Influence of third monomer on the crystal phase transition behavior of ethylene-tetrafluoroethylene copolymer

Crystal phase transition between the low- and high-temperature phases has been investigated for ethylene (E)-tetrafluoroethylene (TFE) alternating copolymer (ETFE) containing the third monomeric species by the temperature dependent measurements of wide-angle X-ray diffraction (WAXD) and small-angle X-ray scattering (SAXS) and differential scanning calorimetry. Nonafluoro-1-hexene (NFH) and hexafluoropropylene (HFP) were chosen as the third monomers, where they are different in the side-branch length, -(CF₂)₃CF₃ and -CF₃, respectively. In the case of E/TFE/NFH copolymer (ET-C4F9), the crystal phase transition temperature of the original ETFE two-components copolymer was not very much affected by the existence of NFH in the range of NFH content from 0.7 to 3 mol%. Contrarily, the crystal phase transition temperature of E/TFE/HFP copolymer (ET-CF3) was found to decrease drastically with increasing HFP content. The melting temperature and the higher-order structure were also affected sensitively depending on the HFP content. This difference in phase transition behavior between ET-C4F9 and ET-CF3 copolymers is reasonably interpreted as follows: the short side groups (-CF₃) of HFP monomeric unit are included in the crystal lattice of E/TFE chains and the unit cell is expanded gradually with an increment of the HFP content, resulting in the decrease in phase transition point because of easier thermal motion of the chains. On the other hand, the long side groups [-(CF₂)₃CF₃] of NFH monomeric units are excluded out of the crystal lattice and located on the lamellar surfaces or in the amorphous region and do not affect very much the phase transition temperature even when the NFH content is increased. In association with such a change in crystal structure, the long period of stacked lamellar structure was found to decrease remarkably in the case of NFH, whereas it does not change very much for HFP, consistent with the interpretation of the above-mentioned WAXD data.     

Suppression of photo-induced dilation in cyanide treated hydrogenated amorphous silicon films

Effects of cyanide (CN) treatment with hydrogenated amorphous silicon (a-Si:H) films have been investigated. The decrease of ΔV/V was observed in cyanide treated a-Si:H films and the successive thermal annealing at 200°C after CN treatment induced the further reduction of the ΔV/V. XPS spectra show the indirect evidence that the cyanide species is present within 10 nm from the hydrogenated amorphous silicon surface. The results of CN treatment with a-Si:H solar cells are demonstrated.     

Adsorption of trypsin onto poly(2-hydroxyethyl methacrylate)/polystyrene composite microspheres and its enzymatic activity

Poly(2-hydroxyethyl methacrylate)/polystyrene (PHEMA/PS) composite microspheres were produced by emulsifier-free seeded emulsion polymerization for styrene in the presence of PHEMA seed particles. Effects of the surface characteristics of the PHEMA/PS composite microspheres on the adsorption immobilization of trypsin and on its enzymatic activity were discussed. Above 5 mol% of HEMA content, trypsin molecules adsorbed had high activity, 65–100% of the activity of free trypsin. The excellence of the composite microspheres as a carrier for trypsin seems to be closely related with the surface heterogeneity consisting of both hydrophilic and hydrophobic parts.     

Studies on catalysis by molten metals. 14. Catalytic cracking of asphalts at low temperature

The catalytic effects of liquid metals for low-temperature (336 °C) asphalt-cracking have been examined using a semi-batch reactor. All the liquid metals examined (Bi, Cd, Ga, In, Pb and Sn) effectively catalysed the reduction of molecular weight with minimal gasification (<1 wt%). Gasification had a positive correlation with the reduction in molecular weight in the processed asphalts. The catalytic activities of liquid metals tor these two reactions were proportional to a parameter which represents the interaction between the atoms of the catalyst metal and the radicals formed in the course of the reaction. Mass flow among four fractions (saturates, aromatics, resins and asphaltenes) had two independent paths: conversion of resins to saturates and of aromatics to asphaltenes. The former path dominated when catalytic dehydrogenation activity was relatively low, whereas the latter dominated when the catalytic activity was high.     

An apparent ensemble effect in the oxidative coupling of methane on hydroxyapatites with incorporated lead

The introduction of small quantities of lead into calcium hydroxyapatite catalysts produces marked increases in the selectivity to C₂₊ hydrocarbons, while the conversion of methane remains relatively constant. Small surface concentrations of lead are sufficient to achieve C₂₊ selectivities of 80 and 90%, with oxygen and nitrous oxide, respectively, in contrast with 18 and 46%, respectively, obtained in the absence of lead. Since surface concentration of lead species sufficient to stabilize pairs of methyl radicals in close proximity to each other would be expected to facilitate the formation of C₂ hydrocarbons, an ensemble effect appears to be extant.     

Ketones from carboxylic acids over supported magnesium oxide and related catalysts

Silica-supported alkaline earth oxides revealed excellent activity to convert acetic acid selectively into acetone in a vapor-phase fixed-bed flow system. Acetone was obtained through the cyclic formation of alkaline earth acetate followed by decomposition. Magnesium oxide should be supported on the silica surface without formation of magnesium silicate, which was inactive for the present reaction. Attempted syntheses of benzophenone and acetophenone are also described.     

Effect of zeolite in surface discharge plasma on the decomposition of toluene

Toluene was decomposed in a surface discharge plasma reactor packed with various zeolites. The positioning effect of the zeolite bed was also investigated Reactor-B, in which the zeolite bed was located upstream, performed much better than Reactor-A, in which the zeolite bed was located downstream. Furthermore, the decomposition efficiency in Reactor-B increased with the capacity for toluene adsorption on zeolite, while that in Reactor-A did not. The toluene adsorbed in micropores was not decomposed effectively by direct electron impact, but was decomposed by active oxygen species generated in the plasma zone on the zeolite surface. A good correlation was also observed between toluene decomposition and ozone consumption in the downward-type reactor.     

The effect of the N-linked glycans on structural features and physicochemical functions of soybean β-conglycinin homotrimers

β-Conglycinin is a trimeric protein consisting of three subunits, α,α′,and β, which are N-glycosylated. The α and α′ subunits contain extension regions in addition to core regions common to all subunits. We purified homogeneous trimers consisting of only α, α′, or β from mutant soybean cultivars containing β-conglycinin lacking one or two subunits: α homotrimers from an α′-lacking mutant, α′ homotrimers from an α-lacking mutant, and β homotrimers from an α-and α′-lacking mutant. Structural features and physicochemical functions of the three homotrimers were examined and compared with those of recombinant homotrimers having no N-linked glycans. The native homotrimers have secondary structures very similar to those of the recombinant ones. In analogy with the recombinant homotrimers, the native ones exhibit different thermal stabilities from one another (β>α′>α), and the native α and α′ homotrimers exhibit better solubility, emulsifying ability, and heat-induced association than the native β homotrimer. Further, the N-linked glycans contribute to solubilities of the three subunits at low ionic strength (μ=0.08) and to the emulsifying ability of the native β homotrimer. N-Linked glycans also prevent heat-induced associations of the native α and α′ homotrimers but do not contribute to the secondary structure and the thermal stability of β-conglycinin.