Free volume and permeabilities of O2 and H2 in Nafion membranes for polymer electrolyte fuel cells

The mechanism of gas permeation in Nafion membranes for polymer electrolyte fuel cells has been investigated from the viewpoint of free volume. Three different samples, a membrane with ionic exchange capacity (IEC) = 0.92 meq/g, and recast samples with IEC = 0.92 and 1.00 meq/g were used after drying. Free volume was quantified using the positron annihilation lifetime (PAL) technique and gas permeabilities were measured for O₂ and H₂ as functions of temperature and relative humidity. Good linear correlations between the logarithm of the permeabilities at different temperatures and reciprocal free volume indicate that gas permeation in dry Nafion is governed by the free volume. Nevertheless permeabilities are much smaller than the corresponding flexible chain polymer with a similar free volume size due to stiff chains of the perfluoroethylene backbone. In highly hydrated Nafion above 60% relative humidity, where the O₂ permeability varies oppositely to the free volume, gas permeation proved to be controlled by the gradual increase in overall flexibility of the Nafion–water system.     

Atomic force microscopic study on DNA-wrapping for different diameter single-wall carbon nanotubes

DNA-wrapped single-wall carbon nanotubes (DNA-SWNT hybrids) prepared from different diameter HiPco- and Arc-SWNTs were investigated by atomic force microscopy. The mean diameter of DNA-HiPco-SWNT hybrids is 1.94 nm that is consistent with one HiPco-SWNT (~ 0.9 nm) wrapped by DNA (~ 1 nm). On the other hand, the mean diameter of DNA-Arc-SWNT hybrids is 3.74 nm that can correspond to one Arc-SWNT (~ 1.4 nm) wrapped by several layers of DNA. It is suggested that the DNA-wrapping mechanism for large diameter Arc-SWNTs is different from that for small diameter HiPco-SWNTs.     

Suppression of photo-induced dilation in cyanide treated hydrogenated amorphous silicon films

Effects of cyanide (CN) treatment with hydrogenated amorphous silicon (a-Si:H) films have been investigated. The decrease of ΔV/V was observed in cyanide treated a-Si:H films and the successive thermal annealing at 200°C after CN treatment induced the further reduction of the ΔV/V. XPS spectra show the indirect evidence that the cyanide species is present within 10 nm from the hydrogenated amorphous silicon surface. The results of CN treatment with a-Si:H solar cells are demonstrated.     

Evaluation of static and dynamic fracture toughness in ductile cast iron

Crack extension behavior and fracture toughness of ductile cast iron were examined by three-point bend tests, where various detection methods of crack initiation under static and dynamic loading conditions were adopted. Loading on the specimens was interrupted at various displacement points, and the final fracture surfaces of the specimen were observed via scanning electron microscopy (SEM). Crack-tip opening displacement (CTOD) obtained under the dynamic loading condition was smaller than that under the static loading condition in ferritic ductile cast iron, and CTOD additionally decreased with increasing pearlite content in the matrix. The relationship between J (ΔC) obtained by the compliance changing rate method and J(R) established by the intersection of the crack extension resistance curve and the theoretical blunting line varied with pearlite content. The average value of .J(ΔC) and J(R), that is J (mid), was proposed to define the fracture toughness of ductile cast iron; J (mid) was considered to be a reasonable measure for the fracture toughness of ductile cast iron, irrespective of loading condition and the pearlite content in the matrix.     

Blue electroluminescent devices withSrGa2S4:Ce for full-color display

In order to realize full-color electroluminescent (EL) displays, which are expected as a dominant candidate for the future multimedia flat panel display, blue EL devices with SrGa₂S₄:Ce have been prepared by molecular beam epitaxy (MBE). This paper proposes a novel deposition method employing Sr metal and Ga₂S₄ compound as the source materials. A single-phase SrGa₂S₄ layer is obtained in a Ga₂S₃/Sr flux ratio of 60 and at the growth temperature of 560°C. We have obtained the well-saturated blue with CIE color coordinates of x=0.14, y=0.14 and brighter blue EL devices made by optimizing the growth conditions in MBE. The maximum luminance of 70 cd/m² in comparison with the 3 cd/m₂ of our previous EL devices, is achieved at a driving frequency of 1 kHz     

Oxidation of methane to formaldehyde over Fe/SiO2 and Sn---W mixed oxides

In an attempt to develop new catalysts for the formation of formaldehyde from methane, the promotion effect of Fe on SiO₂ and that of Sn on WO₃ have been studied. The formation of formaldehyde on silica can be appreciably enhanced by the impregnation of Fe, as far as iron loadings are kept below 0.1 atom.% (Fe/Si × 100). In the case of Sn---W---Ox catalysts, both the addition of Sn to WO₃, and that of W on SnO₂ were effective to the selective formaldehyde formation. Absorption spectra (UV-Vis) and ESR measurements revealed that tetrahedrally coordinated Fe³⁺ in the silica network plays an important role in the formation of formaldehyde. A thin surface layer consisting of W and Sn oxides can account for the selective formaldehyde formation on the Sn---W---Ox catalysts.     

Minor role of fractographic features in basic fatigue crack propagation properties

The fatigue crack propagation rate and the fatigue threshold were investigated for transverse-butt-welded joints of the austenitic stainless steel SUS304. Specimens were of the center-cracked type. In three sets of tests the fatigue crack passed through the weld metal, and in the other two sets, through the base metal. The fatigue crack propagation properties coincided with each other at different stress ratios for the weld metal, and at the higher stress ratios for the base metal. The propagation properties improved at the stress ratio of zero for the base metal. The absence of a stress ratio effect means that the coincided properties are basic ones in which fatigue crack closure does not occur. However, fractographic appearance and surface roughness were quite different between weld metal and base metal. The coincidence of fatigue crack propagation properties in spite of the difference in fractographic features reveals that the fractographic appearance and surface roughness only have a minor effect on basic fatigue crack propagation behaviour.     

Integration of knowledge-based systems with data processing

Transaction Oriented Prolog-Online Environment is a multi-user, mainframe implementation of the logic programming language Prolog, specially designed and developed for the data processing environment. This article describes the background, functionality, implementation and use of TOP-ONE, stressing that applications of knowledge-based systems technology to data processing environments will achieve full success only when existing systems and existing conventional data are incorporated within the applications.     

Monolithic rat-race mixers for millimeter waves

In this paper, we report on fully monolithic millimeter-wave Schottky-barrier diode (SBD) down-converters with an IF amplifier using heterojunction bipolar transistors (HBT's). A rat-race circuit is used for the mixer, and is analyzed using a harmonic-balance simulator. The measured conversion gain and the isolation are 7.1 and 29 dB in the V-band design, and 8.0 and 25 dB in the W-band design, respectively. The conversion gains are matched well with the circuit simulation