Experimental verification of the effect of a voltage‐detection‐based shunt active filter for harmonic damping throughout a power distribution line

This paper is focused on a voltage‐detection‐based shunt active filter for installation on a power distribution system. A main objective of the active filter is to achieve damping of harmonic propagation coming from series/parallel resonance between capacitors for power factor correction and line inductors in the distribution system. The active filter installed at the end terminal of a distribution feeder is controlled in such a way as to present infinite impedance to the external circuit for the fundamental frequency, and to exhibit low resistance for harmonic frequencies. As a result, the active filter acts as a damping resistor for the harmonic propagation, like a 50‐Ω terminator installed at the end of a signal transmission line. It is verified by experiment that the active filter intended for harmonic termination has the capability of harmonic damping throughout the distribution feeder. © 2000 Scripta Technica, Electr Eng Jpn, 133(2): 1–10, 2000     

Stochastic ellipsoid methods for robust control: Multiple updates and multiple cuts

Efficient randomized algorithms are developed for solving robust feasibility problems with multiple parameter-dependent convex constraints. Two complementary strategies are presented, both of which exploit the multiplicity to achieve fast convergence. One is the stochastic ellipsoid method with multiple updates. In each iteration of this algorithm, an ellipsoid which describes a candidate of the solution set is updated many times via the multiple constraints with one random sample, while at most one update is allowed in the original method. The other is the stochastic ellipsoid method with multiple cuts. Here, a new update rule is presented to construct a smaller ellipsoid directly via multiple subgradients given by the constraints. A quantitative analysis of the volume of the ellipsoid is also provided, which guarantees the advantage of the proposed algorithm over the original one. The above features lead to a reduction of the total number of random samples necessary for convergence, which is extensively demonstrated through numerical examples.     

Scrotal ulcer occurring in patients with acute promyelocytic leukemia during treatment with all-trans retinoic acid

STUDY OBJECTIVE: To evaluate the efficacy of conservative laparoscopic surgery in a series of patients with stage III-IV endometriosis. DESIGN: Prospective study (Canadian Task Force classification II-1). SETTING: University-affiliated hospital. PATIENTS: All 141 women who underwent conservative operative laparoscopy for stage III-IV endometriosis between January 1993 and December 1996 and were followed for a minimum of 6 months. INTERVENTIONS: Laparoscopic procedures performed with scissors, bipolar coagulation, and hydrodissection. MEASUREMENTS AND MAIN RESULTS: Clinical examination, transvaginal ultrasonography, and pain questionnaire were scheduled every 6 months postoperatively. The cumulative proportion of pregnant patients and cumulative recurrence rate were calculated by Kaplan-Meier method. Twenty-five women (44%) with infertility became pregnant. Twenty-three (51%) had stage III and two (16.7%, p <0.05) had stage IV endometriosis. The 24-month cumulative pregnancy rate was 57.5%. Thirty-one women (22%) reported pain recurrence during follow-up. Five (3.5%) recurrences were confirmed by histologic examination and eight (5.7%) were documented only by clinical and ultrasonographic findings. No recurrence occurred in the first 6 months of follow-up. CONCLUSION: Operative laparoscopy seems to be effective treatment for stage III endometriosis. A larger series with longer follow-up is necessary to clarify its role in the management of stage IV disease. (J Am Assoc Gynecol Laparosc 6(1):55-58, 1999)     

Synthesis of nm-sized barium titanate crystallites using a new LTDS method and their characterization

A new LTDS method was established to synthesize nm-sized barium titanate crystallites with particle sizes around 10 nm. This LTDS method was the following two features, i.e., (1) a heat of neutralization in a neutralization reaction between strong acid and base can be used as a driving force for a formation of barium titanate, and (2) barium titanate crystallites can be directly synthesized from Ti and Ba ions, not via intermediates. Therefore, using the LTDS method, it can be expected that there is no minimum limit in particle sizes, and also no contamination in barium titanate crystallites. At first, optimum conditions for a formation of barium titanate were screened at various reaction temperatures and Ba/Ti atomic ratios in the starting materials. As a result, the formation of barium titanate was found at higher reaction temperatures than 50°C and higher Ba/Ti atomic ratios than 5. Under a constant temperature, particle sizes decreased with increasing Ba/Ti atomic ratios while under a constant Ba/Ti atomic ratio, particle sizes were independent of reaction temperatures. Finally, barium titanate crystallites with particle sizes below 10 nm were first prepared. These particles were also characterized using various methods.     

Electron-beam doping-electron radiation effects in impurity overlayers and semiconductor substrates

3-9 MeV electrons were used to introduce impurity Ge atoms into Si wafers from Ge sheets, which are in contact with a Si surface at 20-60‡C in water bath. Concentration-dependent diffusivities of ∼10-18-10^-14 cm²sec^-1 for Ge in Si were measured. Activation energies of sputtering yield for Ge and of the diffusivity of Ge in Si are estimated to be ∼0.3 eV and ∼0.58 eV, respectively. In a case of hot (∼250‡C) irradiation in ∼1x10^-3 Torr vacuum, also the similar concentration profiles of impurity atoms in the substrates were observed.     

Integrated waveguide-photodiodes with large bandwidth and highexternal quantum efficiency

An integrated waveguide-photodiode with an external quantum efficiency as high as 56% (coupled to single-mode fiber) and large bandwidth (5.5-11.2 GHz) at 1.55-μm wavelength is described. This performance was achieved utilizing a vertical impedance matching design for improved guide-detector coupling     

Severe gastrointestinal hemorrhage due to Mycobacterium avium complex in a patient receiving immunosuppressive therapy

Intense immunosuppressive therapy is used frequently for treatment of systemic vasculitides, collagenoses, rapidly progressive glomerulonephritis, and after organ transplantation. Numerous serious treatment-related side effects include localized or disseminated opportunistic infections, and require careful monitoring of immunosuppressed patients. Gastrointestinal infections with Mycobacterium avium complex (MAC) or other nontuberculous mycobacteria have been previously identified in HIV seropositive patients only. We now report the first case of an HIV seronegative patient who received immunosuppressive therapy for rapidly progressive glomerulonephritis. The patient presented with severe lower gastrointestinal bleeding and was diagnosed to have ulcerative colitis due to infection with MAC. The patient recovered promptly after administration of antimycobacterial therapy. MAC infection should be included in the differential diagnosis of gastrointestinal bleeding in all immunodeficient patients. The significance of repeated colonoscopy to obtain multiple biopsy specimens with histological examination for foam cells and specific staining for acid-fast organisms is emphasized.     

Microstructure and electrochemical behavior of Ti-coatedZr55Al10Ni5Cu30 bulk metallic glass

In this study, pure Ti was coated on Zr₅₅Al₁₀Ni₅Cu₃₀ bulk metallic glass (BMG) using a physical vapour deposition (PVD) technique with magnetron sputtering. Microstructures of Ti coating, BMG substrate and interface were investigated by conventional and high-resolution transmission electron microscopy (TEM and HREM). The electrochemical behavior of Ti-coated Zr₅₅Al₁₀Ni₅Cu₃₀ BMG was studied by potentiodynamic polarization curves and electrochemical impedance spectroscopy (EIS) in Hanks' solution. Scanning electron microscopy (SEM) was used to characterize the surface morphology of the coating after electrochemical testing. HRTEM observation reveals that the sputtering Ti coating consists of α-Ti nano-scale particles with the size about 10 nm. The polarization curves revealed that the open-circuit potential shifted to a more positive potential and the passive current density was lower after Ti coating was applied in comparison with that of the monolithic Zr₅₅Al₁₀Ni₅Cu₃₀ BMG. Electrochemical impedance spectroscopy (EIS) measurements showed that the Bode plots of Ti-coated Zr₅₅Al₁₀Ni₅Cu₃₀ BMG presented one time constant for 1 h and 12 h immersion and two time constants after 24 h immersion. The good bonding condition between Ti coating and Zr₅₅Al₁₀Ni₅Cu₃₀ BMG substrate may be responsible for the high corrosion resistance of Ti-coated Zr₅₅Al₁₀Ni₅Cu₃₀ BMG.