户式中央空调发展方向的探讨

本文描述了我国户式中央空调的发展现状，分析了三种户式中央空调各自的特点，提出了把风管式机组作为我国户式中央空调的发展方向。     

轴齿轮断齿失效分析

通过对轴齿轮断口形貌、硬度测试及金相组织等试验进行分析表明，齿根处没有进行硬化处理造成齿根处抗疲劳性能不足是导致轴齿轮疲劳断裂的主要原因，另外齿根过渡处倒角过小，且存在纵向刀痕引起了较大应力集中也是导致轴齿轮疲劳断裂的原因。     

Influence of Manufacturing and Ripening Conditions on the Survival of Enterobacteriaceae in Manchego Cheese

The effects of cooking temperature, time and temperature of brine-salting, and temperature of ripening on the behavior of Enterobacteriaceae in Manchego cheese were studied. Fifty lots of cheese from raw ewe's milk manufactured and ripened under different conditions were investigated throughout a 60-day ripening period. Differences in pH values due to temperature-dependent whey retention accounted for the effect of cooking temperature on coliform and fecal coliform counts. Temperature of brine-salting had no effect on Enterobacteriaceae counts, but a significant effect of salting time on Enterobacteriaceae and fecal coliform counts was detected. Ripening temperature was the manufacturing variable with greatest influence (P<.01) on Enterobacteriaceae and coliform counts during the whole curing period.     

全双极WTA模型的改进及其实现

提出了一种相似度的新定义，使双极ＷＡＴ模型的实现更加简洁明了。增加一个阈值使系统能判别非存储模式或因其信息量过低而无法鉴定的输入模式，阈值的大小与要求的容错能力有关。双极相似度及阈值通过光学方法实现。阈值的光学实现使系统仍具有照明不变性。通过电路实现取及ＷＴＡ网络的迭代运算。     

IPA模型对Hopfield模型神经网络的改进

考虑Ｈｏｐｆｉｅｌｄ模型中假态之间的布尔逻辑关系，提出利用ＩＰＡ模型对神经网络中的假态进行抑制，并和原网络的性能进行了比较，结果表明：改进后的网络性能比Ｈｏｐｆｉｅｌｄ模型和ＩＰＡ模型均有较大提高。     

ANALYSIS AND PROCESSING OF LMF－COSTAS STEPPED FREQUENCY RADAR SIGNAL

Linear Modulated Frequency (LMF) Costas Stepped Frequency Radar (SFR) signal is introduced. Its ambiguity function is derived and analyzed in detail and its feasibility is validated in theory. The scheme of the proposed signal processing is also presented. The results of theoretic analysis and simulation show that, by using the proposed signal and increasing the bandwidth of the total stepped frequency, the ambiguity sidelobe is well suppressed and the range-velocity coupling in the stepped frequency radar is also greatly weakened.     

模内贴箔装饰的自动化生产

详细介绍了一种新型装饰工艺－模内贴箔工艺的自动化过程及生产要求。     

Comments on “Multiphase systolic algorithms for spectraldecomposition” [and reply]

Comments that the paper by Liu and Yao (see ibid., vol.40, no.1, p.190, 1992) presented an efficient algorithm for spectral decomposition, but the parallel algorithm and architecture for the Hessenberg reduction has a problem. The matrix obtained from the unitary similarity transformation is not necessarily a Hessenberg matrix. The authors reply that the Hessenberg reduction described is not in the Hessenberg form. Only the first column is in its proper form. There are many ways to overcome such a problem. One simple way is to use the multiphase rectangular systolic array     

Green and self-lubricating polyoxymethylene composites filled with low-density polyethylene and rice husk flour

Polyoxymethylene (POM) composites filled with low-density polyethylene (LDPE) and rice husk flour (RHF) were prepared by injection molding. The POM/5 wt % LDPE/7.5 wt % RHF composite exhibited the lowest wear rate, whereas the coefficient of friction remained low, and the POM/5 wt % LDPE/5 wt % RHF composite had the best mechanical properties. X-ray diffraction analysis was carried out, and the worn surfaces were examined with scanning electron microscopy. The results showed that the addition of the filler reduced the crystallinity degree of the POM composites. The main wear mechanism for unfilled POM was adhesion, whereas for the POM composites, wear seemed to occur mainly by fatigue and abrasion. It was experimentally confirmed that the POM composite filled with LDPE and RHF, which is well-performing, low-cost, and environmentally friendly, could be a potential material for tribological applications. © 2008 Wiley Periodicals, Inc. J Appl Polym Sci, 2008