英台地区天然水驱油藏的开发特点及稳产技术

掌握边底水运动规律，控制并利用活跃的边底水能量，是成功开发天然水驱油藏的关键。英台地区的英台、四方坨子和一棵树等三个油田均为天然水驱油藏，天然能量充足。油藏投入开发后初期含水较高，含水上升极快，造成产油量大幅度递减。针对其开发特点，适时采用大泵、电潜泵提液强采，通过大量补孔层间接替以及加密调整和扩边等稳产技术措施，确保了油藏以3％-5％的采油速度长期稳产，水驱采收率高达50％以上。     

Prediction of compressive strength and optimization of mixture proportioning in ternary cementitious systems

This paper discussed the application of the method of the simplex-lattice design for predicting the properties of cement-based composites. On the basis of the compressive strength, its use was demonstrated on ternary paste systems composed of cement, silica fume and fly ash with constant water to binder ratio and a mass fraction of mineral admixtures not exceeding 30%. The regression model between compressive strength of paste and binder proportion was built up. The F-test method was utilized for validation of the regression model. The nonlinear programming system with upper and lower bound was solved. This allowed assessment of optimum mixture proportions and corresponding maximum compressive strength. It was shown that: (1) the 3rd-order regression model constructed by using the simplex-lattice design method could accurately predict the compressive strength in ternary paste system made of cement, silica fume and fly ash (the total mass fraction of all mineral admixtures was up to 30%); (2) to solve the nonlinear programming with the constraints of upper and lower bound played an important role in getting the optimum compressive strength and its corresponding mixture proportion at different ages; (3) the combination of the simplex-lattice design method and the optimization theory could be valuable tool for optimization of cement-based composites' properties.     

6to4与ISATAP技术相结合的IPv6网络实现

在IPv4向IPv6过渡期间,多种过渡技术可以互相支持、互相组合使用,以达到互利互助。简要介绍了其中2种隧道技术:6to4技术和ISATAP技术,提出了1种基于两者结合的新型实验网络的实现方案。具体讨论了在Linux下如何组建这种新型实验网络平台,详细阐明了如何配置IPv6主机以及双栈路由器,为IPv4过渡到IPv6提供1个可行的方案。     

昆2井优快钻井及油气层保护技术

昆2井是一口位于柴北缘西段的昆特依凹陷潜伏Ⅰ号圈闭上的风险探井,设计井深为5950m。针对柴北缘深探井存在的主要技术难题,制定了昆2井的技术对策。通过对钻井设备的优选、井身结构的优化、钻头及钻具组合的优选、钻井参数及钻井液性能的优化、油气层保护技术的研究与应用,形成了一套适合于柴北缘的优快钻井技术,使昆2井的完钻井深达到5950m。与邻区的深探井平均水平相比,在井深增加888m、大尺寸井眼段更长的前提下,昆2井的钻井、完井周期分别缩短了98.75d、124.2d,钻机月速度增加了317m/台,平均机械钻速增加了0.82m/h。根据“理想充填新理论”,确定了保护油气层的最优复配暂堵方案,利用该方案所配制的钻井液其渗透率恢复值达到了87.5%以上,流变性能良好,滤失量低,对改善泥饼质量、增强井壁稳定性有明显的效果。     

浅谈现阶段如何推行HSE

根据胜利油田建立实施HSE管理体系工作的现状,提出现阶段推行HSE管理体系要做好五方面的工作。在日常管理工作中,要做到高标准、高质量、严要求、严考核。     

高输入功率因数的三相无源AC-DC变换器

对于采用三相不控整流桥作为前级的变换器，自然条件下其输入电流波形系数不高，使得输入功率因数委低，降低了电源的利用率。为此需要采用功率因数提高技术，其中无源PFC是一类重要的功率因数校正技术，在某些场合非常具有应用价值。本文介绍了几种三相无源AC-DC变换器的高功率因数方案，如采用LC滤波器、移相电抗器，谐振电抗器，移相变压器，相间变压器，相间电抗器等，在进行简单的工作原理描述后，给出了部分方案的MATLAB/SIMULINK仿真结果。     

Optimum thermoeconomic and thermodynamic performance characteristics of an irreversible three-heat-source heat pump

The coefficient of performance and specific heating load of an irreversible three-heat-source heat pump are given by using a general cycle model affected by the finite-rate heat transfer, heat leak and internal irreversibility of the cyclic working fluid. The heat pumping load divided by the total cost per unit time is taken as a new objective function and used to investigate the performance of the heat pump. The thermoeconomic and thermodynamic performance characteristics of the heat pump are discussed in detail. Some important performance parameters such as the thermoeconomic objective function and coefficient of performance are optimized. The optimally operating regions of the heat pump and the bounds of several performance parameters are determined. Finally, it is pointed out that the Carnot heat pump may be taken as a special case of a three-heat-source heat pump and consequently its optimal performance can be directly derived from the results obtained here.     

单井注水吞吐在塔河油田的应用

在塔河油田开发生产过程中，个别油井在修井作业中出现先漏后喷的现象。在修井完成后，产量较前期有大幅增加。针对这类油井进行单井注水吞吐采油试验，研究发现钻遇定容封闭性油藏的油井适合单井注水吞吐开采。一方面利用油水重力分异，抬升油水界面，增加采出量；另一方面注水补充地层能量，恢复地层压力。该方法在塔河油田实际应用中，取得了较好的效果和较高的经济效益，也为提高定容封闭性油藏油井的采收率提供了一个较好的方法。     

Study of miscibility enhancement in poly(styrene‐co‐4‐vinylphenol)/poly(ethylene oxide) blends by the spin labelling method

The electron spin resonance (ESR) spectra of end‐group spin labelled poly(ethylene oxide) (SLPEO) using 2,2,6,6‐tetramethyl‐piperdine‐1‐oxyl nitroxide and its blends with poly(styrene‐co‐4‐vinylphenol) (STVPhs) of different hydroxyl contents were recorded over a wide temperature range. For a blend of SLPEO and pure polystyrene (PS), the ESR spectrum was composed of a single motion component, indicating that PS was immiscible with PEO. For blends composed of SLPEO and different‐hydroxyl‐content STVPhs, two spectral components with different motion rates were observed over a certain temperature range. The difference between the motion rates should be attributed to micro‐heterogeneity in the blends, with the faster rate corresponding to a nitroxide radical motion trapped in the PEO‐rich domain and the slower rate corresponding to a nitroxide radical motion trapped in the STVPh‐rich domain. Variations in the values of a number of the ESR parameters (T_a, T_d and T_50G) and the apparent activation energy (E_a) with hydroxyl content in the blends indicated that the miscibility of the blends increased with increasing hydrogen‐bonding density due to specific interactions between the hydroxyl groups in STVPh and the ether oxygens in PEO. Copyright © 2004 Society of Chemical Industry     

《石油沥青纸胎油毡》国家标准的修订

《石油沥青纸胎油毡》国家标准进行了第三次修订。本文介绍了修订的理由、修订的内容与依据，并与国内外同类产品标准进行了比较。