Ionizing-Radiation Response of the GaAs/(Al, Ga)As PHEMT: A Comparison of Gamma- and X-ray Results

An experiment is reported on the effect of ⁶⁰Co gamma rays or 45-keV x-ray photons on the GaAs/(Al, Ga)As PHEMT. It is shown that x-ray treatment can improve the dc performance of the device in some cases. This finding is attributed in part to the annealing or modification of DX centers.     

Effect of proton radiation on the kinetics of phosphorescence decay in the ceramic material ZnS-Cu

The results of studying the dose dependences of the decay kinetics of phosphorescence excited by X-ray radiation in luminescent ZnS-Cu ceramic material before and after irradiation with 50-MeV protons are considered. An anomalous variation in the exponent of the hyperbolic phosphorescence curves was observed experimentally as the accumulated light sum increased. It is found from an analysis of the data obtained that two processes are involved in the decay: one of these is monomolecular and corresponds to the first-order kinetics; the other is bimolecular and corresponds to the second-order kinetics. Transitions of charge carriers delocalized from traps occur at the nonradiative-recombination centers induced by proton radiation. Recombination of these charge carriers at the emission centers in the course of decay is described by the second-order kinetics.     

Electromagnetic coupling effects on the cavity measurement of antenna efficiency

Electromagnetic coupling effects on the antenna in a conducting cavity are studied theoretically and experimentally. It is observed in experiments that at the resonant frequencies of the cavity, the input resistance of the antenna attains values two or three orders of magnitude higher than that at frequencies away from resonance. It is shown via theoretical analysis that the input resistance of the antenna measured at the resonant frequencies of the cavity is not merely the loss resistance desired in computing the antenna efficiency, but is actually the sum of the loss resistance of the antenna and the coupling resistance between the antenna and cavity. This coupling effect is demonstrated quantitatively by numerical computations for dipole and monopole antennas. The computational results for the input resistance are in agreement with the measured data. A method is proposed to avoid the cavity-antenna antiresonance in the measurement.     

Exploiting the high-frequency performance of low-voltage low-power SC filters

This paper investigates the design of low-voltage low-power switched-capacitor (SC) filters for high-frequency applications by using the clock-booster approach. In particular, our proposed SC filter architecture uses single-ended double-sampling integrator cells based on low-voltage operational transconductance amplifiers which take advantage of dynamic biasing and the clock-booster technique to drive the switch transistors. To validate its high-frequency capability, two low-pass elliptic SC filters respectively with a corner frequency of 6 and 8-MHz, were designed in a 0.35-/spl mu/m CMOS process. Both are suitable for telecom applications and can operate with a power supply as low as 1.5 V, while dissipating 11 mW. Measurements showed that for an output amplitude of 1 V/sub pp/, their total harmonic distortions were maintained well below -40 dB in their bandwidths. Comparisons with other SC filter implementations in the literature, which highlight the quality of our implementation are also provided.     

The impact of publicly funded basic research: an integrative extension of Martin and Salter

This paper provides an integrative literature review of the research on the impact of the public funding of basic research, extending previous work done at the Science Policy Research Unit (SPRU), University of Sussex, East Sussex, UK. "Impact" is measured in terms of publications, patents, new drugs, employment, and new start-up companies. The primary focus of this paper is on empirical studies of the impact of biomedical research. However, a few key theoretical papers and empirical papers with a broader industrial focus are also reviewed to provide a more complete perspective. Conclusions, including an alternative view that basic research need not be public supported, and future research opportunities in this area are also discussed.     

Vibration thresholds for fretting corrosion in electrical connectors

Single frequency vibration tests were used to induce fretting corrosion in tin alloy plated contacts. The samples used in this study were connectors consisting of 25 pairs of mated pin and socket contacts. Experimental results for a variety of vibration levels, frequencies, and wiring tie-off lengths are presented. The experiments consisted of running a series of vibration tests at each frequency where the excitation level was stepped through a range of g-levels. During each test run contact resistance was monitored as a performance characteristic. The results exhibit threshold behavior at each frequency for the onset of fretting degradation. Typically a plateau region was observed where similar g-levels produced similar fretting rates. It was also found that outside the plateau region the g-levels varied according to the dynamic behavior of the mechanical system. In addition, a transfer matrix model was used to analyze these results. An empirical fit of the data correlated well with the model when damping was used. This analysis revealed the importance of the bending moment induced at the contact interface as a result of excitation levels and tie-off configurations. Consequently, it is concluded that dynamic response of the mechanical system under various g-levels and tie off configurations can greatly impact the performance of a connector system subjected to vibration stresses.     

Tensile fracture and failure behavior of technical flax fibers

The apparent tensile strength of technical flax fibers was determined in single‐fiber tests at various clamping lengths (20, 40, and 80 mm) and the outcome was compared with literature data. It was demonstrated that the strength of flax at each clamping length obeyed the two‐parameter Weibull model. The failure mode and sequence were studied in situ (i.e., during loading) by SEM and acoustic emission (AE). The failure sequence (axial splitting of the technical fiber along its elementary constituents, radial cracking of the elementary fibers, multiple fracture of the elementary fibers) concluded reflected the hierarchical build‐up of the flax bast fibers. To the above failure events AE amplitude ranges were assigned. © 2003 Wiley Periodicals, Inc. J Appl Polym Sci 90: 3638–3645, 2003     

Examining a curvilinear relationship between communication frequency and team performance in cross-functional project teams

The performance of a cross-functional team depends on the skillful and innovative combination of information and expertise from all team members. Communication is the medium through which team members share the information required for successful amalgamation. In this work, we postulate that both high and low levels of team communication can impede team performance, thus leading to a curvilinear relationship between team performance and team communication. To test this hypothesis, the relationships between face-to-face, e-mail, and telephone communication and team performance were examined for 60 cross-functional project teams. E-mail and face-to-face communication were curvilinearly associated with performance, but telephone communication was not. Further analysis of the communication frequency between colocations showed that e-mail is the only medium for which usage increased with distance.     

中国3G运营商的目标市场与业务模式初探

中国3G业务的市场需求有两个方面：一是迅猛增长、规模庞大的用户群对移动语音业务的需求；二是较高收入用户群对移动数据业务的需求。3G运营商的目标市场包括大众用户对移动语音的需求、大众用户对移动数据业务的需求、企业用户对移动数据业务的需求以及批发型用户的需求等。本结合国内外移动运营商的数据业务开展状况，初步探讨了中国3G运营商的移动数据业务模式和3G业务的收入模式。     

1.6 Tbit/s (40/spl times/40 Gbit/s) DPSK transmission over 3/spl times/100 km of TeraLight fibre with direct detection

By transmitting 40 channels over 300 km of TeraLight fibre, it is shown that optical differential phase shift keying can be used in 100 GHz-spaced 40 Gbit/s systems, with direct detection and a simple receiving filter. Chromatic dispersion tolerance around 300 ps/nm is also measured, compared to 70 ps/nm for NRZ.