Hydrostatic Pressure Influences HIF-2 Alpha Expression in Chondrocytes

Hypoxia-inducible factor (HIF)-2α is considered to play a major role in the progression of osteoarthritis. Recently, it was reported that pressure amplitude influences HIF-2α expression in murine endothelial cells. We examined whether hydrostatic pressure is involved in expression of HIF-2α in articular chondrocytes. Chondrocytes were cultured and stimulated by inflammation or hydrostatic pressure of 0, 5, 10, or 50 MPa. After stimulation, heat shock protein (HSP) 70, HIF-2α, nuclear factor kappa B (NF-κB), matrix metalloproteinase (MMP)-13, MMP-3, and vascular endothelial growth factor (VEGF) gene expression were evaluated. The levels of all gene expression were increased by inflammatory stress. When chondrocytes were exposed to a hydrostatic pressure of 5 MPa, HIF-2α, MMP-13, and MMP-3 gene expression increased significantly although those of HSP70 and NF-κB were not significantly different from the control group. In contrast, HIF-2α gene expression did not increase under a hydrostatic pressure of 50 MPa although HSP70 and NF-κB expression increased significantly compared to control. We considered that hydrostatic pressure of 5 MPa could regulate HIF-2α independent of NF-κB, because the level of HIF-2α gene expression increased significantly without upregulation of NF-κB expression at 5 MPa. Hydrostatic pressure may influence cartilage degeneration, inducing MMP-13 and MMP-3 expression through HIF-2α.     

Efficient Assembly of Bridged β‐Ga2O3 Nanowires for Solar‐Blind Photodetection

An increasing number of applications using ultraviolet radiation have renewed interest in ultraviolet photodetector research. Particularly, solar‐blind photodetectors sensitive to only deep UV (<280 nm), have attracted growing attention because of their wide applicability. Among recent advances in UV detection, nanowire (NW)‐based photodetectors seem promising, however, none of the reported devices possesses the required attributes for practical solar‐blind photodetection, namely, an efficient fabrication process, a high solar light rejection ratio, a low photocurrent noise, and a fast response. Herein, the assembly of β‐Ga₂O₃ NWs into high‐performance solar‐blind photodetectors by use of an efficient bridging method is reported. The device is made in a single‐step chemical vapor deposition process and has a high 250‐to‐280‐nm rejection ratio (～2 × 10³), low photocurrent fluctuation (<3%), and a fast decay time (<<20 ms). Further, variations in the synthesis parameters of the NWs induce drastic changes in the photoresponse properties, which suggest a possibility for tuning the performance of the photodetectors. The efficient fabrication method and high performance of the bridged β‐Ga₂O₃ NW photodetectors make them highly suitable for solar‐blind photodetection.     

Characterization of plasma membrane H+-ATPase from salt-tolerant yeast Candida versatilis

Plasma membrane was isolated from the salt-tolerant yeast Candida versatilis and the ATPase in plasma membrane was characterized. The ATPase was a typical H⁺-ATPase with similar properties to the Saccharomyces cerevisiae and Zygosaccharomyces rouxii enzymes. It was reacted with antibody (IgG) raised against S. cerevisiae plasma membrane H⁺-ATPase. The ATPase activity was not changed by adding NaCl and KCl to the assay solutions, but was increased by NH, especially by ammonium sulfate. In vivo stimulation of ATPase activity was observed by the addition of NaCl into the culture medium, as observed in Z. rouxii. No in vivo activation of H⁺-ATPase by glucose metabolism was observed in C. versatilis cells and the activity was independent of the growth phase, like Z. rouxii and unlike S. cerevisiae cells.     

Automated single nucleotide polymorphism typing using bead array in capillary tube

A low-cost and simple on-site technique for genotyping single nucleotide polymorphisms (SNPs) was developed. The technique is based on allele-specific primer PCR and the recently developed bead arrays in a single tip technique. The performance of the method was verified by genotyping four SNPs that correlate with cardiovascular diseases.     

Estimation of regional stress by FEM for a heterogeneous rock mass with a large fault

Defining regional stress for a heterogeneous rock mass composed of different rock bodies and a large fault as a displacement boundary condition that is consistent with the mean trend of the in situ stress, we propose a method for determining regional stress from limited stress data by using a 3D finite element method (FEM). First, this method was applied to a small-scale heterogeneous model with a large planar fault that penetrates the region, to clarify the estimation accuracy and the effects of poor modeling and incomplete stress data. The results showed that (1) the method proposed in this study can accurately estimate the stress distribution in the region under consideration except at the bottom when the sliding area of the fault is small, (2) the reproducibility of the given stress can be used to estimate appropriate values of the normal and shear stiffnesses of the fault when the fault is homogeneous, and (3) both incomplete stress data and the assumption that the fault does not slide decrease the accuracy of stress estimation while the given stresses are approximately reproduced. Next, the method was applied to the Tono area, Japan, where a large fault with a complex geometry, called the Tsukiyoshi fault, exists. The results obtained under the assumption that the Tsukiyoshi fault does not slide showed that (1) the stress distribution was estimated reasonably well only for a narrow region that contained the boreholes at which the stress used in the inverse analysis was measured, (2) the stress in the area shows a large scatter and a non-linear trend with depth, which is mainly caused by the Tsukiyoshi fault, and (3) when a fault is heterogeneous, comprehensive examination for the states of the stress and displacements on the fault is needed to obtain a reasonable estimation for the regional stress.     

Slug to annular flow transition during boiloff in a rod bundle under high-pressure conditions

High-pressure boiloff experiments in a wide range of bundle powers by using the Two-Phase Flow Test Facility (TPTF) were conducted. Two kinds of boiloff patterns were observed in these experiments. One is the boiloff pattern in a low bundle power, in which the dryout points of rods locate at a certain elevation in the bundle because the mixture level controls the dryout points. The other is the boiloff pattern in a high bundle power, in which the clear mixture level can not be observed and the dryout points of rods locate in a wide range of vertical directions. The vertical scatter of the dryout points is considered to be due to the break of the thin water film on the heater rods under the annular flow pattern.A simple model to predict the slug to annular flow transition in the rod bundle is proposed. In the model, the slug to annular flow transition takes place when the interferences of the water films on the neighboring rods cease. The model appeares to give good predictions of the previous flow transition experiment conducted in a rod bundle. The slug-annular transition below the dryout points was predicted with the present model in the high power boiloff experiments of TPTF. No slug-annular transition below the dryout points is predicted with the present model in the low power boiloff experiments.     

Identification and field evaluation ofAnomala octiescostata (Coleoptera: Scarabaeidae) sex pheromone

Using GC-EAD, the sex pheromone of the scarab beetleAnomala octiescostata was identified to be a 8:2 binary mixture of (R,Z)-5-(–)-(oct-1-enyl)oxacyclopentan-2-one and (R,Z)-5-(–)-(dec-1-enyl)oxacyclopentan-2-one. These semiochemicals have been also reported as sex pheromone constituents of otherAnomala species, either geographically or seasonally isolated fromA. octiescostata. Synthetic sex pheromone was highly attractive in the field; 0.1 mg captured significantly more males than two virgin females. Buried traps were significantly more attractive than those positioned at 30, 90, and 150 cm above the ground. In a dose-response test (0.1–100 mg), no saturation due to overdose of pheromone was observed, but in most cases, two dosages differing by 10-fold were not significantly different. Response of males to traps baited with different ratios of the two components was tested in two experiments with randomized blocks and Latin-square designs. Deviation from the natural ratio (8:2) of sex pheromone did not significantly diminish the response of males. Peak flight activity of beetle was recorded at 9:00–10:00 AM JST on sunny days in the end of April 1993.Presented in part at the 10th Annual ISCE Meeting, July 31–August 4, 1993, Clearwater Beach, Florida.     

Segregation Effects at Grain Boundaries in Fluorite-Structured Ceramics

The atomic-scale structure, composition, and chemistry of grain boundaries in two fluorite-structured ceramic materials were characterized by a combination of Z -contrast imaging and electron energy-loss spectroscopy (EELS). In the case of a symmetric 24° [001] tilt bicrystal of yttria-stabilized-zirconia (YSZ), a shift in the zirconium M -edge onset and a change in the yttrium and zirconium M -edge ratios at the boundary indicate an increase in the number of electrons in the boundary plane. A detailed study of the structure and composition indicates that this is caused by an increase in the number of oxygen vacancies in the grain boundary core that is partially compensated by yttrium segregation. Studies of grain boundaries in an industrial Gd-doped ceria ceramic reveals similar changes in vacancy/dopant profiles indicating that these effects may be generic to grain boundaries in fluorite-structured materials.