Long multifilament Bi-2223 Ag-sheathed superconducting tapes and solenoids

Multifilament Ag-sheathed BiPbSrCaCuO (2223) superconducting tapes containing 49 filaments were fabricated by the powder-in-tube route and the roll-anneal process. The transport critical current densityJ _c was 1.3×10⁴ A cm^–2 at 77 K and 7×10⁴ A cm^–2 at 4.2 K in self-field. A 12-m-long tape was used to construct superconducting solenoids (50, 28, and 14 mm internal diameters) generating dc fields 380–1070 G at 4.2 K. Measurements of the variation ofJ _c with field (0–1.6 T) and bend strain (0–5%) are used to explain the performance of the solenoids. The critical bend strain of tapes was about 1.5%.     

Quantitative analysis of ephedrines in urine by HPLC

Simultaneous determination of six ephedrines in urine sample has been achieved by high performance liquid chromatography on a Lichrospher RP-18 column, using methylamphetamine as internal standard. The 6 ephedrines are well separated in 25 minutes with resolution better than 1.8. This method has high recovery, selectivity and reproducibility, and the linearity is satisfactory from 1.5 micrograms/ml to 25 micrograms/ml with correlation coefficients better than 0.999.     

Nonlinear protein binding and enzyme heterogeneity: effects on hepatic drug removal

The kinetics of substrate removal by the liver and the resulting nonlinear changes in unbound fraction along the flow path at varying input drug concentrations were examined by a model simulation study. Specifically, we varied the binding association constant, KA, and the Michaelis-Menten constants (Km and Vmax) to examine the steady state drug removal (expressed as hepatic extraction ratio E) and changes in drug binding for (i) unienzyme systems and (ii) simple, parallel metabolic pathways; zonal metabolic heterogeneity was also added as a variable. At low KA, E declined with increasing input drug concentration, due primarily to saturation of enzymes; only small differences in binding were present across the liver. At high KA, a parabolic profile for E with concentration was observed; changes in unbound fraction between the inlet and the outlet of the liver followed in parallel fashion. Protein binding was the rate-determining step at low input drug concentrations, whereas enzyme saturation was the rate-controlling factor at high input drug concentration. Heterogeneous enzymic distribution modulated changes in unbound fraction within the liver and at the outlet. Despite marked changes in unbound fraction occurring within the liver for different enzymic distributions, the overall transhepatic differences were relatively small. We then investigated the logarithmic average unbound concentration and the length averaged concentration as estimates of substrate concentration in liver in the presence of nonlinear drug binding. Fitting of simulated data, with and without assigned random error (10%), to the Michaelis-Menten equation was performed; fitting was repeated for simulated data obtained with presence of a specific inhibitor of the high-affinity, anteriorly distributed pathway. Results were similar for both concentration terms: accurate estimates were obtained for anterior, high affinity pathways; an overestimation of parameters was observed for the lower affinity posteriorly distributed pathways. Improved estimations were found for posteriorly distributed pathways upon inhibition with specific inhibitors; with added random error, however, the improvement was much decreased. We applied the method for fitting of several sets of metabolic data obtained from rat liver perfusion studies performed with salicylamide (SAM) (i) without and (ii) with the presence of 2,6-dichloro-4-nitrophenol (DCNP), a SAM sulfation inhibitor. The fitted results showed that SAM sulfation was a high-affinity high-capacity pathway; SAM glucuronidation was of lower affinity but comparable capacity as the sulfation pathway, whereas SAM hydroxylation was of lower affinity and lower capacity.     

GaN and AlGaN high-voltage rectifiers grown by metal-organic chemical-vapor deposition

In this paper, we report the study of the electrical characteristics of GaN and AlGaN vertical p-i-n junctions and Schottky rectifiers grown on both sapphire and SiC substrates by metal-organic chemical-vapor deposition. For GaN p-i-n rectifiers grown on SiC with a relatively thin “i” region of 2 μm, a breakdown voltage over 400 V, and forward voltage as low as 4.5 V at 100 A/cm² are exhibited for a 60-μm-diameter device. A GaN Schottky diode with a 2-μm-thick undoped layer exhibits a blocking voltage in excess of ∼230 V at a reverse-leakage current density below 1 mA/cm², and a forward-voltage drop of 3.5 V at a current density of 100 A/cm². It has been found that with the same device structure and process approach, the leakage current of a device grown on a SiC substrate is much lower than a device grown on a sapphire substrate. The use of Mg ion implantation for p-guard rings as planar-edge terminations in mesageometry GaN Schottky rectifiers has also been studied.     

Densification involved in the UV-based photosensitivity of silicaglasses and optical fibers

A comprehensive survey of photosensitivity in silica glasses and optical fiber is reviewed. Recent work on understanding the mechanisms contributing to germanium or aluminum doped fiber photosensitivity is discussed within the framework of photoelastic densification models     

The lattice dynamics of the Fe(tpa) (NCS)2 complex : light-induced excited spin state trapping effect

A light-induced excited spin state trapping (LIESST) experiment for a thermal gradual spin crossover complex, Fetris (2-pyridylmethyl) amine(NCS)2 or Fe(tpa) (NCS)2, was attempted for the first time. The high spin (HS) state after light inducement stayed metastable over a period of days without relaxation at 10 K. Intersystem relaxation from a high to a low spin (LS) complex occurred at 50 K after bleaching at 10 K. Investigation of the Mossbauer spectra of the LIESST and relaxation experiment indicated that the Debye–Waller factor was a correlation parameter of the HS fraction and that the co-operative effect played a role in the relaxation process for such a solid compound. This revised version was published online in November 2006 with corrections to the Cover Date.     

STRESS INTENSITY FACTORS AND WEIGHT FUNCTIONS FOR SEMI-ELLIPTICAL SURFACE CRACKS IN FINITE-THICKNESS PLATES UNDER TWO-DIMENSIONAL STRESS DISTRIBUTION

Abstract— A Fourier series approach is proposed to calculate stress intensity factors using weight functions for semi-elliptical surface cracks in flat plates subjected to two-dimensional stress distributions. The weight functions were derived from reference stress intensity factors obtained by three-dimensional finite element analyses. The close form weight functions derived are suitable for the calculation of stress intensity factors for semi-elliptical surface cracks in flat plates under two-dimensional stress distributions with the crack aspect ratio in the range of 0.1 ≤ a/c ≤ 1 and relative depth in the range of 0 ≤ a/t ≤ 0.8. Solutions were verified using several two-dimensional non-linear stress distributions; the maximum difference being 6%.