Characteristics of hydrogen-fueled gas turbine cycle with intercooler,hydrogen turbine and hydrogen heater

The performances of a hydrogen-fueled gas turbine cycle equipped with an intercooler, regenerator, hydrogen turbine and recuperative hydrogen heater are analyzed. The intercooler is very effective to prevent the condensation and freezing of water vapor in cooling the suction air. The operation of hydrogen turbine in low-temperature range can also be prevented by adopting hydrogen heater. Thermodynamic analysis has revealed that the thermal efficiency and the specific output are considerably improved compared to those of the simple gas turbine cycle.     

Multichip Differential Phase-Shift-Keyed Transmission Over (Non)Linear Optical Channels

The recently introduced multichip differential phase-shift keying (MC-DPSK) optical transmission format, entailing the modulation of relative phases over a moving transmission window of successive chip intervals, is analytically and numerically analyzed. The maximum-likelihood optimal MC-DPSK receiver is derived and synthesized using integrated-optic Mach-Zehnder delay interferometers, whose electrical outputs are interpreted as generalized Stokes' parameters. The MC-DPSK performance over a nonlinear fiber channel, limited by the combination of amplified spontaneous emission noise and self-phase modulation, is further derived and simulated, demonstrating that the lowest complexity three-chip binary-phase MC-DPSK receiver provides an ~1-dB Q-factor advantage over conventional DPSK.     

Evaluation of constructed wetlands by wastewater purification ability and greenhouse gas emissions.

Domestic wastewater is a significant source of nitrogen and phosphorus, which cause lake eutrophication. Among the wastewater treatment technologies, constructed wetlands are a promising low-cost means of treating point and diffuse sources of domestic wastewater in rural areas. However, the sustainable operation of constructed wetland treatment systems depends upon a high rate conversion of organic and nitrogenous loading into their metabolic gaseous end products, such as N2O and CH4. In this study, we examined and compared the performance of three typical types of constructed wetlands: Free Water Surface (FWS), Subsurface Flow (SF) and Vertical Flow (VF) wetlands. Pollutant removal efficiency and N2O and CH4 emissions were assessed as measures of performance. We found that the pollutant removal rates and gas emissions measured in the wetlands exhibited clear seasonal changes, and these changes were closely associated with plant growth. VF wetlands exhibited stable removal of organic pollutants and NH3-N throughout the experiment regardless of season and showed great potential for CH4 adsorption. SF wetlands showed preferable T-N removal performance and a lower risk of greenhouse gas emissions than FWS wetlands. Soil oxidation reduction potential (ORP) analysis revealed that water flow structure and plant growth influenced constructed wetland oxygen transfer, and these variations resulted in seasonal changes of ORP distribution inside wetlands that were accompanied by fluctuations in pollutant removal and greenhouse gas emissions.     

A typical meteorological day (TMD) approach for predicting the long-term performance of solar energy systems

A method for predicting the long-term performance of solar energy systems, based on the analysis of system performance for one particular day—the typical meteorological day (TMD)—is presented. The TMD is constructed from the cumulative time distribution of insolation values on the collector aperture. The TMD method requires little calculational effort and a small data base relative to standard yearly computer simulations. Good agreement is found between the predictions of the new method and the corresponding results of the -f-chart method. The TMD method is of particular value for cases that may often be treated inaccurately by simple calculational methods: (1) high threshold problems; (2) systems with short response times (e.g., due to small storage); and (3) systems in which collectors other than flat plates are used (the method is applicable to all solar collector types).     

Orientation in uniaxially stretched plasticized atactic polystyrene

Summary Fourier transform infrared spectroscopy and birefringence measurements have been used to study the changes in molecular orientation which occur on drawing of plasticized as compared to pure polystyrene (PS) at a temperature T=Tg+Cte. No influence of plasticizers on orientation can be detected whatever the interactions between small molecules and PS chains are. Comparison with previous results obtained on PS-poly(vinylmethyl ether) compatible blends confirms the importance of the macromolecular nature of the second component to enhance the friction coefficient leading to higher level of chain orientation.     

Integrated optical devices of InGaAsP/InP heterojunction phototransistor and inner stripe light-emitting diode

New integrated optical devices combining an InGaAsP/InP HPT and an inner-stripe LED are proposed and their fabrication processes are described. The device functions of light amplification, optical bistability, and optical switching are demonstrated in the 1-μm wavelength region.     

Effect of puffer volume and operating force on dielectric recovery performance in thermal puffer-type gas circuit breaker

In order to investigate the influence of puffer volume V/sub P/ and operating force to dielectric performance of GCB at current interruption, we calculated the prospective dielectric withstand voltage V/sub W/ between arcing contacts. The withstand voltage was calculated by the electric field strength appeared on arcing contacts and the allowable electric field strength E/sub W//sup */ of hot gas due to thermal puffer action. We could clarify that large initial puffer volume V/sub P/ can increase withstand voltage V/sub W/ at current breaking point and also that an optimum point exists in operating force F. For example, it was found that in case of the operating force of 1000 kgf, the puffer volume V/sub P/ of 1.2 liter would be best choice in the interrupting condition of i=50 kA and arcing time of 1.35 cycle.     

POLARIZATION BEHAVIOR OF PACKED-BED ELECTRODES: A COMPARATIVE STUDY OF EXPERIMENTAL AND MODELING RESULTS

The current distribution and overall polarization behavior of electrodeposition at a flow-through (packed bed or fluidized bed) electrode are modeled by means of a one-dimensional model involving a primary reacting species and a simultaneous side reaction. The model equations are solved by orthogonal collocation; the time and storage requirements compare favorably to those of finite-difference methods. Experimental data obtained using a packed-bed electrode are compared with the model predictions and various methods of fitting the data are compared.