Cr3+ microspectroscopy measurements and modelling of local variations in surface grinding stresses in polycrystalline alumina

Surface residual stresses caused by grinding and polishing of alumina are thought to influence materials properties but have previously been measured only by low spatial resolution techniques which sample average stresses. In this work confocal Cr³⁺ fluorescence microscopy has been used to investigate the spatial distribution of the residual stresses. A model for the residual stresses, accounting for both surface plastic deformation and “pullout” of material from the surface by brittle fracture, was developed to help in analysing the results. After coarse diamond grinding, the results showed that the residual stresses fluctuate greatly with position. Large tensile stresses (up to ～600 MPa) were found below the plastically deformed surface layer in regions between the “pullouts”. These tensile stresses are expected to aid crack propagation and further surface pullout. They arise because pullout removes parts of the plastically deformed surface layer. The stresses beneath the pullout sites themselves were compressive, but the largest compressive stresses (≈?1.5 GPa) were within the plastically deformed surface regions and extended to a depth of 1.3 μm. The plastically deformed surface layer was much shallower following polishing with 3 μm diamond paste but the compressive stress within it was of similar magnitude to that in the plastically deformed surface layer caused by grinding.     

Study of gas streaming in a deep fluidized bed containing Geldart's Group A particles

The nature of gas streaming in a deep fluidized bed containing Geldart's Group A powder has been investigated in a 30-cm ID cold flow unit. Pressure fluctuations have been measured at 8 locations from 4 to 150 cm above the gas distributor for bed depths and gas velocities ranging from 0.4 to 1.6 m and 0.04 to 0.20 m/s, respectively. In order to study the effect of fines content on gas streaming, two particle size distributions with Sauter mean diameters of 48 and 84 μm were tested for each bed depth and gas velocity. Two distributor plates with differing percentage open area were also tested for their influence on gas streaming. Analysis of pressure fluctuations in the time and frequency domains, in combination with visual observations show that streaming flow emerges gradually at bed depths greater than 1 m. Increased gas velocity and fines content act to delay the onset of streaming, but cannot completely eliminate it over the range of velocities examined. The two different distributor designs had no measurable effect on the streaming flow.     

Electrochemical detection of single-nucleotide mismatches: application of M-DNA

The detection of a single-nucleotide mismatch in unlabeled duplex DNA by electrochemical methods is presented. Impedance spectroscopy is used to characterize a perfect duplex monolayer and three DNA monolayers differing in the position of the mismatch. The monolayers were studied as B-DNA (normal duplex DNA) and after conversion to M-DNA (a metalated duplex). Modeling of the impedance data to an equivalent circuit provides parameters that are useful in discriminating the four monolayer configurations. The resistance to charge transfer, R(CT), was lower for all duplexes after conversion to M-DNA. Contrary to expectations, R(CT) was also found to decrease for duplexes containing a mismatch. However, R(CT) was found to be diagnostic for mismatch detection. In particular, the difference in R(CT) between B- and M-DNA (deltaR(CT)) decreased from 190(22) omega.cm(2) for a perfectly matched duplex to 95(20), 30(20), and 85(20) omega.cm(2) for a mismatch at the top (distal), middle, and bottom (proximal) positions of the monolayer with respect to the gold surface. Further, a method to form loosely packed single-stranded (ss)-DNA monolayers by duplex dehybridization that is able to rehybridize to target strands is presented. Rehybridization efficiencies were in the range of 40-70%. Under incomplete hybridization conditions, the R(CT) was the same for matched and mismatched duplexes under B-DNA conditions. However, deltaR(CT) between B- and M-DNA, under incomplete hybridization, still provided a distinction. The deltaR(CT) for a perfect duplex was 76(12) omega.cm(2), whereas a mismatch in the middle of the sequence yielded a deltaR(CT) value of 30(15) omega.cm(2). The detection limit was measured and the impedance methodology reliably detected single DNA base pair mismatches at concentrations as low as 100 pM.     

Anomalous double blood supply to the lung

We report an unusual case in which an apparently normal upper lobe of the right lung was supplied by major systemic arterial and pulmonary arterial vessels. The anomalous artery arose from the descending aorta. Following interruption of this vessel, the machinery-like murmur previously present disappeared.     

Progress in application of high temperature superconductor in tokamak magnets

It has long been known that high temperature superconductors (HTS) could have an important role to play in the future of tokamak fusion research. Here we report on first results of the use of HTS in a tokamak magnet and on the progress in design and construction of the first fully-HTS tokamak.     

Thoughts of agoraphobic people during scary tasks.

The authors examined the occurrence of theoretically derived patterns of thinking in 74 agoraphobic participants as they drove alone or tolerated an enclosed place. During the increasingly scary tasks in a behavioral test hierarchy, participants responded to a periodic beep by stating aloud what they were thinking at that moment, yielding more than 1,800 tape-recorded statements. Content analyses revealed that participants were mainly preoccupied with their current anxiety (expressed in 29% of the statements) and with their self-efficacy (15%). Despite participants' mounting feelings of anxiety, fewer than 1% of their statements expressed a thought of danger or an anticipation of future anxiety or panic. The rarity of danger thoughts poses an explanatory challenge for all cognitive theories of phobia and especially for the perceived danger theory of A. T. Beck (1976) and A. T. Beck, G. Emery, and R L. Greenberg (1985). (PsycINFO Database Record (c) 2010 APA, all rights reserved)     

Lean NOx Trap Chemistry Under Lean-Gasoline Exhaust Conditions: Impact of High NOx Concentrations and High Temperature

The primary technical barrier to deployment of fuel saving lean gasoline engines is NOx emissions control. We conducted automated flow reactor experiments on a commercial LNT catalyst to identify opportunities and challenges associated with the higher temperatures and higher NOx concentrations expected in lean gasoline applications. Overall NOx conversion was quite high at low to moderate temperatures, but dropped off at high temperatures. The decrease in NOx conversion with temperature was worse for higher inlet NOx concentrations. As expected from equilibrium considerations, the catalyst stored more NOx under higher gas phase NOx concentrations, but that NOx was rapidly released during the rich phase and slipped out of the catalyst before it could be converted to N₂ by incoming reductant. This rich phase NOx release was the primary factor limiting performance of the catalyst at high temperatures, and resulted in significant spikes of NOx that would likely exceed any not-to-exceed regulated emissions levels. N₂O production was also significant, and increased with NOx concentration. The catalyst made very little NH₃ at high temperatures. NH₃ yield was significant at the lowest operating temperature studied, but it decreased with increasing NOx concentration.