of the 10 % bearing life. Both failure modes are illustrated by concrete examples. Contaminated lubricant and boundary lubrication, which represent practically important surface‐induced failures, are discussed in more detail. Gray staining, i.e. shallow pitting, often occurs without distinct indication of global material aging by means of XRD characteristics. Here, scanning electron microscopy observations and electron microprobe analyses point to corrosion fatigue as acting surface failure mechanism. The interaction between material and lubricant under complex loading regimes particularly of mixed friction and corrosion opens further failure research areas in the field of tribology.     

Hierarchical Self‐Assembly of Peptide‐Coated Carbon Nanotubes

Numerous applications, from molecular electronics to super‐strong composites, have been suggested for carbon nanotubes. Despite this promise, difficulty in assembling raw carbon nanotubes into functional structures is a deterrent for applications. In contrast, biological materials have evolved to self‐assemble, and the lessons of their self‐assembly can be applied to synthetic materials such as carbon nanotubes. Here we show that single‐walled carbon nanotubes, coated with a designed amphiphilic peptide, can be assembled into ordered hierarchical structures. This novel methodology offers a new route for controlling the physical properties of nanotube systems at all length scales from the nano‐ to the macroscale. Moreover, this technique is not limited to assembling carbon nanotubes, and could be modified to serve as a general procedure for controllably assembling other nanostructures into functional materials.     

Lipase‐catalyzed dynamic kinetic resolution of (R,S)‐fenoprofen thioester in isooctane

A lipase‐catalyzed enantioselective hydrolysis process under in situ racemization of the remaining (R)‐thioetser substrate with trioctylamine as the catalyst was developed for the production of (S)‐fenoprofen from (R,S)‐fenoprofen 2,2,2‐trifluoroethyl thioester in isooctane. Detailed investigations of trioctylamine concentration on the enzyme activation and the kinetic behavior of the thioester in racemization and enzymatic reactions were conducted, in which good agreement between the experimental data and theoretical results was observed. © 2002 Society of Chemical Industry     

Determination of assimilable organic carbon (aoc) in ozonated water with acinetobacter calcoaceticus

The effect of ozone application in drinking water on the production of assimilable organic carbon (AOC) was evaluated. The typical procedure to determine AOC is suggested by van der Kooij, which is the method of bacterial growth measurement by colony‐forming units using the strain P17 and/or NOX. The bacterial indicator species used for this study is Acinetobacter calcoaceticus which was isolated and identified while ozonating Nakdong river water. This strain could never be isolated from the raw water, but this strain was the predominant isolate in the ozonated water. Within a short incubation time, this organism was found to replicate well on acetate and oxalate as the sole carbon sources. The yield coefficients of this organism for acetate and oxalate are the same order of magnitude as the value of P17 and NOX. With full‐scale experiments, A. calcoaceticus concentration was found to increase after ozonation, but did not decrease upon chlorination. In laboratory‐scale experiments with Yongsan river water, aldehyes were found to be produced in proportion to the ozone dose. The raw water contains low concentrations of aldehydes, but has a high AOC concentration. A correlation between aldehyde production and AOC production was observed in the tested water with ozonation.     

Apoptosis in the failing human heart

BACKGROUND: Loss of myocytes is an important mechanism in the development of cardiac failure of either ischemic or nonischemic origin. However, whether programmed cell death (apoptosis) is implicated in the terminal stages of heart failure is not known. We therefore studied the magnitude of myocyte apoptosis in patients with intractable congestive heart failure. METHODS: Myocardial samples were obtained from the hearts of 36 patients who underwent cardiac transplantation and from the hearts of 3 patients who died soon after myocardial infarction. Samples from 11 normal hearts were used as controls. Apoptosis was evaluated histochemically, biochemically, and by a combination of histochemical analysis and confocal microscopy. The expression of two proto-oncogenes that influence apoptosis, BCL2 and BAX, was also determined. RESULTS: Heart failure was characterized morphologically by a 232-fold increase in myocyte apoptosis and biochemically by DNA laddering (an indicator of apoptosis). The histochemical demonstration of DNA-strand breaks in myocyte nuclei was coupled with the documentation of chromatin condensation and fragmentation by confocal microscopy. All these findings reflect apoptosis of myocytes. The percentage of myocytes labeled with BCL2 (which protects cells against apoptosis) was 1.8 times as high in the hearts of patients with cardiac failure as in the normal hearts, whereas labeling with BAX (which promotes apoptosis) remained constant. The near doubling of the expression of BCL2 in the cardiac tissue of patients with heart failure was confirmed by Western blotting. CONCLUSIONS: Programmed death of myocytes occurs in the decompensated human heart in spite of the enhanced expression of BCL2; this phenomenon may contribute to the progression of cardiac dysfunction.     

The importance of geriatrics to family medicine: a position paper by the Group on Geriatric Education of the Society of Teachers of Family Medicine

The role of geriatrics and geriatricians in family medicine remains unsettled. Despite a rapidly aging population, a tremendous shortage now exists of faculty with interest and expertise in geriatrics. Relatively few family practice residents choose to enter geriatric fellowship programs, and federal funding for such programs has been reduced. Despite accreditation requirements, residency programs are not always able to provide the range of geriatric experiences needed to properly prepare graduates to provide care for the broad range of older patients. Medical students' exposure to geriatrics remains limited. The Group on Geriatric Education of the Society of Teachers of Family Medicine believes that family medicine faculty must recognize and be committed to the notion that geriatrics is integral to family medicine. Both undergraduate and residency training programs should emphasize experience with geriatric patients in multiple settings. In particular, the nursing home should not be the main focus of geriatric training. The small number of certified geriatric faculty will be able to provide leadership, but a broad range of faculty must become involved in teaching geriatrics. Faculty development activities and continuing education programs to foster the necessary expertise will be essential to the accomplishment of this task.     

Silicon bipolar chipset for SONET/SDH 10 Gb/s fiber-opticcommunication links

High-speed multiplexers, demultiplexers, frequency dividers, mixers, and amplifiers are key electronic components in high-speed fiber-optic communications systems such as SONET/SDH. In this paper, we present several important digital and analog integrated circuits (IC) which have been developed for use in SONET/SDH 10 Gb/s optical communication links. The circuits have been fabricated in MOSAIC 5E, an advanced silicon bipolar technology (f_T=26 GHz). The resulting chipset which amounts to a total of 10 IC's consists of multiplexers, demultiplexers, a regenerative frequency divider (2:1), a dual output limiting amplifier, and two different types of mixers for clock extraction. Specifically, the design and performance of these IC's and a hybrid clock recovery module are discussed. The high performance and potential low cost of this research chipset show that advanced silicon bipolar circuit technology can play an important role in future multigigabit fiber-optic communication systems