Analysis and optimization of DS-CDMA systems with time-limited partial response chip waveforms

Conventional direct sequence code division multiple access systems (DS-CDMA) using offset quadrature phase shift key (OQPSK) usually employ a strictly bandlimited partial response square-root raised cosine pulse as the chip waveform. They have the disadvantage of large envelope fluctuation that will incur performance degradation due to the intermodulation and bandwidth enlargement caused by post nonlinear processing. To improve the performance of DS-CDMA systems, the chip waveform and receiver should be properly selected. This paper presents a systematic performance analysis of a matched filter receiver and zero-forcing filter (ZF) receiver for DS-CDMA using a time-limited partial response chip waveform. Nevertheless the systematic performance analysis is applicable to bandlimited chip pulse as well. For the zero-forcing filters, we propose to select the frequency responses that satisfy the first Nyquist criterion. With this class of filters, we can choose the roll-off factor to minimize the total power of multiple access interference and noise power. The zero-forcing filter with proper choice of roll-off factor, referred to as optimum ZF, yields a performance better than the matched filter counterpart. The bit error rate (BER) performance of the optimum ZF with superposed quadrature amplitude modulation signal as the time pulse waveform is evaluated. It is shown that the optimum ZF provides better BER performance than conventional OQPSK and minimum shift keying, and its envelope uniformity is much better than that of OQPSK.     

Comprehensive Study of Emitter-Ledge Thickness of InGaP/GaAs HBTs

A comprehensive study of emitter-ledge thickness of InGaP/GaAs heterojunction bipolar transistors (HBTs) has been undertaken. It is shown that the recombination rate and electron densities are drastically increased near the exposed base surface between the base contact and the emitter ledge. In contrast, the corresponding hole densities are decreased. If the emitter ledge is too thick, current will flow through the undepleted ledge, which increases the emitter-size effect. In contrast, if the emitter ledge is too thin, it may not effectively passivate the surface. Therefore, the thickness of the emitter ledge is a crucial issue and should be carefully considered. It is shown that, from simulated and experimental results, the optimum emitter-ledge thickness of InGaP/GaAs HBT is 100-200 Aring     

Region-based image retrieval using color-size features of watershed regions

This paper presents a region-based image retrieval system that provides a user interface for helping to specify the watershed regions of interest within a query image. We first propose a new type of visual features, called color-size feature, which includes color-size histogram and moments, to integrate color and region-size information of watershed regions. Next, we design a scheme of region filtering that is based on color-size histogram to fast screen out some of most irrelevant regions and images for the preprocessing of the image retrieval. Our region-based image retrieval system applies the Earth Mover’s Distance in the design of the similarity measure for image ranking and matching. Finally, we present some experiments for the color-size feature, region filtering, and retrieval results that demonstrate the efficiency of our proposed system.     

Conception of Stretchable Resistive Memory Devices Based on Nanostructure‐Controlled Carbohydrate‐block‐Polyisoprene Block Copolymers

It is discovered that the memory‐type behaviors of novel carbohydrate‐block ‐polyisoprene (MH‐b ‐PI) block copolymers‐based devices, including write‐once‐read‐many‐times, Flash, and dynamic‐random‐access‐memory, can be easily controlled by the self‐assembly nanostructures (vertical cylinder, horizontal cylinder, and order‐packed sphere), in which the MH and PI blocks, respectively, provide the charge‐trapping and stretchable function. With increasing the flexible PI block length, the stretchability of the designed copolymers can be significantly improved up to 100% without forming cracks. Thus, intrinsically stretchable resistive memory devices (polydimethylsiloxane(PDMS)/carbon nanotubes(CNTs)/MH‐b ‐PI thin film/Al) using the MH‐b ‐PI thin film as an active layer is successfully fabricated and that using the MH‐b ‐PI_12.6k under 100% strain exhibits an excellent ON/OFF current ratio of over 10⁶ (reading at ?1 V) with stable V _set around ?2 V. Furthermore, the endurance characteristics can be maintained over 500 cycles upon 40% strain. This work establishes and represents a novel avenue for the design of green carbohydrate‐derived and stretchable memory materials.     

Computation Controllable Mode Decision and Motion Estimation for Scalable Video Coding

This paper proposes an efficient computation‐aware mode decision and search point (SP) allocation algorithm for spatial and quality scalabilities in Scalable Video Coding. In our proposal, a linear model is derived to allocate the computation for macroblocks in enhancement layers by using the rate distortion costs of the base layer. In addition, an adaptive SP decision algorithm is proposed to decide the number of SPs for motion estimation under the constraint of the allocated computation. Experiment results demonstrate that the proposed algorithm allocates the computation resource efficiently and outperforms other works in rate distortion performance under the same computational availability constraint.     

Partial adaptive nulling on a monopulse phased array antenna system

A partial phase-only nulling (PPON) algorithm has been developed and evaluated on a 496-element monopulse phased array antenna system which employs five-bit phase shifters. Using this PPON algorithm allows nulls in the far-field pattern to be steered to the desired directions for a phased array equipped with low-resolution phase shifters to perform simultaneous nulling in the sum and two difference patterns in the environment of multiple jammers. Simulated and experimental patterns are illustrated     

A location‐aware peer‐to‐peer overlay network

This work describes a novel location‐aware, self‐organizing, fault‐tolerant peer‐to‐peer (P2P) overlay network, referred to as Laptop. Network locality‐aware considerations are a very important metric for designing a P2P overlay network. Several network proximity schemes have been proposed to enhance the routing efficiency of existing DHT‐based overlay networks. However, these schemes have some drawbacks such as high overlay network and routing table maintenance overhead, or not being completely self‐organizing. As a result, they may result in poor scalability as the number of nodes in the system grows. Laptop constructs a location‐aware overlay network without pre‐determined landmarks and adopts a routing cache scheme to avoid maintaining the routing table periodically. In addition, Laptop significantly reduces the overlay maintenance overhead by making each node maintain only the connectivity between parent and itself. Mathematical analysis and simulations are conducted to evaluate the efficiency, scalability, and robustness of Laptop. Our mathematical analysis shows that the routing path length is bounded by log_d N, and the joining and leaving overhead is bounded by d log_d N, where N is the number of nodes in the system, and d is the maximum degree of each node on the overlay tree. Our simulation results show that the average latency stretch is 1.6 and the average routing path length is only about three in 10 000 Laptop nodes, and the maximum degree of a node is bounded by 32. Copyright © 2006 John Wiley & Sons, Ltd.     

Simulations and experiments for optimal deployment of an RFID‐based location‐aware system

The proliferation of communication and mobile computing devices and local‐area wireless networks has cultivated a growing interest in location‐aware systems and services. An essential problem in location‐aware computing is the determination of physical locations. RFID technologies are gaining much attention, as they are attractive solutions to indoor localization in many healthcare applications. In this paper, we propose a new indoor localization methodology that aims to deploying RFID technologies in achieving accurate location‐aware undertakings with real‐time computation. The proposed algorithm introduces means to improve the accuracy of the received RF signals. Optimal settings for the parameters in terms of reader and reference tag properties were investigated through simulations and experiments. The experimental results indicate that our indoor localization methodology is promising in applications that require fast installation, low cost and high accuracy. Copyright © 2009 John Wiley & Sons, Ltd.     

High performance analog VLSI computational circuits

Simple linear voltage/current-controlled voltage-to-current (V-T) converters, which are to first-order insensitive to the threshold voltage variation, are introduced. The circuits can be used as basic building blocks to construct simple analog computational circuits, which can perform functions such as square rooting, squaring, multiplication, sum of squares, difference of squares, etc. Some of the key features are: good linearity, floating inputs [high common-mode rejection ratio (CMRR)], simplicity, and good transconductance tuning range. The circuits can be realized with CMOS devices in saturation, however, BiCMOS devices extend their speed and input voltage range. Realistic simulations and experimental results clearly demonstrate the claims     

Taxation on vehicle fuels: its impacts on switching to cleaner fuels

Vehicular consumption of fossil fuel contributes over 90% of air pollution in Hong Kong. A key strategy to improve Hong Kong's air quality is to discourage dirty fuels (e.g., leaded petrol and high-sulphur diesel) and to promote the use of clean fuels (e.g., low-sulphur diesel and liquefied petroleum gas (LPG)). This paper presents the empirical evidence on the effectiveness of the Government's clean fuel programs that offer tax subsidy to lower the consumption cost of such fuels. For the cases of unleaded petrol and ultra-low-sulphur diesel, lower fuel duties were offered so that the prices of these fuels were below those of leaded petrol and conventional diesel. Conventional petrol and diesel were phased out. In order to decide on the level of fuel duty concessions required to introduce LPG for taxis and bio-diesel for other vehicles, various Government-run trial programs were introduced to obtain cost estimates of using these alternative cleaner fuels. LPG using vehicles were subsequently exempted from the fuel duty in order to attract taxi and light bus operators to switch to LPG. It is apparent that the higher the subsidy, the faster is the rate at which switching to cleaner fuels takes place.