Catalytic combustion over platinum group catalysts: fuel-lean versus fuel-rich operation

Performance data are presented for methane oxidation on alumina-supported Pd, Pt, and Rh catalysts under both fuel-rich and fuel-lean conditions. Catalyst activity was measured in a micro-scale isothermal reactor at temperatures between 300 and 800 °C. Non-isothermal (near adiabatic) temperature and reaction data were obtained in a full-length (non-differential) sub-scale reactor operating at high pressure (0.9 MPa) and constant inlet temperature, simulating actual reactor operation in catalytic combustion applications.

Under fuel-lean conditions, Pd catalyst was the most active, although deactivation occurred above 650 °C, with reactivation upon cooling. Rh catalyst also deactivated above 750 °C, but did not reactivate. Pt catalyst was active above 600 °C. Fuel-lean reaction products were CO₂ and H₂O for all three catalysts.

The same catalysts tested under fuel-rich conditions demonstrated much higher activity. In addition, a ‘lightoff’ temperature was found (between 450 and 600 °C), where a stepwise increase in reaction rate was observed. Following ‘lightoff’ partial oxidation products (CO, H₂) appeared in the mixture, and their concentration increased with increasing temperature. All three catalysts exhibited this behavior.

High-pressure (0.9 MPa) sub-scale reactor and combustor data are shown, demonstrating the benefits of fuel-rich operation over the catalyst for ultra-low emissions combustion.     

Responses to prey chemicals by a lacertid lizard,Podarcis muralis: Prey chemical discrimination and poststrike elevation in tongue-flick rate

The ability to discriminate prey chemicals from control substances and the presence of a poststrike elevation in tongue-flicking (PETF) rate are experimentally demonstrated in the lacertid lizard,Podarcis muralis, The tongue-flick attack score, a composite index of response strength, was significantly higher in response to integumental chemicals from cricket than to cologne or distilled water. The cricket chemicals additionally elicited a significantly greater rate of tongue-flicking and higher proportion of attacks by the lizards than did control stimuli. PETF combined with apparent searching movements strongly suggest the presence of strike-induced chemosensory searching (SICS). Experimental evidence indicates that both PETF and SICS occur in insectivorous representatives of three families of actively foraging autarchoglossan lizards, suggesting their widespread occurrence in such lizards. The adaptive roles of chemosensory behavior in the foraging behavior of P.Muralis are discussed. It is proposed that these lizards may form chemical search images and that PETF and SICS may have been present in the lacertilian ancestors of snakes.     

Novel poly(butylene terephthalate)/poly(vinyl butyral) blends prepared by in situ polymerization of cyclic poly(butylene terephthalate) oligomers

Blends of in situ polymerized PBT from cyclic oligomers (c-PBT) and PVB were prepared with varying compositions and compared with mechanical blends of conventional PBT and PVB. The materials were characterized by a variety of techniques including DSC, DMTA, DETA, FTIR, NMR and GPC. It was found that the in situ prepared blend of c-PBT/PVB has one glass transition temperature and shows evidence of miscibility. In contrast, the conventional blend of PBT/PVB shows incompatibility after blending. The cause of miscibility in the in situ prepared PBT/PVB blends is thought to be the formation of a graft copolymer. These results show that there are unique possibilities for in situ processing by combining polymerization of cyclic polyester oligomers with blending.     

Delayed conversion of squalene to sterols during development ofPinus pinea seeds

During germination of seeds of the gymnosperm,Pinus pinea, radioactivity from [2-¹⁴C]-mevalonate proceeded principally through the anaerobic reactions leading to squalene in the first 24 hr in both the haploid endosperm and the diploid embryo, and only with succeeding time (3–9 days) in both cases was label transferred to sterols in oxygen-requiring steps. The rates of turnover must be real and independent in the two tissues, since no consequential interchange of labelled lipids occurred between the endosperm and the embryo. Similar delayed conversion of squalene to sterols has been observed previously during germination of seeds of the angiosperm,Pisum sativum.     

Effect of Zwitterionic Surfactants on Interparticle Forces, Rheology, and Particle Packing of Silicon Nitride Slurries

Phosphocholine (PC) zwitterionic surfactants, with different hydrocarbon chain lengths (C₆C₆PC to C₉C₉PC), were absorbed on the surface of silicon nitride near the isoelectric point (pH 6). Adsorption of the surfactants changed the lateral and normal surface forces, the rheology, and the consolidation behavior of the particles. The normal force between two silicon nitride surfaces as a function of separation and the lateral (friction) forces were measured using an atomic force microscope (AFM). These measurements indicated that surfactant adsorption reduced the magnitude of the long-range attractive van der Waals force and produced a repulsive short-range force. Although the adsorbed layers provided a barrier to particle contact, they could be ejected with a critical force that increased with the hydrocarbon chain length. The effect of an adsorbed layer on the viscosity and consolidation of slurries was also measured. The viscosity of all slurries decreased with increasing shear rate, indicative of attractive particle networks. The highest viscosity was observed for slurries formulated at the isoelectric point without added surfactant. Much lower viscosities were observed when the surfactant concentration was greater than the critical micelle concentration (cmc). A relative density of 0.46 was obtained via pressure filtration at 4 MPa without a surfactant, and between 0.46 to 0.59 (C₆C₆PC to C₉C₉PC, respectively) for surfactant concentrations greater than the cmc. Comparing force measurements with rheology and packing density provides a basis for discussing the role of interparticle forces in ceramic powder processing via colloidal routes.     

Spin coating behavior of polyimide precursor solutions

Experimental data confirm the utility of the following simple equation in predicting the spin coating behavior of polyimide precursor solutions: in which .     

Model for drying during fluidized-bed combustion of wet low-rank coals

An unsteady state heat conduction model with a convective boundary condition is proposed for the drying of low-rank, high-porosity coals, such as lignites, during fluidized-bed combustion. The drying front is assumed to be the receding surface of a wet core. The solution technique for this moving boundary problem is based on the heat balance integral approach with immobilization of the moving boundary by a change in space variable. The governing cubic equation describing the drying curve in dimensionless form may be solved easily by the Newton—Raphson method. The model predictions are compared with experimental data for Mississippi lignite with excellent agreement. A correlation for estimation of total drying time is proposed. The temperature profiles obtained may be used for the study of the coupled drying and devolatilization in fluidized-bed combustors. The profiles could also be of importance in the study of formation of fissures/cracks in lignites subjected to intense heating conditions encountered during fluidized-bed combustion.     

Mössbauer analysis of iron phases in brown coal ash and fireside deposits

The iron phases present in an electrostatic precipitator ash, an uncooled ash deposit and a cooled superheater ash deposit from Hazelwood Power Station, Australia, burning Morwell brown coal has been examined using Mössbauer spectroscopy. The principal iron phase in the precipitator ash and the uncooled ash deposit from a hot gas offtake was calcium aluminoferrite (Ca₂Fe_{2 ? x}Al_xO₅). Minor amounts of hematite (α-Fe₂O₃) and magnetite (Fe₃O₄) were also detected in the precipitator ash. The cooled superheater ash deposit contained a (Mg, Fe, Al) oxide spinel as the primary iron phase; small quantities of hematite were also detected in this deposit close to the heat exchanger interface. The formation of these iron phases has been rationalized on the basis of the average composition of coal delivered to the power station and supplementary ash chemistry data obtained from other techniques. The evidence suggests that the calcium aluminoferrite in the precipitator ash is derived from inorganic constituents (distributed throughout the coal organic matrix) and the hematite and magnetite are of mineral origin (discrete particles).     

Correlation of reactivity and electrical resistivity of coke

A correlation between the reactivity and electrical resistivity of a series of cokes was determined using cokes prepared from blends of medium- and high-volatile coals. After correcting for the ash yield of the coke and the density of the resistivity specimen, a statistically significant relation between reactivity and resistivity was established. As the resistivity test requires much less time to perform than the reactivity test, it can be considered as an alternative approach to reactivity testing currently performed for quality control purposes.     

Organolithium route to poly(arylsilane)s

Various poly(arylsilane)s The poly(carbosilane)s prepared in this way are of higher molecular weight than when prepared by the Wurtz-type condensation route previously reported. TG shows 40–50% overll weight loss attained at 500–600°C.