Electrodiffusion Model Simulation of Ionic Channels: 1D Simulations

The drift-diffusion (Poisson-Nernst-Planck) model is applied to ionic channels in biological membranes plus surrounding solution baths. Simulations of the K channel in KCl solutions using the TRBDF2 method are presented which show significant boundary layers at the ends of the channel. The computed current-voltage curve for the K channel shows excellent agreement with experimental measurements.     

The Attentional Dynamics of Masked Detection.

A dichoptic masking procedure was used to test whether the mask-dependent cuing effects found in luminance detection by P. L. Smith (2000a) were due to integration masking or interruption masking. Attentional cuing enhanced detection sensitivity (d') when stimuli were backwardly masked with either dichoptic or monoptic masks, whereas no cuing effect was found with unmasked stimuli, implying the mask dependencies were due to interruption of stimulus processing in visual cortex by the mask. The effect is predicted by a gated diffusion process model in which masks interrupt stimulus processing and attention controls the flow of information to a sequential-sampling decision mechanism. The model correctly predicts different patterns of performance for detection and discrimination and cuing effects in simple reaction time. (PsycINFO Database Record (c) 2010 APA, all rights reserved)     

Influence of Powder Morphology and Chemical Composition on Metallic Foams produced by SlipReactionFoamSintering (SRFS)‐ Process

The SlipReactionFoamSintering (SRFS)‐ process is a metallurgical method to produce open‐cell metallic foams of iron based materials, steels and nickel based materials. In this process several chemical reactions take place. Through the most influential parameter, the morphology of the metallic powder, different properties of the foam can be adjusted, such as the viscosity of the slip, the cell structure and the mechanical properties. Several examples are presented in this paper. Moreover, the thermal conductivity of three foams is measured with the transient‐heat‐source‐technique.     

The Influence of Rapid Annealing Cycles on the Recrystallisation Behaviour of Cold Rolled Ultra Low Carbon and Low Carbon Steel

For ultra low carbon (ULC) and low carbon steel (LC), the influence of heating rate, annealing temperature, and holding time on the recrystallisation behaviour and the resulting grain size was investigated. For ULC smallest grain sizes of about 9 μm were obtained at the lowest heating rate whereas for LC significant smaller grain sizes of about 5 μm were determined at the highest heating rate. Furthermore, the evolution of the grain size distribution with varying heating rate, annealing temperature, and holding time was studied in dependence of the rolling and normal direction. The state of the as‐hot rolled microstructure as well as the precipitation state exert a strong influence on the development of the recrystallised microstructure along the different directions for both steel grades. The inherent prolonged microstructure due to the cold rolling process is still obvious just after recrystallisation. With ongoing annealing and grain growth, the aspect ratio approaches the equiaxed state. This change proceeds faster for the ULC steel grade. With increasing annealing temperature, the bimodal character of the grain size distribution disappears and the distribution becomes more homogeneous.     

Charging effect in electron-irradiated ice

To maintain the original distribution pattern of diffusible elements in biological samples, electron probe microanalysis is carried out with frozen hydrated bulk specimens and cryosections, analysed at temperatures below 130 K. Ice has a very low intrinsic conductivity at this working temperature and surface- and space-charging appears, when uncoated specimens are irradiated with non-penetrating electrons. Although coating with a grounded conductor abolishes the surface potential, the build-up of an internal space-charge field is possible, depending on the sample thickness and beam voltage used. Consequently, the geometry of the X-ray source volume and the spectral distribution of the emitted continuous and characteristic X-rays are affected. To simulate the situation for microanalysis of frozen hydrated specimens the charging process in electron irradiated ice is studied by recording simultaneous specimen currents from the top and bottom of ice layer preparations. The external currents yield information on the build-up of internal space-charge fields which result from the balance of charge injection, storage, and transport. Irradiation of uncoated bulk specimens with a finely focused beam results in the build-up of a space-charge field close to the surface, which causes a reduction of the depth of microprobe analysis. In coated bulk specimens the induced conductivity renders possible a current flow to the front electrode, thereby limiting the space-charge field. Sections with an effective rear electrode will not charge appreciably if the electron range is larger than about half the section thickness.     

Nondestructive and noncontact method for determining the spring constant of rectangular cantilevers

We present here an experimental setup and suggest an extension to the long existing added-mass method for the calibration of the spring constant of atomic force microscope cantilevers. Instead of measuring the resonance frequency shift that results from attaching particles of known masses to the end of cantilevers, we load them with water microdrops generated by a commercial inkjet dispenser. Such a device is capable of generating drops, and thus masses, of extremely reproducible size. This makes it an ideal tool for calibration tasks. Moreover, the major advantage of water microdrops is that they allow for a nearly contactless calibration: no mechanical micromanipulation of particles on cantilevers is required, neither for their deposition nor for removal. After some seconds the water drop is completely evaporated, and no residues are left on the cantilever surface or tip. We present two variants: we vary the size of the drops and deposit them at the free end of the cantilever, or we keep the size of the drops constant and vary their position along the cantilever. For the second variant, we implemented also numerical simulations. Spring constants measured by this method are comparable to results obtained by the thermal noise method, as we demonstrate for six different cantilevers.     

Electron energy loss spectroscopy for analysis of inhaled ultrafine particles in rat lungs

Epidemiologic studies have associated cardiovascular morbidity and mortality with ambient particulate air pollution. Particles smaller than 100 nm in diameter (ultrafine particles) are present in the urban atmosphere in very high numbers yet at very low mass concentration. Organs beyond the lungs are considered as targets for inhaled ultrafine particles, whereby the route of particle translocation deeper into the lungs is unclear. Five rats were exposed to aerosols of ultrafine titanium dioxide particles of a count median diameter of 22 nm (geometric standard deviation, GSD 1.7) for 1 hour. The lungs were fixed by intravascular perfusion of fixatives immediately thereafter. TiO(2) particles in probes of the aerosol as well as in systematic tissue samples were analyzed with a LEO 912 transmission electron microscope equipped with an energy filter for elemental microanalysis. The characteristic energy loss spectra were obtained by fast spectrum acquisition. Aerosol particles as well as those in the lung tissue were unambiguously identified by electron energy loss spectroscopy. Particles were mainly found as small clusters with a rounded shape. Seven percent of the particles in the lung tissue had a needle-like shape. The size distribution of the cluster profiles in the tissue had a count median diameter of 29 nm (GSD 1.7), which indicates no severe clustering or reshaping of the originally inhaled particles. Electron energy loss spectroscopy and related analytical methods were found to be suitable to identify and localize ultrafine titanium dioxide particles within chemically fixed and resin-embedded lung tissue.     

The smile of Asia: Acculturation effects on symptom reporting.

Compared Canadian Asian with Caucasian university students (N?=?292) on symptom reporting and response styles and evaluated acculturation effects on symptom reporting and response styles among the Asian Ss. Asian Ss were subdivided into low, medium, or high levels of acculturation. Measures comprised psychological and somatic symptom report scales, behavioral affect expression, and scales tapping self-deception and impression management as response styles. Asian Ss reported more cognitive anxiety than Caucasian Ss, but did not differ in frequency of somatic symptom reports or in preferred response styles, although a linear acculturation effect was noted on behavioral affect expression. (French abstract) (PsycINFO Database Record (c) 2010 APA, all rights reserved)     

Synthesis,Structure, Spectral-Luminescent Properties,and Biological Activity of Chlorine-Substituted N-[2-(Phenyliminomethyl)phenyl]-4-methylbenzenesulfamide and Their Zinc(II) Complexes

New azomethine compounds of 2-(N-tosylamino)benzaldehyde or 5-chloro-2-(N-tosylamino)benzaldehyde and the corresponding chlorine-substituted anilines, zinc(II) complexes based on them have been synthesized. The structures of azomethines and their complexes were determined by elemental analysis, IR, ¹H NMR, X-ray spectroscopy, and X-ray diffraction. It is found that all ZnL₂ complexes have a tetrahedral structure according to XAFS and X-ray diffraction data. The photoluminescent properties of azomethines and zinc complexes in methylene chloride solution and in solid form have been studied. It is shown that the photoluminescence quantum yields of solid samples of the complexes are an order of magnitude higher compared to the solutions and range from 11.34% to 48.3%. The thermal properties of Zn(II) complexes were determined by thermal gravimetric analysis (TGA) and differential scanning calorimetry. The TGA curves of all the compounds suggest their high thermal stability up to temperatures higher than 290 °C. The electrochemical properties of all complexes were investigated by the cyclic voltammetry method. The multilayered devices ITO/PEDOT:PSS/NPD/Zn complex/ TPBI/LiF/Al with wide electroluminescence (EL) color range spanning the range from bluish-green (494 nm) to green (533 nm) and the high values of brightness, current and power efficiency were fabricated. The biological activity of azomethines and zinc complexes has been studied. In the case of complexes, the protistocidal activity of the zinc complex with azomethine of 5-chloro-2-(N-tosylamino)benzaldehyde with 4-chloroaniline was two times higher than the activity of the reference drug toltrazuril.