Catalytic decomposition of biomass tars with iron oxide catalysts

Catalytic gasification of wood (Cedar) biomass was carried out using a specially designed flow-type double beds micro reactor in a two step process: temperature programmed non-catalytic steam gasification of biomass was performed in the first (top) bed at 200–850 °C followed by catalytic decomposition gasification of volatile matters (including tars) in the second (bottom) bed at a constant temperature, mainly 600 °C. Iron oxide catalysts, which transformed to Fe₃O₄ after use possessed catalytic activity in biomass tar decomposition. Above 90% of the volatile matters was gasified by the use of iron oxide catalyst (prepared from FeCl₃ and NH_3aq) at SV of 4.5 × 10³ h^?1. Tar was decomposed over the iron oxide catalysts followed by water gas shift reaction. Surface area of the iron oxide seemed to be an important factor for the catalytic tar decomposition. The activity of the iron oxide catalysts for tar decomposition seemed stable with cyclic use but the activity of the catalysts for the water gas shift reaction decreased with repeated use.     

High-Temperature Active Oxidation of Chemically Vapor-Deposited Silicon Carbide in CO─CO2 Atmosphere

Active oxidation behavior of CVD-SiC in CO─CO₂ atmospheres was investigated using a thermogravimetric technique in the temperature range between 1823 and 1923 K. The gas pressure ratio, P _CO2/ P _CO, was controlled between 10⁻⁴ and 10⁻¹ at 0.1 MPa. Active oxidation rates (mass loss rates) showed maxima at a certain value of P _CO2/ P _CO, ( P _CO2/ P _CO )^*, In a P _CO2/ P _CO region lower than the ( P _CO2/ P _CO)^* a carbon layer was formed on the SiC surface. In a P _CO2/ P _CO region higher than the ( P _CO2/ P _CO)^*, silica particles or a porous silica layer was observed on the SiC surface.     

Preparation of Cu(In,Ga)(S,Se)2 thin films by sequential evaporation and annealing in sulfur atmosphere

Cu(In,Ga)(S,Se)₂ thin films with high Ga/III ratio (around 0.8) were prepared by sequential evaporation from CuGaSe₂, CuInSe₂, In₂Se₃ and Ga₂Se₃ compounds and then annealing in H₂S gas atmosphere. The annealing temperature was varied from 400 to 500 °C. These samples were characterized by means of XRF, EPMA, XRD and SEM. The S/(S+Se) mole ratio in the thin films increased with increase in the annealing temperature, keeping the Cu, In and Ga contents nearly constant. The open circuit voltage increased and the short circuit current density decreased with increase in the annealing temperature. The best solar cell using Cu(In,Ga)(S,Se)₂ thin film with Ga/(In+Ga)=0.79 and S/(S+Se)=0.11 annealed at 400 °C demonstrated V_oc=535 mV, I_sc=13.3 mA/cm², FF=0.61 and efficiency=4.34% without AR-coating.     

HNF1A Mutations and Beta Cell Dysfunction in Diabetes

Understanding the genetic factors of diabetes is essential for addressing the global increase in type 2 diabetes. HNF1A mutations cause a monogenic form of diabetes called maturity-onset diabetes of the young (MODY), and HNF1A single-nucleotide polymorphisms are associated with the development of type 2 diabetes. Numerous studies have been conducted, mainly using genetically modified mice, to explore the molecular basis for the development of diabetes caused by HNF1A mutations, and to reveal the roles of HNF1A in multiple organs, including insulin secretion from pancreatic beta cells, lipid metabolism and protein synthesis in the liver, and urinary glucose reabsorption in the kidneys. Recent studies using human stem cells that mimic MODY have provided new insights into beta cell dysfunction. In this article, we discuss the involvement of HNF1A in beta cell dysfunction by reviewing previous studies using genetically modified mice and recent findings in human stem cell-derived beta cells.     

Experimental study on latent heat storage characteristics of W/O emulsion -Supercooling rate of dispersed water drops by direct contact heat exchange-

Recently, much attention has been paid to investigate the latent heat storage system. Using of ice heat storage system brings an equalization of electric power demand, because it will solved the electric -power-demand-concentration on day-time of summer by the air conditioning. The flowable latent heat storage material, Oil/Water type emulsion, microencapsulated latent heat material-water mixture or ice slurry, etc., is enable to transport the latent heat in a pipe. The flowable latent heat storage material can realize the pipe size reduction and system efficiency improvement. Supercooling phenomenon of the dispersed latent heat storage material in continuous phase brings the obstruction of latent heat storage. The latent heat storage rates of dispersed water drops in W/O (Water/Oil) emulsion are investigated experimentally in this study. The water drops in emulsion has the diameter within 3 ～ 25μm, the averaged water drop diameter is 7.3μm and the standard deviation is 2.9μm. The direct contact heat exchange method is chosen as the phase change rate evaluation of water drops in W/O emulsion. The supercooled temperature and the cooling rate are set as parameters of this study. The evaluation is performed by comparison between the results of this study and the past research. The obtained experimental result is shown that the 35K or more degree from melting point brings 100% latent heat storage rate of W/O emulsion. It was clarified that the supercooling rate of dispersed water particles in emulsion shows the larger value than that of the bulk water.     

Mobile catabolic genes in bacteria

The recent findings of various mobile catabolic genes have provided some insight into the evolution of microbial degradation systems for xenobiotic compounds. The catabolic genes undergo marked genetic rearrangements due to their presence on transposons or association with mobile genetic elements. Bacterial catabolic transposons fall into three defined structural classes. Class I elements include catabolic genes flanked by two copies of insertion sequences. Class II elements carry short terminal inverted repeats and transpose by the replicative mode in which transposase and resolvase are involved. Conjugative catabolic transposons represent the third class of mobile genetic elements. They carry all the genes required for excision, conjugal transfer to a new host, and integration. This review focuses on the structures, functions and roles of the recently characterized catabolic transposons in bacteria. Also described are the mobile catabolic elements that share structural similarity with the pathogenicity and symbiosis islands.     

Nowhere-differentiable attractors

The notion of nowhere-differentiable attractors is illustrated with four prototype equations, that is, maps of invertible type. Four classes of nowhere-differentiable attractors can be distinguished so far: the (nongeneric) continuous-nonchaotic-nonfractal type; the (nongeneric) continuous-fractal type; the (generic) singular-continuous-fractal type; and the (generic) continuous-fractal-in-a-projection type. the history of all four classes is linked with the name of J. A. Yorke in different ways. Even though continuous fractal nowhere-differentiable attractors do not exist genetically, the hypothesis that the fractal geometry of nature may be a consequence of the fact that nature is a differentiable dynamical system is strengthened. Attractors with nowhere-differentiable generic projections can mimic the whole richness of fractal pictures. © 1995 John Wiley & Sons, Inc.     

Reference values for bisphosphoglycerate mutase protein content and specific activity in human erythrocytes

Cytomegalovirus (CMV) gastritis has been reported in transplant patients. Symptoms are considered nonspecific, and gastroscopy with biopsy is usually performed to establish the diagnosis. Three patients are described here 1 to 3 months after solid organ transplantation, with primary CMV gastritis, confirmed by gastroscopy, histopathologic examination and cultures. The clinical presentation in all three cases was sharp epigastric pain that decreased in a supine position, increased while sitting and further increased when standing or walking. The epigastric pain completely resolved after treatment with ganciclovir. To the best of our knowledge, such postural epigastric pain has not been described as a specific symptom in any other clinical entity and may be a unique sign of primary CMV gastritis.     

Osteoclastogenesis inhibitory factor exhibits hypocalcemic effects in normal mice and in hypercalcemic nude mice carrying tumors associated with humoral hypercalcemia of malignancy

In the present study, we attempted to determine the extent to which an anterior capsulorrhexis carried out during cataract surgery contracts postoperatively. The size of the continuous curvilinear capsulorrhexis (CCC) was measured at the end of surgery and at the final follow-up examination in 52 eyes of 40 patients who underwent phacoemulsification/aspiration and implantation of an intraocular lens (IOL) with 6-mm optics. Images obtained by video during surgery and by slit-lamp microscopy were used to determine the CCC size with reference to the optics of the IOL. The average CCC size was 5.0 mm at the end of surgery; it contracted to 4.4 mm by the final postoperative examination. The contraction of the anterior capsule progressed rapidly in the first 50 days following surgery and then gradually thereafter. The extent of contraction was greater in older patients. The smaller the CCC size immediately after surgery, the more rapidly it contracted. The size of the capsulorrhexis contracted an average of 22% following cataract surgery. The contraction rate tended to be higher in older patients. The results suggest that the capsulorrhexis carried out in cataract surgery for elderly patients should be sufficiently large, but not larger than the optics size of the IOL.