BaFe12O19/SiO2-B2O3微晶玻璃陶瓷的制备和微波性能

采用柠檬酸sol-gel工艺合成了BaFe12O19/SiO2-B2O3微晶玻璃陶瓷，研究了SiO2-B2O3玻璃的含量，Ba/Fe原子比和热处理温度对体系析出晶相的影响，以及介电常数和磁异率在1MHz-6GHz频率范围的变化规律，结果表明，休系中SiO2-B2O3玻璃的含量和Ba/Fe比越高，BaF312O19相的析出越困难，前驱体合适的热处理温度为1000℃，介电常数和磁导率基本上随测试频率的增而加下降；介电损耗的最大值为0．43，磁损耗较小。     

全IP移动通信网网络层移动性管理

首先介绍了全IP移动通信网网络层移动性管理的概念、框架和最经典的移动IP（Mobile IP）协议，然后讨论了基于Mobile IP的四种主要扩展方案：蜂窝IP、切换敏感无线接入Internet结构（HAWAII)、电信增强移动IP（TeleMIP）和边缘移动性体系结构（EMA）方案，最后结合第三代移动通信发展的状况得出了一些结论。     

准噶尔盆地侏罗系储集层的基本特征及其主控因素分析

从描述储集层基本特征、分析储集层性质的主控因素、建立储集层成因模式和评价、预测储集层性质这 4个层次 ,研究准噶尔盆地重点勘探目标区的侏罗系储集层。系统总结侏罗系储集层岩石学特征 ,认为成岩压实作用强弱是控制储集层性质的关键因素 ;指出相对优质储集层均为剩余原生粒间孔隙型储集层 ,溶蚀作用对渗透率贡献小 ;非煤系储集层的孔隙保存条件明显比煤系储集层好 ,这是三工河组、头屯河组和吐谷鲁群的物性普遍优于八道湾组和西山窑组的原因。在确定储集层性质的控制因素和控制机理基础上 ,建立了煤系和非煤系两大类储集层的成因 演化模型。在上述研究的基础上 ,分地区、分层位评价了储集层 ,并预测了不同渗透率储集层的深度界线及相对优质储集层的平面分布。图 6参 10     

以入世为契机,进一步推进电力科研院所企业化转制

我国入世和融入经济全球化，将给中国经济运行的大环境带来深刻变化，科技事业也面临着全新挑战。电力科研所实行企业化转制，与国际接轨，按照国际规则办事势在必行。作者作为电力科研单位的一把手就电力科研院所的企业化转制阐述了个人的观点。转制必须有利于回忆科技创新和高新技术产品的开发；必须有利于抓紧培养和造就复合型人才队伍；必须有利于更好地为电网、为发供电企业提供规范化、制度化、长期化和现代化的全方位服务。     

沸石加氢处理催化剂的制备方法

考察了渣油加氢处理催化剂制备过程中引入一种低硅铝比沸石的情况，它不仅提高催化剂的酸性，而且由于引入的分子筛孔径集中，最终使催化剂具有集中的孔分布，弥补了制备高活性催化剂采用混捏法的不足，制备出来的催化剂性能更优异。     

济钢转炉煤气储存加压系统存在缺陷及处理措施

济钢燃气厂针对济钢转炉煤气储存加压系统的设备现状，组织了一次设备大修，大修后煤气柜升降速度提高到了1．0m/min，并解决了加压机前负压等问题。     

A novel cyclic process using CaSO4/CaS pellets for converting sulfur dioxide to elemental sulfur without generating secondary pollutants: Part II. Hydrogen reduction of calcium-sulfate pellets to calcium sulfide

The reduction of calcium sulfate to produce calcium sulfide is a part of the cyclic process for converting sulfur dioxide to elemental sulfur that is described in Part I. The kinetics of the hydrogen reduction of nickel-catalyzed calcium-sulfate pellets were investigated using a thermogravimetric analysis (TGA) technique at reaction temperatures between 1023 and 1088 K and hydrogen partial pressures between 12.9 and 86.1 kPa. The reactivity of nickel-catalyzed calcium-sulfate pellets was demonstrated by the conversion of 70 pct fresh nickel-catalyzed calcium sulfate to calcium sulfide in 20 minutes at 1073 K under a hydrogen partial pressure of 86.1 kPa. Furthermore, the reactivity remained relatively intact after ten cycles of reactions and regenerations. This observed characteristic of the pellets is important because the solids must be reusable for repeated cycles to avoid generating secondary pollutants. The nucleation and growth rate expression was found to be useful in describing the kinetics of the reaction, which had an activation energy of about 167 kJ/mol (∼40 kcal/mol) in all reaction cycles except for the first regenerated samples that were lower at 146 kJ/mol (35 kcal/mol). The reaction order with respect to hydrogen partial pressure was 0.22 in all cycles with the exception of the first regenerated sample for which it was 0.37.     

Effects of extended dislocations on charge distribution in GaN epilayer

We have investigated the effect of extended dislocations (0.5-3 μm) on charge distribution in GaN epilayer grown by metalorganic chemical vapor deposition on (0001) sapphire using atomic force microscopy (AFM) and scanning surface potential microscopy (SSPM). It has been observed for the surface at the extended dislocations present in undoped GaN film to be negatively charged showing 0.04-0.2 V higher potential relative to regions that contain no dislocations. In addition to the higher potential at the dislocation core, the surrounding surfaces, including the edge of the dislocations, are also negatively charged in a symmetric way around the dislocations revealing crater-shaped higher potential regions (∼0.04 V) relative to surrounding dislocation-free area. The experimental results show that the protrusion-type of dislocation is also negatively charged and its potential is dependent on the size of dislocation.     

基于公钥加密算法和PPCT动态图编码的软件指纹方案

提出了一种综合PPCT动态图编码方法和椭圆曲线加密算法的软件指纹方案,该方案将公钥加密技术和软件水印技术综合应用于软件版权的保护和验证过程中,充分利用两者的优势,具有安全性高和抗恶意篡改能力强的特点.     

首钢烧结配加扬地粉试验研究

介绍了首钢原料条件下配加扬地粉对烧结生产影响的实验室研究.随着扬地粉配入量的增加,烧结矿转鼓强度、成品率改善,燃耗有少量上升,利用系数增加,低温还原粉化指数变差.研究结果表明:在首钢目前条件下,配入10%～20%的扬地粉是可行的.二烧车间进行了扬地粉工业试验,其最高配比达到30%,工业试验时烧结各项指标变化与实验室试验结果基本一致.